cliMATE CLI-AP30 Handbuch
CLI-AP30 | Installation & Operating Instructions
Air
Purification
System
Congratulations on your purchase of a
Cli~Mate Air Purification System
This Air Purifier improves the quality of the air in your home by helping to eliminate airborne matter such as allergens,
microbes and unpleasant odours.
Note: Please read through the instructions carefully before using or installing the product and ensure that the
manual is kept in a safe place for future reference.
The system must be properly installed and located in accordance with the installation instructions before it is used.
During the set up of this product if you have any questions / comments / issues DO NOT RETURN TO STORE.
FOR SERVICE AND TECHNICAL ADVICE ON THIS PRODUCT, FREE CALL 1300 764 325.
Electrical Requirements:
Australia / New Zealand 240V / 230V 50Hz
Due to manufacturing alterations product may
vary slightly from the pictured.
CUSTOMER HOTLINE: 1300 764 325
Register your warranty online at
www.cli-mate.com.au/warranty-and-registration
Aquaport Corporation Pty Ltd
PO Box 81 Findon SA 5023 Australia
Telephone: 08 8354 0711
Facsimile: 08 8354 0722
Email: aquaport@aquaport.com.au
Web: www.cli-mate.com.au
Social: /climatebrand @climatebrand
INSTALLATION AND OPERATING INSTRUCTIONS 1
SAFETY PRECAUTIONS
Read all instructions carefully.
• All components need to be installed in accordance with the user
manual instructions for correct performance of unit.
• This appliance should be used in conjunction with a safety switch.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Do not operate any appliance with a damaged cord or plug or after
the appliance malfunctions, or has been damaged in any manner.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
• Children should be supervised to ensure that they do not play with
the appliance.
• Do not use appliance for other than intended use.
• Do not disassemble, repair or re-form the unit, it may cause injur y,
fire or other malfunctions. A qualified service agent must make all
service adjustments. Removing any part or attempting to service
the dryer will void the warranty.
• Unplug from outlet when not in use and before cleaning. Never
plug in or unplug unit with wet hands.
• Do not use unit outdoors or expose to greasy or damp
environments.
• Keep the rear air inlet and outlet is free from air blocking
materials such as clothing, plastic bags or papers. Air flow is
required for the unit to operate effectively.
• Place unit on a flat location at least 30cm from wall or other
appliances.
• When the unit is in operation, keep all body parts, jewellery, hair
and loose clothing away from the openings
• Unit must be placed on a stable flat sur face to reduce possible
excessive vibration and noise.
• Keep the dr yer away from fire, flammable gas, combustible
products or vapours, and corrosive substances.
• Do not operate the unit without filters
• When transporting the air purifier, always hold the handles on the
side of the unit
• Do not remove the lid of the unit when it is in operation.
• To protect against fire, electric shock and personal injury, do not
immerse cord, plugs, or appliance in water or other liquid.
• Do not place on or near a hot gas, electric burner or heating
appliance.
• Check voltage to be sure that the voltage indicated on the
nameplate agrees with your voltage.
2INSTALLATION AND OPERATING INSTRUCTIONS
PRODUCT FEATURES
Filters
The 3 layer filter contains a pre-filter, a HEPA filter and an activated
carbon filter.
• The pre-filter traps larger particles such as dust, pet hair and
large-sized allergens.
• The HEPA filter (Grade H12) removes 99.5% of particles as
small as 0.3 microns and greater from the air. It is capable of
removing smoke, dust, pollen, pet dander, mold spores, bacteria
and allergens in the air.
• The Activated carbon filter absorbs common household odours,
VOCs, cigarette odours, chemical fumes and smoke.
Ionizer
In addition to the filters, this air purifier generates negatively
charged oxygen molecules (different than ozone) which attach to
particles in the air which makes it easier for the air purifier to trap.
Airborne par ticles are attracted to the negative ions in an effect
similar to static electricity.
UV TiO2 Photocatalyst
This air purifier also utilises safe and advanced UV TiO2
Photocatalyst technology as a way of sterilising the air.
This air purification method involves a broad-spectrum UV-C light
reacting with a thin film of Titanium Dioxide which produces highly
reactive electrons. These combine with airborne microbes.
Once combined, a chemical reaction takes place between the
super-charged ion and the pollutant which effectively breaks
down the microbes.
INSTALLATION AND OPERATING INSTRUCTIONS 3
COMPONENT IDENTIFICATION
1. Display panel
2. Control buttons
3. Air outlet cover
4. Hidden handles
5. Remote control
6. Air inlet
7. Ionizer
8. Pre-filter, HEPA and active carbon filter
9. UV TiO2 photocatalyst filter
10. Back cover
4INSTALLATION AND OPERATING INSTRUCTIONS
CONTROL PANEL/BUTTONS
1. Speed options
Allows selection for desired speed setting- turbo, high, low and
sleep. Default setting at low speed
Filter timer reset button
Press and hold for 3 seconds to reset filter timer
2. Power button
Turns unit on/off
3. Timer options
To set automatic off timer at 1, 4 or 8 hour settings
REMOTE CONTROL
I. On/off
II. Child-safety lock
III. Auto-mode
IV. Speed options
V. Sleep mode
VI. Off timer options
Note:
• Avoid storing the remote control in
direct sunlight
• The battery for this remote control is
for initial use only and will need to be
changed
• When replacing batter y, always use a
3V lithium coin battery
• When the unit will not be used for an
extended period, remove the battery
from the remote to prevent battery
fluid leakage
1. 2. 3.
