ColorKey Blaster 2R Bedienungsanleitung

Blaster 2R

Beam, Scanner, & Laser Simulator Effects

CKU01-1040 (US) / CKE01-1040 (EU)

USER MANUAL

Introduction

Thank you for purchasing the ColorKey Blaster 2R. Please read these instructions carefully

before use. O

perating this fixture according to these instructions is important to avoid any

possible damage or

accidents caused by misuse.

Packing list

!1x Blaster 2R fixture

!1x DMX cable

!1x Power cord

!User Manual

Safety

Caution! Opening this unit voids warranty. Contact ColorKey for any service requests.

Warning! To avoid electrical shock, be sure to disconnect power before any service or when moving or setting

up the fixture.

Caution! Avoid direct eye exposure with the fixture when on.

•This fixture is for indoor use only.

•This fixture must be installed a minimum distance of 5 meters (16’4”) away from any lighted objects.

•Do not install or operate this fixture near flammable materials.

•This device must be installed, operated, and maintained by a qualified professional.

•Do not touch the fixture with bare hands during operation as the surface temperature of the fixture can

exceed 60˚C (140˚F). Turn off power and wait 15 minutes for the fixture to cool before attempting to touch

it.

•Please check if the voltage is in accordance with the rated power before installing.

•Do not operate this fixture if the power cord has been damaged. Turn off fixture and replace with a power

cord of similar rating.

Display Operation

•MENU: Access the menu/Scroll through menu options

•ENTER: Open/Select the current menu option

•UP: Scroll through menu selection or parameter increase

•DOWN: Scroll through menu selection or parameters decrease

DMX Values

DMX 17 Channel Mode

Channel

Function

Pan

Tilt

Color

Gobo

Pattern Macros

Pattern Rotation (double directions)

Pattern Rotation (horizontal/vertical)

Pattern Zoom

Horizontal Pattern Movement

Vertical Pattern Movement

Eccentri

Eccentri Shaking

Prism

Prism Auto Rotation

Dimmer

Shutter

Macro Function (active after 5 seconds)

DMX 21 Channel Mode

Channel

Function

Pan

Pan Fine (16 bit)

Tilt

Tilt Fine (16 bit)

Pan shaking

Tilt shaking

Color

Gobo

Pattern Macros

Pattern Rotation (double directions)

Pattern Rotation (horizontal/vertical)

Pattern Zoom

Horizontal Pattern Movement

Vertical Pattern Movement

Eccentri

Eccentri Shaking

Prism

Prism Auto Rotation

Dimmer

Shutter

Macro Function (active after 5 seconds)

Menu Guide & Operation

A001

DMX Address

DMX Address code set

A512

17Ch

Channel Mode

Channel selection

21Ch

Sound

Show Mode

Voice control, auto control

Auto

Master

Slave Mode

Master or Slave mode selection

Slave

Black Out

Standby selection

Yes

Sound State

Voice control switch

Off

Sound Sense

0--100

Acoustic sensitivity (0 min, 100 max)

Pan Inverse

Motor pan reverse

Yes

Tilt Inverse

Motor tilt reverse

Yes

Back Light

LCD display backlight on/off

Off

Lamp On/Off

Lamp switches

Off

Auto Test

Test unit

---°C

Not connected to the temperature sensor

Temp.

-20--200°C

Display internal temperature of the unit

Fixture Time

0--999

Total running time

Firmware Version

V1.01

Version numbering

Factory Defaults

Restore the factory default Settings

Yes

System Reset

Unit reset

Yes

DMX Connections

"DMX Cable：

The Blaster 2R can be controlled via DMX using a 3-pin XLR connection. The standard

DMX connection is XLR is: one end connects to the male plug, and the other connects to the

female. As below: pin 1: ground, pin 2: negative signal, pin 3: positive signal

Noted：In order to avoid failures and interference signal transmission，we connect a

resistance120Ω（1/4W ）at the end of the DMX connecting as below:

"The Conversion between 3 pin and 5 pin XLR

If the output cable of DMX512 controller is the 5PIN, please use 1pc 5PIN to 3PIN cable

Master/Slave Mode Operation

Master/Slave

Master/Slave mode allows you to connect multiple units together using one (1) unit to control

others in a chain. When a fixture is set to ‘Master Mode,’ this unit will always act as a

controlling unit until it is switched out of ‘Master Mode’. The Master unit will send out signal

via DMX to Slave units which will react in synchronization. When a fixture is set into ‘Slave

Mode’, this fixture will receive the Master signal. To avoid master signal and DMX signal

interference, do not connect DMX when using Master/Slave mode. If using a DMX run

longer than 60 meters and/or over 32 units, a signal amplifier may be required.

Troubleshooting

Problem

Solutions

No DMX control

#Make sure that the DMX cable is properly connected

#Make sure that the DMX controller is operational

#Check the DMX cable for tears or breaks

#Make sure that the fixture is in DMX mode

Fixture does not

respond to sound

#Make sure that the fixture is in Sound Active mode.

Technical Information

Power supply: AC 100-240V –50/60Hz

Power consumption: 160W

Light source: 2R YODN Lamp

Life span: 2000 hours

Color temperature: 8000 k

Colors: 14 colors plus white

Gobos: 17 gobos plus open

Beam angle: 3˚

Channel: 17/21ch

Control: Auto, Sound active, DMX512, Master/slave

Dimmer: Electronic dimming

Prism: Three-facet prism

Display: LED display

Weight: 16.5lbs (7.5kg)

Dimensions: 14” x 10.5” x 9.5” (358 x 268 x 242mm)

Notice to consumer: ColorKey offers a 1-year limited warranty. Please visit our website at

www.ColorKeyLED.com to register your product.

Please note: As we continue to work towards improving our products and your experience

as a user, we recommend that you check our website periodically for updates to user

manuals and specifications at www.ColorKeyLED.com or you may contact us directly at

[email protected].

Inhaltsverzeichnis

Andere ColorKey DJ-Equipment Handbücher

ColorKey

ColorKey Mover Beam 4 Zoom Bedienungsanleitung

ColorKey

ColorKey PartyBar GO Bedienungsanleitung

ColorKey

ColorKey AIRPAD QUAD Bedienungsanleitung

ColorKey

ColorKey MiniWash QUAD-W 7 Bedienungsanleitung

ColorKey

ColorKey StageBar HEX 12 Bedienungsanleitung

ColorKey

ColorKey Mover Halo Beam QUAD Bedienungsanleitung

ColorKey

ColorKey MobilePar Hex 4 Bedienungsanleitung

ColorKey

ColorKey MicroPar HEX 7 Bedienungsanleitung

ColorKey

ColorKey MobilePar Hex 4 Bedienungsanleitung

ColorKey

ColorKey PartyBar FX Bedienungsanleitung

ColorKey

ColorKey Mover Wash HEX 12 Bedienungsanleitung

ColorKey

ColorKey StagePar COB TRI 4 Bedienungsanleitung

ColorKey

ColorKey Mover Spot 100 Bedienungsanleitung

ColorKey

ColorKey Kraken FX Bedienungsanleitung

ColorKey

ColorKey StageBar TRI 12 Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Zumtobel

Zumtobel APHRODITE Home Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung