Colorado time systems Dolphin Bedienungsanleitung

User Guide

F912 Rev 201710

For Dolphin version 4.3

Colorado Time Systems

Corporate Office

1551 East 11th Street

Loveland, CO 80537 USA

Sales: 800-279-0111 or +1 970-667-1000

Service: 1-800-287-0653 or +1 970-667-1000

Service Fax: 970-667-1032

Web: www.coloradotime.com

Email: customerservice@coloradotime.com

Information in this manual is subject to change without notice. Pictures and illustrations may not

accurately depict your version. Please check our website for the most current information; our user

manuals are available online in the customer service section of our website.

FCC Compliance Statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interface, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Part Number F912, Rev. 201809

Table of Contents

Introduction............................................................................................................................... 1

How to Use this Manual ....................................................................................................... 1

Theory of Operation.............................................................................................................. 1

Overview for setting up and using the Dolphin System:...................................................... 2

Initial Set Up............................................................................................................................. 3

Software Installation (Do NOT connect Dolphin hardware until software has been

installed)................................................................................................................................ 3

Software Set Up .................................................................................................................... 3

Dolphin Standalone Operation (Sports Timer not used) .................................................. 3

Dolphin with Sports Timer (System 6 or System 5)......................................................... 3

Hardware Set Up................................................................................................................... 4

Setting up the Base ........................................................................................................... 4

Setting up the Starter......................................................................................................... 4

Setting up the Stopwatches............................................................................................... 6

Regular Operation..................................................................................................................... 6

Computer Operator Instructions ........................................................................................... 6

Forced Reset ..................................................................................................................... 7

Confirm Set Up................................................................................................................. 7

Dolphin as Primary Timing System (Standalone Operation -- Sports Timer not used) .. 8

Dolphin as Backup; Sports Timer as Primary Timing System (System 6 or 5) .............. 9

How to Select a Data Set for your Meet ......................................................................... 11

Starting Official Instructions .................................................................................................. 12

Electronic Start System....................................................................................................... 12

Synchronized Start/Manual Stop ........................................................................................ 12

Lane Timer Instructions.......................................................................................................... 13

Synchronized Start (from Electronic Start System or Dolphin Starter).............................. 13

Blanking your lane.......................................................................................................... 14

Wireless Manual Start/Stop ................................................................................................ 14

Watch Operation ............................................................................................................. 14

Blanking your lane.......................................................................................................... 14

Troubleshooting...................................................................................................................... 15

How to turn the Dolphin Starter and Watches on/off & how to change settings: ......... 15

Solution............................................................................................................................... 16

Dolphin Device Updates......................................................................................................... 18

Introduction

Thank you for purchasing a Dolphin system! This system of wireless stopwatches makes

running a swim meet much easier and faster. It has been designed to interface seamlessly

with various meet management software programs; contact your software vendor about

compatibility of their program and Dolphin. Please note that knowledge of your meet

management software is required to use Dolphin effectively.

How to Use this Manual

If you like to start with an overview of the process, and refer to the manual only when you

need it, see the Theory of Operation and the Overview below.

If you like step-by-step instructions, turn to Initial Set Up, beginning on page 3, and start

there. After the step-by-step Software and Hardware instructions, there are separate

instructions for what needs to be done during the meet by the Lane Timers, the Starting

Official, and the Computer Operator.

Theory of Operation

The Dolphin system includes

-Dolphin Software to be loaded on the meet management computer (Windows XP or

higher required). The software accepts the information from the Base unit and writes

files that can be accessed by meet management software.

-A Wireless Stopwatch for each Lane Timer. Watches can be started

automatically via the Starter, or started individually for Manual Start/Stop

backup times.

-A Wireless Starter

oCan be used to start all of the Stopwatches with a

synchronized start

oCan be connected to an electronic start system

(CTS Infinity or Championship Start System, for

example). In this case, the start impulse from the electronic start system will

start the watches automatically.

-A Base unit, which is connected to the meet management

computer with a standard USB cable (included with the Dolphin

system). The Base unit receives information from the starter and

the lane watches

Overview for setting up and using the Dolphin System:

1. Confirm that your meet management software supports Dolphin, and is installed on

the computer you will be using. If it is not, follow the software provider’s instructions

for installing it.

