ClodPi Labs ATOM Hub Bedienungsanleitung
How to install battery in to ClodPi Labs ATOM Hub for Home Assistant?
ClodPi Labs ATOM Hub for Home Assistant does not come with pre-installed battery. Before you start using the ATOM Hub device, battery
installation has to be done. Below are the suggested steps to install / replace the battery
Pre-Requisite:
1) We need to open up the ATOM Hub enclosure using a screw driver (PH0 / PH1)
2) Buy locally a battery “CR2032”, 3 Volts.
Steps:
1) Take the device, do not connect to power and internet.
1
2) Keep the device upside down
3) Remove the rubber feet.
4) Take a screw driver (PH0 / PH1) and remove all the four screws
5) Cautiously pick the device and keep it in a way with cover is at the top
6) Remove the top cover
7) Observe a battery slot labelled U10 (highlighted in blue –adjacent image)
2
8) Battery placement:
•Remove the battery from the package
•Slide it intothe battery slot as shown inadjacent image with battery slipping
under the two teeth.
3
•Hold the ATOM Hub base board from the left side firmly.
•Push the battery from right side and press.
•The battery should get fixed int o the slot.
9) Place the top cover
10)Keep the device upside down
11)Tighten all the 4 screws
12)Place back all the 4 Rubber Feet
13)Keep the device with cover on the top. Your device is ready to use again.
Andere Handbücher für ATOM Hub
1
Andere ClodPi Labs Schalten Handbücher
