Port Type Cable Type Connector
1000BASE-LX 9/125 μm Single-Mode fiber cable
50/125 μm Multi-Mode fiber cable
62.5/125 μm Multi-Mode fiber cable
LCFiber
1000BASE-SX 50/125 μm Multi-Mode fiber cable
62.5/125 μm Multi-Mode fiber cable
LC
100BASE-TX Category 5 TP (Using min. 2 pairs) RJ-45TP
10BASE-T Category 3, 4 or 5 TP RJ-45
2.2.5 Status LEDs
This Switch comes with a complete range of LEDs. The table below lists each LEDs name, color
and a brief description of its function.
Name Color Function
PWR Green Lit: Power "On"
Ports 1~24
LINK/ACT
Yellow(10Mbps)
Green(100Mbps)
Lit: When the port has a valid physical connection with
another device.
Blinks: When the port is sending or receiving data (Activity).
Ports 1~24
FD/COL
Green Lit: When the port is set to Full-Duplex mode.
Blinks: When a collision is detected in Half-Duplex mode.
Port 25,26
Fiber
Green Lit: When the port has a valid physical connection with
another device at 1000Mbps.
Blink: When the port is sending or receiving data (Activity).
Ports 25,26
FD
Green Lit: When the port is set to Full-duplex mode.
2.3 The Rear Panel
Console 50-60Hz
OFF ON
100-240V AC
2.3.1 ON/OFF ("Reset") Switch
The power ON/OFF switch is located to the far right of the rear panel - next to the power
connector.
To reset the Switch, turn the power switch "OFF", then "ON".
Note: The Switch must be reset when the MAC address table needs to be rebuilt.
2.3.2 Power Socket
The Power Socket is designed to be used with the power cord included in the product package.
•Attach the female end of the power cord to the male power connector on the rear panel.
•Attach the male end of the power cord to a grounded power outlet.
6