2. Install the Dolphin software from www.coloradotime.com/dolphindownload. Refer to

Software Installation on page 3.

3. Configure your meet management software to use the Dolphin System. Refer to

Software Set Up beginning on page 3 for details.

4. Set up the Dolphin hardware the way you will be using it. Refer to

beginning on page 4.

5. At least a day before the first meet, practice with the Dolphin system so you are

familiar with what to do. Refer to the Computer Operator Instructions (page 6),

Starting Official Instructions (page 12) and Lane Timer Instructions (page 13). You

may also find the Troubleshooting section useful (page 15).

6. Note that there are separate instruction sheets for the Starting Official and Lane

Timers, and a sheet of Dolphin Basics. These instructions describe only what each of

those individuals need to do with their part of the Dolphin system. Many facilities

find it useful to print extra copies of these pages to use in training those individuals.

This manual was loaded on your computer (CTSDolphin\DOCS folder) when you

installed the software. The most recent version is available on our website

(www.coloradotime.com), in the customer service section.

Initial Set Up

Software Installation (Do NOT connect Dolphin hardware until software has been installed)

1. Ensure that your meet management software is installed on the computer you will be

using for Dolphin. If not, install it first.

NOTE: If you have questions regarding using your meet management software,

please see the help files within the software, or contact your software vendor.

2. Download and install the latest updates for your meet management software.

3. Install Dolphin from www.coloradotime.com/dolphindownload

Software Set Up

There are two ways Dolphin can be used as far as meet management software is concerned.

Choose the method your facility will be using and follow the instructions below.

Dolphin Standalone Operation (Sports Timer not used)

In this mode, the Dolphin wireless watches are the primary times for results, and a sports

timer is not used.

1. Connect base unit to computer with USB cable, and open your meet management

software.

2. If required by your meet management software, configure it for Colorado Time

Systems Dolphin as the primary timing system.

Dolphin with Sports Timer (System 6 or System 5)

If you are using a sports timer (CTS System 6 or System 5, for example) in addition to

Dolphin, you may need a backup mode in your meet management software. For example,

Hy-Tek’s Meet Manager requires the Dolphin Backup Mode Option, which is sold separately

by Hy-Tek. Contact Hy-Tek for details (Shop online at www.hy-tekltd.com or call

866.456.5111). Other software packages may have their own specific requirements.

In this mode, the Dolphin wireless stopwatches are the backup watches, while the touchpads

and buttons are the primary timing system.

1. Connect base unit to computer with USB cable, and open your meet management

software.

2. If required by your meet management software, configure it for CTS Dolphin as the

backup mode

3. Configure your software for the primary timing system.

Hardware Set Up

Setting up the Base

1. Connect base unit to computer with a standard USB cable

(included with the Dolphin system).

2. Open the Dolphin interface, and set the channel on the base:

-Click the Channel box in the lower left corner of the screen

-Select the desired channel

Setting up the Starter

There are three ways to use Dolphin to start timing a race. Choose the method your facility

will be using and follow the instructions below. The Starter has a small cylindrical BNC

connector on top (see picture below).

Method 1: Wireless Manual Start/Stop

Wireless Manual Start/Stop means that the Dolphin wireless stopwatches are used strictly

like standard stopwatches: each Lane Timer uses the Dolphin watch to start, stop and reset

individually. The data is transmitted wirelessly to the base, and stored on the laptop for

access by your meet management software. This method meets all ruling bodies’ (FINA,

NCAA, USS, NFHS, YMCA) requirements for backup timing.

To set up for this method, put the Dolphin Starter back in the case. It is not used for wireless

manual start/stop. Go on to Setting up the Stopwatches beginning on page 6.

Method 2: Synchronized Start/Manual Stop

Synchronized Start/Manual Stop means that the Starting Official

starts all watches simultaneously with the Dolphin Starter, and the

Lane Timers stop them individually.

1. To set up for this method, turn the Dolphin Starter on (press

and hold the Reset button).

2. Enter the menu (press and hold both buttons).

3. Once in the menu, press Reset to advance to the CHAN

setting.

4. Press Start/Stop to change the channel to the same number

as the Dolphin base.

