CommScope 5NPX1006F Bedienungsanleitung

Argus

Installation Instructions

Multi-Beam Panel Antenna 5NPX1006F

Bulleti

Bulletin D701-0005 • Revision D • July 2013 page 1 of 8

CommScope Infrastructure Academy offers installation training

General

This instruction sheet contains all necessary information required to assist in the correct installation

of ARGUS Multi-Beam Panel Antennas.

The following symbols can be found next to text outlining important information.

Please follow the procedure marked with this symbol precisely.

Non-compliance may lead to damage of the product.

Handy tips when installing product.

Unpacking

To make sure no pressure and load on the radome of this antenna in handling and

fixing.

Make sure that the antenna and the accessory items listed below are provided and have not been

damaged during transport.

•Antenna

•Mounting kit

•Installation Instructions (This document)

Mounting Kits Type

Fixed Downtilt F-042-GL-E

Mechanical Downtilt T-045-GL-E

Do not install near power lines. Power lines,

telephone lines, and guy wires look the same.

Assume any wire or line can electrocute you.

Do not install on a wet or windy day or

when lightning or thunder is in the area.

Do not use metal ladder.

Wear shoes with rubber soles and heels.

Wear protective clothing including a

long-sleeved shirt and rubber gloves.

Multi-Beam Panel Antenna 5NPX1006F

Bulletin D701-0005 • Revision D • July 2013 page 2 of 8

Installation Instructions

•Ensure a torque spanner is used when tightening fasteners, see the mounting kit

diagrams on the following pages for the correct torque recommendations.

•Ensure antenna is installed with the connectors and drainage holes at the bottom.

Installation Instructions - Fixed Downtilt Mounting Kit (F-042-GL-E)

Assemble both mounting brackets to the antenna as per Figures 1, 2 & 3 of this document.

Attach the mounting kit assembly to the antenna, before trying to clamp the brackets

to the pole.

The clamp brackets can clamp pipe diameters between 60mm (2.4") & 115mm (4.5").

For typical installations the minimum recommended pipe diameter is 75mm (3").

Figure 1. Correctly Assembled

Mounting Brackets

Bulletin D701-0005 • Revision D • July 2013 page 3 of 8

For Multi-Beam Panel Antenna 5NPX1006F

Figure 2. Fixed Downtilt Mounting Bracket

Assembled to Antenna & pole

Figure 3. Fixed Downtilt Mounting Bracket Exploded Assembly

Multi-Beam Panel Antenna 5NPX1006F

Bulletin D701-0005 • Revision D • July 2013 page 4 of 8

Installation Instructions - Mechanically Adjustable Downtilt Mounting Kit (T-045-

GL-E) , Bracket Spacing 716mm (28.2")

Assemble both mounting brackets as per Figures 4 and 5 (or Figures 7 and 8) of this

document.

1. Attach the lower and upper mounting bracket assemblies to the antenna, before

clamping the brackets to the pole. Downtilt angles of 0°and 2°to 10°in 1°

increments can be obtained with the correct setting of the tilt arm bracket. For 0°

downtilt the tilt arm may be stowed as show in Figure 5.

2. 2°-10°downtilt can be achieved by aligning the corresponding hole in the tilt arm

to the pivot bracket which mates against the mounting pole, as shown in Figure 6 or

Figure 9. The first hole is for 2°downtilt, with each consecutive hole resulting in an

increased inclination of 1°.

3. When the tilt arm is used in the upper antenna bracket as shown in Figures 4 and 5,

the mechanical tilt can be set to 0° or to any angle from 2° to 10° in 1° steps. The

electrical beams emerge from the front of the antenna with a 6° electrical downtilt

so 6° needs to be added to the mechanical tilt to find the actual pointing of the

beams.

4. When the tilt arm is used in the lower mounting bracket as shown in Figure 6, the

mechanical uptilt can be set to 0° or to any angle from 2° to 10° in 1° steps. The

electrical beams emerge from the front of the antenna with a 6° electrical downtilt

so the mechanical uptilt needs to be subtracted from the 6° electrical downtilt to

find the actual downtilt of the beams.

The clamp brackets can clamp pipe diameters between 60mm (2.4") & 115mm (4.5").

For typical installations the minimum recommended pipe diameter is 75mm (3").

Bulletin D701-0005 • Revision D • July 2013 page 5 of 8

For Multi-Beam Panel Antenna 5NPX1006F

6º Downtilt

=0° mechanical

+6° electrical

11º Downtilt

=5° mechanical

+6° electrical

16º Downtilt

=10° mechanical

+6° electrical

Figure 5. Setting mechanical downtilt

Figure 4

Arrangement of mounting kits to provide downtilt (details A and B

in Figure 5)

Multi-Beam Panel Antenna 5NPX1006F

Bulletin D701-0005 • Revision D • July 2013 page 6 of 8

6ºDowntilt

=6° electrical

-0° mechanical

1ºDowntilt

=6° electrical

-5° mechanical

-4ºDowntilt

= 6° electrical

-10° mechanical

Figure 6

Setting uptilt

Bulletin D701-0005 • Revision D • July 2013 page 7 of 8

For Multi-Beam Panel Antenna 5NPX1006F

Labelling of Antenna Beams

This antenna radiates 5 beams. As mentioned in connection with tilting of the antenna, the beams

point downwards relative to the front face of the antenna at an angle of 6°. In the horizontal plane,

the beams are at azimuth angles of -40° (i.e. 40° to the left of boresight when looking at the

antenna from the rear), -20°, 0°, +20°, +40° (i.e. 40° to the right of boresight when looking at the

antenna from the rear). There are 10 connectors to the antenna, one for each beam of the antenna

at a polarization of +45° and one for each beam at a polarization of -45°.

