Cobra RAD350 Bedienungsanleitung
Printed in the Philippines
Part No. 480-1070-P
Version C
Operating Instructions
RADAR/LASER
PROTECTION
RAD350
RADAR/LASER
Nothing Comes Close to a Cobra®A1
©2016 Cobra Electronics Corporation
6500 West Cortland Street
Chicago, Illinois 60707 USA
www.cobra.com
Important Information
Customer Assistance
Federal Laws Governing the Use of Radar Detectors
It is not against federal law to receive radar transmissions with your Cobra radar/
laser detector. The Communications Act of 1924 guarantees your right to receive
radio transmissions on any frequency. Local laws that contravene this Act, while illegal,
may be enforced by your local law enforcement ofcials until and unless
they are prohibited from doing so by federal court action.
Safe Driving
Motorists, as well as operators of emergency or service vehicles, are expected to
exercise all due caution while using this product, and to obey all applicable trafc
laws. Do not attempt to change settings of the unit while in motion.
Security of Your Vehicle
Before leaving your vehicle, always remember to conceal your radar detector
in order to reduce the possibility of break-in and theft.
Introduction
Important Information and
Customer Assistance
English
A2
Controls Indicators and Connections
Controls, Indicators and Connections •
12V DC
Power Jack
Dim Button
For adjusting the
display brightness.
Mute Button
For manual mute
or auto mute of
audio alerts.
On-Off/Volume Control
Allows you to adjust the
volume of the alerts.
Introduction
LaserEye
For detection of
laser signals.
Speaker
SEN Button
Adjust sensitivity to
City or Highway
modes to reduce
false alerts.
FCC NOTICE This device complies with part 15 of FCC rules: Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received
including interference that may cause undesired operation.
Windshield
Bracket
Mount
AVIS FCC
Cet appareil est conforme à la partie 15 des règles de la FCC: Son
fonctionnement est soumis aux deux conditions suivantes: (1) Ce dispositif ne peut
causer des interférences nuisibles, et (2) Cet appareil doit accepter toute interférence
reçue, y compris les interférences qui peuvent causer un mauvais fonctionnement.
Nothing Comes Close to a Cobra®A3
Display and Product Features
Congratulations! You’ve made a smart choice by purchasing a radar/laser
detector from Cobra. Just look at some of the sophisticated features and
capabilities your new unit includes:
Easy-to-Read Display •
Product Features •
Introduction
Radar
Indicators
VG-2
Indicator
This booklet describes the simple steps for mounting and setting up your detector.
It also provides helpful information about how radar and laser guns are used and
how you can interpret the alerts you receive.
Signal Strength/City/
Highway/Laser Indicator
Radar/Laser Protection
Detects all radar and laser guns.
LaserEye®
Detects laser signals from both front and rear.
Anti-Falsing Circuitry
Automatically reduce false alerts from erroneous
sources including automatic door openers and
xed position trafc ow monitoring systems.
IVT FilterTM
Automatically reduces false alerts from moving
In-Vehicle Technology sources such as collision
avoidance systems and adaptive cruise control.
City & Highway Modes
Selectable modes reduces falsing in densely
populated areas.
Auto Mute
Automatically mutes audio for sustained alerts.
7-Segment Color Display
Bright display with band identication icons
and numeric signal strength meter.
Audible Signal Strength Levels
Unique tones provide signal strength and
band identication.
6’ Power Cord and Mount Included.
Nothing Comes Close to a Cobra®1
Contents
Introduction
Important Information ................................. A1
Controls, Indicators and Connections ..................... A2
Display............................................. A3
Product Features .................................... A3
Your Detector
Installation........................................... 2
Getting Started ....................................... 5
Settings ............................................. 6
Highway/City Mode.................................. 6
Anti-Falsing Circuitry .................................7
Muting an Alert ..................................... 7
Auto Mute Mode .................................... 7
Display Brightness .................................. 8
Tone Setting ....................................... 8
VG-2 Alert Settings .................................. 9
Radar Alert Settings ................................ 10
Detection ........................................... 11
Signals Detected................................... 11
Audio Alerts....................................... 11
Visual Display ..................................... 11
Instant-On Detection................................ 13
Responding to Alerts................................ 14
Understanding Radar and Laser ......................... 15
Understanding LIDAR.................................. 16
Customer Information
Maintenance ........................................ 16
Specications ...................................... 17
Limited 1-Year Warranty ............................... 18
Product Service & Optional Accessories .................. 19
Trademark Acknowledgement............................20
Introduction
English
2
Installation
Your Detector
Windshield Mounting Dashboard Mounting
Installation •
Where to Mount Your Unit
You will get optimum performance from your detector if you Mount it at a point
approximately in the center of the vehicle, as low as possible on the front windshield
without obstructing the unit’s view of the road either to the front or rear. You can
also mount it directly on the dashboard.
