CMi Intoxilyzer S-D2 Bedienungsanleitung

S-D2

OPERATOR’S MANUAL

650132LevA

S-D2

Operator’s

Manual

316 E. 9th St.

Owensboro,KY42303

866-835-0690

Fax:270-685-6268

www.alcoholtest.com

No part of this work covered by the copyrights hereon may

be reproduced or copied in any form or by any means—

graphical,electronic,mechanical,including photocopying, taping

orinformationstorageandretrievalsystems—without

written permission of CMI, Inc.

INTRODUCTION . . . . . . . . . . . . . . . . . . . 1

PRINCIPLES OF OPERATION . . . . . . . . . 2

• Instrument Features . . . . . . . . . . . . . 3

Mouthpiece

Sampling Port

“SET” Button

“READ” Button

Alcohol Level Display

Calibration Control

Breath Sampling Lights

Battery

Leather Case

SUBJECT BREATH TEST . . . . . . . . . . . . 7

• Ambient Temperature . . . . . . . . . . . . 7

• Preliminary . . . . . . . . . . . . . . . . . . . . 8

• Detailed Procedure . . . . . . . . . . . . . . 8

Ready Check

SET

Attach Mouthpiece

Instruct the Subject

Take Sample

Observe Display

Discard Mouthpiece

Reset and Wait

CALIBRATION REQUIREMENTS: USE OF

THE DRY GAS STANDARD . . . . . . . . . . 14

TABLE OF

CONTENTS

INTOXILYZER®S-D2 Operator’s Manual

• The Alcohol Standard . . . . . . . . . . . . 14

• The Gas Standard . . . . . . . . . . . . . . . 15

• Using a Dry Gas Standard

at High Altitude . . . . . . . . . . . . . . . . 15

• Altitude Correction Chart . . . . . . . . . . 16

• Use of a Wet-Bath Simulator . . . . . . . 17

CALIBRATION CHECK PROCEDURE . . . 18

• Detailed Procedure . . . . . . . . . . . . . . 18

Ready Check

SET

Sample the Dry Gas Standard

Read the Display

Reset and Wait

CALIBRATION ADJUSTMENT . . . . . . . . . 21

• The Calibration Control . . . . . . . . . . . 21

• The Dry Gas Calibration Value . . . . . . 21

• Detailed Procedure . . . . . . . . . . . . . . 22

Preliminary

Ready Check

SET

Sample the Dry Gas Standard

Adjust the Display to the Value of the

Dry Gas Standard

Reset and Wait

ROUTINE FIELD SERVICE CHECKS . . . . 27

• Battery Check & Replacement . . . . . . 27

• Sampling System Check . . . . . . . . . 28

• Breath Sampling Light Check . . . . . . . 29

• Test Fuel Cell Switch . . . . . . . . . . . . 31

• Fuel Cell Replacement . . . . . . . . . . . 31

POINTS TO REMEMBER . . . . . . . . . . . . . 32

• Test Procedure . . . . . . . . . . . . . . . . . 32

• Mouthpiece . . . . . . . . . . . . . . . . . . . . 33

• Smoking . . . . . . . . . . . . . . . . . . . . . . 33

• Food and Drink . . . . . . . . . . . . . . . . . 33

• Storage Between Tests . . . . . . . . . . . 33

• Radio Transmitters . . . . . . . . . . . . . . 34

• Physical Shock . . . . . . . . . . . . . . . . 34

INTOXILYZER®S-D2 SPECIFICATIONS . . 35

INTOXILYZER®S-D2 Operator’s Manual

INTRODUCTION

The Intoxilyzer®S-D2

representsa wellestablished

conceptinbreathalcohol

testing analysis. It is used

worldwideinlawenforce-

ment,transportationand

workplace safety applications. The S-D2 is just

oneof the range of instruments manufactured by

CMI, Inc. for these purposes.

TheIntoxilyzer®S-D2isaccurate and reliable,

allowinga complete breath test procedureto be

conducted in about one minute.

Thismanualdescribes the operation,

maintenance,calibrationcheck,and calibration

adjustment of the S-D2. This manual should be

readcompletelyandfullyunderstoodbyeach

operator prior to testing a subject. It is further

recommendedthatoperatorspractice the breath

testing process before giving an actual “in the

field” test.