The pairs of connectors for each beam direction are shown in Figure 7.

The labelling metioned here are not applyable for the antennas series number are,

00000001,00000002,00000003,00000004.

Operation of Antennas

RF Cable

Connection

The 7-16 female connectors fitted to the antenna are designed to fit jumper

cables with a standard 7-16 RF male connector. After ensuring both mating

connectors are dry push the male connector in and tighten the connector

coupling to 23 - 28Nm (17 -21 ft.lb).

If needed or as required by local procedures a weatherproofing kit may

then be fitted to the connection.

If the RF connectors are tightened beyond the recommend torque the RF

connection to the antenna may be damaged.

+40 ºBeam

pointing +20 ºBeam

pointing 0 ºBeam

pointing -20ºBeam

pointing -40ºBeam

pointing

Figure

Arrangement of connectors on the base of the antenna.

Multi-Beam Panel Antenna 5NPX1006F

Bulletin D701-0005 • Revision D • July 2013 page 8 of 8

Revision

Changes Date

A First Release 2011-05-10

B Add caution in content of unpacking 2013-03-26

C More clearly define the recommended installation

requirements and warnings & update the figure 2 and 7. 2013-06-19

D Changed drawing template to COMMSCOPE. 2013-07-25

CommScope

1100 CommScope Place SE P.O. Box 339, Hickory, NC 28603-

0339

(828) 324-2200 (800) 982-1708

www.commscope.com/andrew

Customer Service 24 hours

North America: +1-800-255-1479 (toll free)

Any country: +1-779-435-6500

email: acicustomersupportcent[email protected]

Notice: CommScope disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.

Aviso: CommScope no acepta ninguna obligación ni responsabilidad como resultado de prácticas incorrectas o peligrosas de instalación, inspección, mantenimiento o retiro.

Avis : CommScope décline toute responsabilité pour les conséquences de procédures d’installation, d’inspection, d’entretien ou de retrait incorrectes ou dangereuses.

Hinweis: CommScope lehnt jede Haftung oder Verantwortung für Schäden ab, die aufgrund unsachgemäßer Installation, Überprüfung, Wartung oder Demontage auftreten.

Atenção: A CommScope abdica do direito de toda responsabilidade pelos resultados de práticas inadequadas e sem segurança de instalação, inspeção, manutenção ou remoção.

Avvertenza: CommScope declina eventuali responsabilità derivanti dell’esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.

注意：

CommScope 公司申明對於不恰當或不安全的安裝、檢驗、維修或拆卸操作所導致的后果不負任何義務和責任

D701

0005

Inhaltsverzeichnis

Andere CommScope Antenne Handbücher

CommScope

CommScope CMAX-DMF-43-UW-i53 Bedienungsanleitung

CommScope

CommScope ARGUS Bedienungsanleitung

CommScope

CommScope DB404 Series Bedienungsanleitung

CommScope

CommScope Valuline Bedienungsanleitung

CommScope

CommScope MC-MNT-3XV-TS1 Bedienungsanleitung

CommScope

CommScope CMAX-D-43-UW-i53 Bedienungsanleitung

CommScope

CommScope CMAX-DMF3-43-Ci53 Bedienungsanleitung

CommScope

CommScope CMAX-O Series Bedienungsanleitung

CommScope

CommScope ION-M8P S Bedienungsanleitung

CommScope

CommScope CMAX-DM20 Bedienungsanleitung

CommScope

CommScope CMAX-OMF7-43-UWI53 Bedienungsanleitung

CommScope

CommScope CMAX-O-CPUSEWV53 Bedienungsanleitung

CommScope

CommScope CMAX-LHM2-30-I53 Bedienungsanleitung

CommScope

CommScope CMAX-DM CPUSE Series Bedienungsanleitung

CommScope

CommScope ValuLine VHLP Series Bedienungsanleitung

CommScope

CommScope CMAX-OMF8-43-UWI53 Bedienungsanleitung

CommScope

CommScope CMAX-DM60-Series Bedienungsanleitung

CommScope

CommScope CMAX-OUS1-UW-I53 Bedienungsanleitung

CommScope

CommScope CMAX-DMW3060-43i53 Bedienungsanleitung

CommScope

CommScope ValuLine VHLP3 Series Bedienungsanleitung

CommScope

CommScope ValuLine VHLP Series Bedienungsanleitung

CommScope

CommScope Cell-Max CMAX-O-TCPUSEWI53 Bedienungsanleitung

CommScope

CommScope CMAX Series Bedienungsanleitung

CommScope

CommScope CELLMAX-D-CPUSE Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

IWCS

IWCS iriBelt II Einrichtungshandbuch

Labgear

Labgear LABHG32T Bedienungsanleitung