The unit’s lens must not be blocked and the LaserEye should have a clear view
out the back window to allow maximum detection.
Radar and laser signals pass through glass but not through other materials and
objects. Objects that can block or weaken incoming signals include:
QWindshield wiper blades
QMirrored sun screens
QDark tinting at the top of the windshield
QHeated windshields currently available on some vehicles
(Instaclear for Ford, Electriclear for GM). Consult your dealer
to see if you have this option.
The LaserEye Should Have a Clear View
Nothing Comes Close to a Cobra®3
Installation
Your Detector
1. Attach the rubber cups
to the bracket.
2. Make sure the rubber cups and your windshield are clean.
3. Push the bracket rmly onto
the windshield.
4. Attach the detector to
the bracket. Check that
the unit is parallel to the
road’s surface.
5. To adjust the angle if neces-
sary, gently push or pull
on the bracket to bend it.
DO NOT use the detector to
bend the bracket.
6. Plug the power cord
into the detector.
7. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s ciga-
rette lighter.
Windshield Mounting
English
4
Installation
Your Detector
1. Place the detector on the dashboard to nd a location
where the unit has a clear, level view of the road and is
parallel to the road’s surface. The angle CANNOT be
adjusted after mounting
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener. You
can remove and
reattach the unit as often
as you like.
5. Plug the power cord into the
detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
Dashboard Mounting
Nothing Comes Close to a Cobra®5
Getting Started
Your Detector
Getting Started •
To Turn On The Unit And Adjust The Audio Volume
Rotate the On-Off/
Volume control
clockwise (away
from you).
Audible Tone Visual Display
Three beeps hor cppears in the display
indicating that the power
is On
NOTE
In some vehicles, power is supplied to the cigarette lighter even while the
ignition is Off. If this is the case with your vehicle, you should turn Off or
unplug your detector when parking for lengthy periods.
Power On
X K Ka V h
English
6
Settings
Your Detector
Settings •
Sens Mode
Setting your detector to City mode sensitivity delays all X band audio alerts at
lower signal strength levels. (A single beep will sound when the signal is rst
detected.) This will reduce false alerts while you are driving in, or near,
urban areas where there are many sources for conicting X band signals
such as microwave towers and automatic door openers.
To change settings, follow the procedure listed below, which indicates what you will
see and hear as you complete each step. The factory setting is Highway mode.
To Change From Highway Mode To City Mode
Press and release
the SEN button.
Audible Tone Visual Display
One beep cappears in the display
SEN Button
Press and
release
City Mode
X K Ka V
c
Highway Mode
X K Ka V h
To Change From City Mode To Highway Mode
Press and release
the SEN button
again.
Audible Tone Visual Display
Two beeps happears in the display
Andere Handbücher für RAD350
1
Inhaltsverzeichnis
Andere Cobra Radarwarngerät Handbücher
Cobra
Cobra XRS 9830 Bedienungsanleitung
Cobra
Cobra 12 BAND XRS 9940 Bedienungsanleitung
Cobra
Cobra XRS 9675 Betriebsanleitung
Cobra
Cobra XRS 9670 Bedienungsanleitung
Cobra
Cobra ESD9200 Betriebsanleitung
Cobra
Cobra SPX 5400 Bedienungsanleitung
Cobra
Cobra XRS 9745 Bedienungsanleitung
Cobra
Cobra ESD6160 Leitfaden
Cobra
Cobra 14 BAND XRS 878 Bedienungsanleitung
Cobra
Cobra iRadar S120R Bedienungsanleitung
Cobra
Cobra XRS 9430 Bedienungsanleitung
Cobra
Cobra XRS 9630 Bedienungsanleitung
Cobra
Cobra ESD - 9230 W X Bedienungsanleitung
Cobra
Cobra SSR 80 Bedienungsanleitung
Cobra
Cobra ESD 7400 Bedienungsanleitung
Cobra
Cobra SPX 6700 Bedienungsanleitung
Cobra
Cobra RAD450 Bedienungsanleitung
Cobra
Cobra iRADAR 200 Betriebsanleitung
Cobra
Cobra INTELLILINK XRS R7 Bedienungsanleitung
Cobra
Cobra XRS 9430 Bedienungsanleitung