5. Press Reset to exit the menu.

Method 3: Electronic Start System

When using Dolphin with an electronic start system, such as the CTS

Infinity or Championship Start System, the Dolphin Starter is

connected to the electronic start system with a cable. When the

Starting Official starts the race with the electronic start system, the

watches are started simultaneously. The Lane Timers stop them

individually.

1. To set up for this method, turn the Starter on (press and hold

the Reset button).

2. Enter the menu (press and hold both buttons).

3. Once in the menu, the first setting is TRIG. Press Start/Stop to

select the correct trigger style for your start system:

-TRIG = CTS for use with CTS electronic start system

-TRIG = NC for use with a normally-closed electronic start

system

4. Press Reset to advance to the CHAN setting.

5. Press Start/Stop to change the channel to the same number as

the Dolphin base.

6. Press Reset to exit the menu

7. Follow the instructions for your electronic start system:

oCTS Infinity Start System

oConnect your Dolphin Starter to the Infinity Start

System’s Start Output jack with the Dolphin

Starter to Infinity Kit (K-DSS-1). DO NOT plug

the Dolphin Starter cable into any other jacks.

oThe start impulse from the Infinity will start the

lane watches automatically.

oCTS Championship Start System

oConnect your Dolphin Starter to the Champ Start’s Timer

Start jack with the Dolphin Starter to Champ Start Kit (K-

DSS-2). DO NOT plug the Dolphin Starter cable into any

other jacks.

oThe start impulse from the Champ Start will start the lane

watches automatically.

Setting up the Stopwatches

Follow these steps for each watch to be used at a meet:

1. Turn the watch on (press and hold the Reset button).

2. Enter the menu (press and hold the Reset button and either of the side

buttons).

3. Once in the menu, the first setting is LANE. Press a side button to

change the lane for this watch, and then press Reset to advance to the next

menu option.

4. Press a side button to select the TIMER for this lane (A, B or C), and

then press Reset to advance to the next option.

5. Press a side button to select the channel number. This MUST match

the channel on the starter and the base.

6. Press Reset to exit the menu.

Watches will show up on the Dolphin screen when set.

Regular Operation

This section describes the regular operation of the Dolphin system at a meet.

There are separate instructions for the Computer Operator, the Starting Official, and the Lane

Timers, describing only what that individual needs to do. This way, each can refer to his or

her specific section to know what to do. Many facilities find it useful to print extra copies of

Starting Official and Lane Timer pages to use in training those individuals. This manual is

available on the customer service section of our website (www.coloradotime.com).

Computer Operator Instructions

There are two ways Dolphin can be used as far as meet management software is concerned:

standalone, or with a sports timer. Follow the instructions for the method your facility is

using.

Dolphin Screen -- DO NOT CLOSE THIS WINDOW while using Dolphin. It’s OK to minimize it.

Andere Handbücher für Dolphin

Inhaltsverzeichnis

Andere Colorado time systems Datenlogger Handbücher

Colorado time systems

Colorado time systems Dolphin Handbuch

Beliebte Datenlogger Handbücher anderer Marken

TESTO

TESTO 176 Bedienungsanleitung

HT Italia

HT Italia XL421 Bedienungsanleitung

HBM

HBM SOMAT XR CX22B-R Bedienungsanleitung

Agtrix

Agtrix 380i Bedienungsanleitung

Hobo

Hobo H8 Pro Bedienungsanleitung

Beijing ART Tech

Beijing ART Tech PCI2320 Bedienungsanleitung

Athena

Athena GET SL1 Bedienungsanleitung

Motec Systems

Motec Systems C185 Bedienungsanleitung

Beijing ART Tech

Beijing ART Tech USB2832 Bedienungsanleitung

Rotronic

Rotronic HygroLog HL20 Bedienungsanleitung

MRC

MRC DW-6092 Bedienungsanleitung

Racelogic

Racelogic VBOX LapTimer Bedienungsanleitung

Edu-Logger

Edu-Logger 900-240 Bedienungsanleitung

Elma

Elma DT173 Bedienungsanleitung

MadgeTech

MadgeTech PRTemp140 Technisches Datenblatt

Comet

Comet U0121M Bedienungsanleitung

pico Technology

pico Technology PT-104 Bedienungsanleitung

Soil Instruments

Soil Instruments GTecLink Bedienungsanleitung