The information contained in this manual concerning operational

procedures, protocols, accuracy verification schedules and

techniques is presented solely for the purpose of establishing a

general knowledge of the instrument and its operation. CMI

recognizes that many law enforcement customers have

agencies responsible for specifying instrument procedures,

protocols and techniques based upon their individual needs,

current laws and pre-existing administrative rules. Therefore, if

any such procedure, protocol, schedule or technique described

in this manual conflicts with the rules set forth by a recognized

governing agency, CMI defers to those authorized entities.

INTOXILYZER®S-D2 Operator’s Manual

PRINCIPLES OF

OPERATION

TheIntoxilyzer®S-D2

usesan electrochemical

fuel cell, containing two

platinumelectrodes,to

detectandmeasurethe

concentrationof alcohol vapor in expired breath.

When breath is drawn into this fuel cell, by means

of the sampling system, a small voltage is

generatedinproportiontoitsbreath alcohol

concentration. This fuel cell is fed to an electronic

amplifier and displayed on a digital meter (liquid

crystal).

The S-D2 incorporates two breath sampling lights,

controlledbyaninterlinked pressure switch and

timer system. The sampling lights show the

operator if the subject is blowing correctly, and

whenhehasprovided a suitable sample of breath

foranalysis.

The instrument is simple to operate and may be

usedasoftenasrequired,providedthatasuitable

delayis allowed between successive tests. This

time delay allows the fuel cell to clear itself of

alcoholandpreventsthepossibilityofadditive

readings. If no alcohol is present in a test, a

secondtestmay be analyzed immediately, since

the fuel cell voltage is already at zero. Unless the

breath alcohol level of the subject is very high,

INTOXILYZER®S-D2 Operator’s Manual

theinstrument will generally beclear enough toreceive

and analyze the second sample in less than two minutes.

INSTRUMENT FEATURES

1)Mouthpiece

This is attached to the sampling port. For

hygenicreasons, mouthpieces are supplied

separatelypackedandaredisposable. Anew

mouthpiece must be used for each breath test.

Thisminimizeshealth concerns and prevents

cross-samplealcohol contamination.

2) Sampling Port

This forms the entrance to the fuel cell detector.

When inserted into the small hole in the side of

the mouthpiece, it allows a small portion of

breath to be drawn into the instrument for

analysis.

3) ‘SET’ Button

This button forms part of the sampling system.

When fully depressed, the button locks to set

the instrument ready for sampling. When the

‘SET’ button rises, the sample to be analyzed

is drawn directly into the fuel cell detector.

4) ‘READ’ Button

This button has two functions:

1) to release the ‘SET’ button and take

thesample,

2) to switch on the amplifier and display

systems

INTOXILYZER®S-D2 Operator’s Manual

INSTRUMENT

FEATURES

1 Mouthpiece

2Sampling Port

3 ‘SET’ Button

4‘READ’ Button

5 Alcohol Level Display

6 Calibration Control (on side)

7 Breath Sampling Lights

8 Battery (on bottom)

9 Leather Case

The ‘READ’ button is spring loaded.

Momentarydepressionwill take the breath

sample. Constantpressureis required to

switch on the amplifier and display systems.

5)AlcoholLevelDisplay

This three digit, liquid crystal display shows

thebreathalcoholconcentrationof the subject.

The display has built-in illumination and is

activatedbydepressing the ‘READ’ button.

If the figure on the left shows ‘L’ when the

‘READ’ buttonisdepressed,thebatteryneeds

tobereplaced.

6)Calibration Control

This screw control, located on the right side of the

case,isusedforperiodic calibration adjustments

with either a dry gas standard or wet bath

simulator.

7) Breath Sampling Lights

Light ‘A’ illuminates to indicate that the subject

is blowing hard enough to obtain a proper breath

sample. Light ‘B’ illuminates when the subject

has blown long enough and indicates when the

‘READ’ button should be pressed. In other

words, light ‘B’ illuminates when the subject has

providedasuitable sample for breath analysis.

8)Battery

The battery is located directly behind the sliding

base on the bottom of the S-D2. It powers the

amplifier, digital display and sampling lights and

INTOXILYZER®S-D2 Operator’s Manual

should be replaced when the letter ‘L’appears on

the left side of the display.

9)Leather Case

The S-D2 is supplied in a leather protective case.

The unit should be kept inside the case at all

times, except when calibrating, changing the

batteryorduringmaintenance.

Inhaltsverzeichnis

Andere CMi Prüfgeräte Handbücher

CMi

CMi Intoxilyzer 9000 Handbuch

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Fluke

Fluke T5-600 Bedienungs- und Montageanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung

Rohde & Schwarz

Rohde & Schwarz RTA4000 Bedienungsanleitung