Using the Communicator in MIC mode
Place the head/earphones in a comfortable position
and connect them to the Comfort Duett (13). Make
sure that the volume control (3) is in the lowest
position, 0. If the maximum volume control is
incorrectly adjusted the maximum volume might
be harmful! Also make sure not holding the head/
earphones and Comfort Duett too close to each
other since this might cause an unpleasant acoustic
feedback. Slide the mode selector (1) to the top
position. A steady green LED indicates that the
battery is charged. If the LED is ashing, Comfort
Duett needs to be recharged. A dark LED indicates
that the battery is empty or incorrectly installed. See
page 4 for battery installation.
Using the T (loop) mode
Using the T (loop) mode in Comfort Duett makes it
possible to pick up signals from an inductive loop.
When an inductive loop is installed in a public
premise the sign below is usually displayed.
Place the head/earphones in a comfortable position
and connect them to the Comfort Duett (13). Make
sure that the volume control (3) is in the lowest
position, 0. Also make sure not holding the head/
earphones and Comfort Duett too close to each
other since this might cause an unpleasant acoustic
feedback.
Adjust the volume to a comfortable level.
You receive maximum performance when Comfort
Duett is in a vertical position.
Shutting OFF the Comfort Duett
Comfort Duett is turned off by sliding the mode
selector (1) to the bottom, OFF, position. None of the
LEDs should be lit.
The Comfort Duett automatically shuts off when
placed in the base unit, unless it is connected to an
external source like TV or telephone and in use. The
Comfort Duett is always charging when placed in the
base unit and the base is connected to a wall outlet, as
indicated by the green LED on the base unit.
The Comfort Duett is manufactured for an easy
operation. Should you however encounter any
problems, please try these tips.
Comfort Duett does not work in MIC-mode.
a) Make sure that the mode selector (1) is in the
top position and the green LED has a steady
light, see further above.
b) Make sure that the head/earphones are
securely plugged into the Comfort Duett.
c) Make sure that the volume is correctly adjusted.
d) Make sure that the maximum volume control
(6) is correctly adjusted, see page 5.
Comfort Duett does not work in T mode.
a) Make sure that the mode selector (1) is in the
middle position and the orange LED has a
steady light, see above.
b) Make sure that the head/earphones are
securely plugged into Comfort Duett.
c) Make sure that the volume is correctly adjusted.
d) Make sure that the maximum volume control
(6) is correctly adjusted, see page 5.
e) Make sure that the induction loop is working
properly.
Comfort Duett does not charge.
a) Make sure that the power supply cord is
plugged in correctly into a working wall
socket and into the base unit.
b) Make sure that Comfort Duett is placed
correctly in the base unit and the LED on the
base unit has a steady green light.
c) Make sure that the battery is correctly
placed in Comfort Duett and according to
required battery specications. See page 4.
MIC mode
T mode
OFF
+
Volume
-
Operating instructions
Troubleshooting tips
Note: The volume control is ONLY
used for adjusting the volume,
NOT for turning the unit off.
