C365-4G-H900 User Manual CB-V1 (May 2020)
•Enable: Check the box to enable the SMS command feature.
•SMS ACK: If checked, the router will send the command feedback to the sender’s phone
number. If unchecked, the router will not send the command feedback to the sender’s phone
number.
•Reboot Router Command: Input the command for “reboot” operation, default is “reboot”.
•Get Cell Status Command: Input the command for “router cell status checking” operation,
default is “cell status”. For example, if we send “cell status” to the router, the router will
feedback the status to the sender such as “Router SN: 086412090002 cell_link_up”, which
identifies the router SN number and Cell Working Status.
•Set cell link-up Command: Input the command for the “router cell link up” operation, default
is “cell up”. If the router receives this command, the Router Cell will be online.
•Set cell link-down Command: Input the command for “router cell link down” operation,
default is “cell down”. If router gets this command, the Router Cell will be offline.
•DIO_0 Set Command: set I/O port 0 to high (1). For the SMS feature, please keep the
parameter as default.
•DIO_0 Reset Command: set I/O port 0 to low (0). For the SMS feature, please keep the
parameter as default.
•DIO_1 Set Command: set I/O port 1 to high (1). For the SMS feature, please keep the parameter
as default.
•DIO_1 Reset Command: set I/O port 1 to low (0). For the SMS feature, please keep the
parameter as default.
•DIO_2 Set Command: set I/O port 2 to high (1). For the SMS feature, please keep the parameter
as default.
•DIO_2 Reset Command: set I/O port 2 to low (0). For the SMS feature, please keep the
parameter as default.
•DIO_3 Set Command: set I/O port 3 to high (1). For the SMS feature, please keep the parameter
as default.
•DIO_3 Reset Command: set I/O port 3 to low (0). For the SMS feature, please keep the
parameter as default.
•Button Set/Reset DIO: Set the DIO to high or low immediately.
•DIO Status Command: Input the command for I/O port status. For the SMS feature, please
keep the parameter as default.
•Wi-Fi on Command: Input the command for turning on the Wi-Fi. For the SMS feature, please
keep the parameter as default.
•Wi-Fi off Command: Input the command for turning off the Wi-Fi. For the SMS feature, please
keep the parameter as default.
•Force Cellup Command: If the cell is down due to traffic limitation, then it can be brought up
by this command.
•Operator List Command: Send the modem operator list as SMS, it is only supported by some
specific modems.
•Operator set Command: Set the modem to operator manually, it is only supported by some
specific modems.