INSTALLATION AND OPERATING INSTRUCTIONS 5
DISPLAY PANEL
1. Power Indicator Illuminates blue when power is ON
Filter Change Indicator Light will flash blue when filter
needs to be changed
Child-Lock Function Indicator Illuminates Green when
Child Safety Lock is ON
2. Fan Speed
Indicator a. Turbo speed
b. High speed
c. Low speed
d. Sleep (Ultra-quiet mode)
3. Timer Indicator
e. 1 hour
f. 4 hours
g. 8 hours
4. Automatic
Mode Indicator Red - Poor air quality
Purple - Moderate air quality
Blue - Good air quality
5. Remote Control Signal Receiver
1.
5.
4.
2. 3.
a. d.b. e.c. f. g.
6INSTALLATION AND OPERATING INSTRUCTIONS
OPERATION INSTRUCTIONS
1. Plug unit into power socket, unit will beep and control panel
lights will illuminate blue before extinguishing. POWER light
will be lit green. Unit is now in standby mode.
2. Press POWER button to turn unit on. The unit will beep and
the fan will start running. The air outlet cover will automatically
open and display panel lights will illuminate indicating current
settings.
Note: The purification default setting is at LOW speed mode.
3. To select speed, press until LED Light is on desired speed-
LOW, HIGH, TURBO, SLEEP.
Note: To select SLEEP mode on the remote control, press
button.
4. To set automatic off timer, press until LED light is on
desired time 1/4/8 hours. Unit will automatically switch off
once selected time duration has lapsed.
5. To select AUTO-MODE, press on the remote control. The
auto-mode icon on the display panel will light up. The icon
colour will change indicating the current air quality. The fan
speed of the unit will change automatically depending on the
air quality as detected by the dust and odour sensors.
PRODUCT SPECIFICATIONS Air Purifier
Model Code CLI-AP30
Dimensions (mm) H679 x W394 x D153
Coverage area Up to 25m
2
Power consumption 55 watts
Net weight 7.2 kg
Gross weight 8.4 kg
Germicidal UV-C light 8W/253.7nm
Air flow 176m
3
/h
Air change per hour 30m
3
x 6
Clean air delivery rate 105cfm (smoke)
Ozone release rate Less than 0.05PPM
Noise level in Turbo Mode <58dB
Noise level in Sleep Mode <28dB
Replacement filter CLI-RF-AP30
INSTALLATION AND OPERATING INSTRUCTIONS 7
6. To activate CHILD-LOCK function, press on the remote
control. ‘CHILD LOCK’ light on the unit will be lit when this
feature is activated. This function will lock the control buttons
on the unit and remote control
Note: To deactivate the CHILD LOCK function, hold the
button on the remote control for 3 seconds until the CHILD LOCK
LED light on the unit extinguishes.
During the set up of this product if you have any questions /
comments / issues DO NOT RETURN TO STORE FOR SERVICE
AND TECHNICAL ADVICE ON THIS PRODUCT FREE CALL
1300 764 325
Good air quality
Moderate air quality
Poor air quality
Indicator
light Blue Purple Red
Operating
speed Sleep Low High
8INSTALLATION AND OPERATING INSTRUCTIONS
CLEANING AND MAINTENANCE
Before carrying out any maintenance or cleaning of the unit, make
sure that the power to the unit is turned off and power cord is
unplugged from the power socket.
External cleaning of unit:
• Do not clean unit with any abrasive cleaning agents or solvents
• Do not apply any water directly to the unit of cleaning
• Only use a soft clean cloth for all cleaning purposes
• Clean the air inlet and outlet with a dry cloth, soft brush or
vacuum cleaner
CLEANING THE PRE-FILTER
It is recommended that the Pre-filters (the removable white layer)
are cleaned every 1-2 weeks of unit operation, depending on the
air quality of the room
To clean the Pre-filter:
1. The removable Pre-filter is attached by Velcro. Gently peel away
the Pre-filter.
2. Fill the sink with lukewarm water and gently hand wash the
Pre-filter under the water for 2-3 minutes or until it is
completely clean.
3. Rinse the Pre-Filter with clean tap water.
4. Use a towel to remove any excess water from the Pre-Filter
5. Allow the Pre-filter to dry for 12-24 hours
6. When the Pre-filter is completely dry, re-attach and place back
into the air purifier. Note: When placing the filters back into the
air purifier, ensure that the white belts are facing outwards and
that the Pre-filters are facing towards the air inlet
Inhaltsverzeichnis
Andere cliMATE Luftreiniger Handbücher
