9
FieldShield Assist Module
__________________________________________________________ Installation Manual
Direct: 763.476.6866 • National: 800.422.2537 • www
.SeeCleareld.com •
[email protected] Manual 017252 Rev A - May 2017
Step 5: Close the Assist Module
Close the case and clamp the clam shell lock
closed on the front of the assist module, mak-
ing sure that the ber stay in the ber guide
grooves(Figure 5).
Figure 5
Step 7:Feed Fiber into Microduct
Use a ¼” drive socket to power the assist module
and feed the ber into the microduct (Figure 7).
Make sure to maintain a consistent speed when
powering the cordless drill.
Figure 6
Figure 7
Step 6: Enable Distance Counter
Open the glare resistant display cover and press
the power button on the right to enable the instal-
lation distance counter (Figure 6).
NOTE: The default unit of measurement for the assist
module distance counter is standard (feet), but can be
switched between standard and metric units.
Step 8: Reset Distance Counter
Once the ber has been installed, reset the
counter switch on the FieldShield Assist Module
by turning the power button off, then powering
back on to continue with the next cable install.
NOTE: To maximize installation distances, feed the ber
off the spool at the same rate as the ber being installed
through the FieldShield Assist Module. Failure to keep ber
installation rates consistent and constant may increase the
amount of friction on the ber during installation.
When using the Assist Module, pay
close attention to the clutch. If the
clutch begins to slip, reduce drill
speed to minimize heat build up.
Failure to reduce drill speed may
cause the Assist Module to fail.
IMPORTANT
