clivus multrum CM8 Bedienungsanleitung
CM8
INSTALLATION
MANUAL
AUS|NZ
2
1x
1x TOILET CHUTE COLLAR
CM8 TANK
CM8 TANK
1x TOILET CHUTE
1x SILICONE
SEALANT
1x MAINTENANCE RAKE
SEALANT
PEDESTAL
15x ROOFING SCREWS
1x PEDESTAL AND
TOILET SEAT
1x ‘HOW TO USE’ SIGN
1x 125mL ENZYME
BULKING
MATERIAL
3x STARTER
BULKING
MATERIAL
How to use:
3
1x VENT COWL
15x ROOFING SCREWS
1x FAN IN HOUSING
1x TRANSFORMER
1x LIQUID DRAIN PIPE
CONNECTOR
VENT
DRAIN
1x ROOF FLASHING COLLAR
1x PVC DRAIN PIPE
2x 45° BEND
3x VENT PIPE SECTIONS
1x 90° BEND
1x VENT SUPPORT
BRACKETS
1x TRENCH ARCH
DRAIN
4
MATERIALS REQUIRED
• Bedding for CM8 tank.
• Starter bulking material.
• Water for wetting starter material.
• Additional 50mm PVC pipe (coupling and bends if absorption trench is to be located some
distance away from tank). Pipe bends if needed for vent pipe.
• In poor soil conditions, extra length of trenching arch or agi drain may be required.
• Drainage gravel for excess uids drain.
Screwdriver
(Philips/plain)
Jigsaw Tape Measure
Caulking gun
Marker
Spade
Ladder
Spirit Level
TOOLS REQUIRED
INSTALLATION SUMMARY
1. Ensure the tank is in a position so that the toilet chute will be perfectly straight over the
tank below.
2. Ensure the tank foundation is solid with a sand or crusher dust bed and has a slight slope
(3%) towards the front hatch.
3. Mark and cut holes in the oor for the toilet chute.
4. Mark and cut holes in the tank top.
5. Insert toilet chute and pedestal.
6. Install the vent system.
7. Install the liquid end-product drain pipe and absorption/transpiration trench.
8. Connect fan to power source.
9. Check everything is sealed.
10. Place a starter-bed of suitable bulking agent (e.g. wood shavings) in the unit.
11. Wet bulking agent before use of toilet.
12. Add starter bacteria after 10 days of use.
Scissors/Knife Drill PPE
5
CONDITIONS
Any decomposition process works better where temperatures are warmer. Over
the winter months the composting process slows or can even temporarily stop where
temperatures in the pile drop below 4°C.
>13°C
Ideal temperature for composting
<13°C
Composting process slows
As the composting tank is black, it will absorb heat from the sun. Simply by installing the
compost bin on the north side of the house will make a dramatic dierence to the
composting process. In addition, a translucent hatch and enclosure can be installed around
the compost bin. In extreme alpine conditions it may be necessary to insulate the tank itself
in addition to the above.
N
Ideal chute/pedestal
location on tank.
Hatch
PLAN VIEW
6
POSITIONING THE TANK
If there is very little room between the top of the tank and the oor of the building, the order
of the installation can be changed as follows: Firstly, cut the pedestal hole in the oor of the
building (refer Section 9) and then mark the hole position on the tank when the tank is in
position, but before the tank is secured into the ground. After the tank has been marked, it
can be removed from under the building and then cut the hole in the tank and t the chute
collar before replacing the tank.
Check the position planned for the toilet chute. The toilet chute must be positioned
over the top of the compost tank. For less maintenance of the compost pile, the
optimum location for the chute/s to enter the tank is mid-width, in the rear half of
the tank. A clearance of at least 150mm from edge of chute to edge of tank-top is
desirable to avoid rapid build up of the pile against the sides.
Check there are no major support beams, pipes or electrical wire that are in the way of
the toilet chute.
Where mains power is to be used, check that a power point has been installed near the
location for the ventilation fan.
Locate where the excess liquid drainpipe and tench is to go and take this into account
when positioning the tank.
TANK SUPPORT
The composting tank must be supported by either packed earth with the tank placed on a
base of sand, or a wooden frame on a solid base; e.g. a concrete slab. Insulation between the
tank and the concrete slab will reduce heat loss and aid the composting process.
NOTE: The tank and enclosure should be protected from surface and oodwater.
Smooth Ground Uneven Ground
50-75mm bed of
sand, ne dust or
similar solid sub-soil
7
EXCESS LIQUID DRAIN INSTALLATION
CM8 and CM10 tank join line
Max. Fill Line
Sand Layer
Tank Drain
Position tank on a slope with
up to 50mm fall (4%)
Soil to be retained
Straight Pipe
Trench Arch
45° Bend
45° Bend
500 min
230 min
SECTION VIEW
Underground Trench
Arch Drain
Trench Arch
Drain
Gravel
150 min
8
TOILET CHUTE & PEDESTAL
Please refer to the Pedestal
installation manual for
instructions on how to locate the
pedestal in your bathroom.
1FRONT
BACK
A3 Template to cut chute
hole at the correct size
BACK WALL
2
<5mm of sideways play around the
hole.
SIDE WALL
3
Note: If the oor of the building is high above the top
of the tank a chute extension piece/s may be needed.
Extra lengths are available from your supplier. Joints
should be screwed with short self-tapper screws, and
sealed with silicon. If more than 2 chutes are joined
then additional support straps or brackets are needed
to support their weight from the building frame,
instead of hanging only by the top chute.
Using the outside of the
toilet chute as a template,
mark and cut the chute hole
into the top of the tank.
Bathroom oor
9
4Enlarge the hole in the
rubber chute collar so it will
stretch snugly around the
toilet chute without gaps.
5
6
Tank
inspection
door
Drip Edge
Max 100mm
SECTION VIEW
Mark and cut
chute
10
Lift the toilet chute
slightly and put sealant
between the toilet chute
and the oor then press
chute down again to
seat rmly onto the oor.
SEALANT
TOP FLOOR
Bend and move the
metal edging strip of the
chute collar to the tank.
SEALANT
Run a bead of silicon sealant
around the underside edge of
the collar.
Using the 1/2 stainless screw
provided, secured the collar of the
tank top by screwing through the
metal edging strip.
12
3
Collar
lift up push down
7
9
8
Andere Handbücher für CM8
4
Inhaltsverzeichnis
Andere clivus multrum Toilette Handbücher
clivus multrum
clivus multrum CM8 Bedienungsanleitung
clivus multrum
clivus multrum CM20 Bedienungsanleitung
clivus multrum
clivus multrum HIGH PROFILE Bedienungsanleitung
clivus multrum
clivus multrum CM8 Bedienungsanleitung
clivus multrum
clivus multrum M100 Bedienungsanleitung
clivus multrum
clivus multrum CM40 Bedienungsanleitung
clivus multrum
clivus multrum CM2 Bedienungsanleitung
clivus multrum
clivus multrum CM HP Bedienungsanleitung
clivus multrum
clivus multrum NL2 Bedienungsanleitung
clivus multrum
clivus multrum CM14 Bedienungsanleitung
Beliebte Toilette Handbücher anderer Marken
Better Bathrooms
Better Bathrooms BUN/BeBa 27555/78725 Bedienungsanleitung
American Standard
American Standard CONCEPT Cube TF-2704 Bedienungsanleitung
BIOLAN
BIOLAN ECO Stücklistenhandbuch
Thetford
Thetford C260 Series Bedienungsanleitung
KELISS
KELISS T162A Series Bedienungsanleitung
Kohler
Kohler K-22241K Montageanleitung
