CommScope ION-M8P S Bedienungsanleitung

Optical Remote Unit

ION™-M8P S

Manual

MF0132APB

Andrew Solutions is a trademark of CommScope, Inc.

All information contained in this manual has been revised thoroughly. Yet Andrew

Solutions accepts no liability for any omissions or faults.

Andrew Solutions reserves the right to change all hard- and software characteristics

without notice.

Names of products mentioned herein are used for identification purposes only and

may be trademarks and / or registered trademarks of their respective companies.

No parts of this publication may be reproduced, stored in a retrieval system,

transmitted in any form or by any means, electronical, mechanical photocopying,

recording or otherwise, without prior written permission of the publisher.

Andrew Wireless Systems GmbH, 13-February-2012

2 of 42

TABLE OF CONTENTS

1. GENERAL 6

1.1. USED ABBREVIATIONS 6

1.2. HEALTH AND SAFETY WARNINGS 8

1.3. ABOUT ANDREW SOLUTIONS 10

1.4. INTERNATIONAL CONTACT ADDRESSES FOR CUSTOMER SUPPORT 11

2. INTRODUCTION 13

2.1. PURPOSE 13

2.2. THE ION-M8P S (INTELLIGENT OPTICAL NETWORK; MMR) 13

2.3. OPTIONAL EQUIPMENT - RELAY ALARM CONNECTING BOARD 14

3. COMMISSIONING 15

3.1. MECHANICAL INSTALLATION 15

3.1.1. General 15

3.1.2. Wall and Pole Mounting 16

3.2. ELECTRICAL INSTALLATION 17

3.2.1. General 17

3.2.2. Connections 18

3.2.3. Grounding 18

3.2.4. Power Connection 19

3.3. CONNECTION OF THE ANTENNA CABLES 20

3.4. CONNECTION OF THE RF CABLES MAIN UNIT TO COMBINING UNIT 20

3.5. OPTICAL-FIBRE-CABLE CONNECTION - RULES 21

3.5.1. Protective Plug 22

3.5.2. Protective-Tube Kit 24

3.6. COMMISSIONING 26

4. ALARMS 29

4.1. BITE AND ALARMS 29

4.2. HANDLING OF ALARMS 29

4.3. ALARM STATUS 29

4.4. STATUS LED ALARMS 29

4.5. RELAY ALARM CONNECTING BOARD 31

4.5.1. External-Alarm Inputs and Outputs 31

3 of 42

4.5.2. Layout and Connector Description 32

4.6. REDUNDANCY RELAY CONFIGURATION 33

4.7. TROUBLESHOOTING 34

5. MAINTENANCE 35

5.1. GENERAL 35

5.2. OPENING AND CLOSING OF THE CABINET 36

5.3. REPLACEMENT OF POWER SUPPLY (AC & DC TYPES) 37

5.4. REPLACEMENT OF FAN UNIT 38

6. SPECIFICATIONS 39

6.1.1. Electrical Specifications 39

6.1.2. Mechanical Specifications 39

6.1.3. Environmental and Safety Specifications 39

6.2. SPARE PARTS LIST 40

7. INDEX 41

8. LIST OF CHANGES 42

4 of 42

FIGURES AND TABLES

figure 3-1 Wall mounting........................................................................................... 16

figure 3-2 Pole mounting .......................................................................................... 16

figure 3-3 ION-M8P S, connector flange, exemplary................................................ 18

figure 3-4 Grounding bolt.......................................................................................... 18

figure 3-5 AC mains plug.......................................................................................... 19

figure 3-6 DC mains plug.......................................................................................... 19

figure 3-7 Protective-plug assembly ......................................................................... 22

figure 3-8 Tube-kit installation................................................................................... 25

figure 4-1 Alarm triggering........................................................................................ 30

figure 4-2 Relay alarm connecting board, description of connectors........................ 32

figure 4-3 Alarm-output contacts, alarm condition .................................................... 33

figure 4-4 Redundancy connection, cabling.............................................................. 33

figure 4-5 Redundancy RF relay............................................................................... 33

figure 4-6 Redundancy connectors, Main Unit and Substitute Unit........................... 33

figure 5-1 Locker with key......................................................................................... 36

figure 5-2 Front and top cover screws...................................................................... 36

figure 5-3 Screws of PSU AC ................................................................................... 37

figure 5-4 Screws of optional PSU DC...................................................................... 37

figure 5-5 Fan unit screws ........................................................................................ 38

figure 5-6 Fan-connector cable................................................................................. 38

table 1-1 List of international contact addresses....................................................... 12

table 4-1 Status LED alarms..................................................................................... 30

table 4-2 Relay alarm connecting board connectors, pin assignment....................... 32

table 5-1 Specified torques for various screw types ................................................. 35

5 of 42

1. GENERAL

1.1. USED ABBREVIATIONS

3GPP 3rd Generation Partnership Project

4G 4th Generation

ALC Automatic Level Control

AMPS American Mobile Phone System or Advanced Mobile Phone System

AWS Advanced Wireless Services

BBU Battery Backup Unit

BCCH Broadcast Control Channel

BITE Built-In Test Equipment

BTS Base Transceiver Station

CDMA Code Division Multiple Access

CEPT Conférénce Européenne des Postes et Télécommunications

CF Center Frequency

CFO Center Frequency Offset

CPD Channel Power Detection

DL Downlink

DoC Declaration of Conformity

EDGE Enhanced Data Rates for GSM Evolution

ESD Electrostatic Discharge

ETS European Telecommunication Standard

ETSI European Telecommunication Standards Institute

FCC Federal Communications Commission

FRU Field Replaceable Unit

FSK Frequency Shift Keying

GSM Global System for Mobile Communication

GUI Graphical User Interface

I2C-Bus Inter Integrated Circuit Bus (Philips)

ID No Identification Number

IF Intermediate Frequency

LMT Local Maintenance Terminal

LNA Low-Noise Amplifier

LO Local Oscillator

LRU Last Replaceable Unit

LTE Long Term Evolution

MIMO Multiple Input Multiple Output

MS Mobile Station

OMC Operation and Maintenance Center

OTRx Optical Transceiver = SRMU (Subrack Master Unit)

PCMCIA Personal Computer Modem Communication International Association

PCS Personal Communication System

PSTN Public Switched Telephone Network

R&TTE Radio & Telecommunications Terminal Equipment

Rev Revision

RF Radio Frequency

RLP Radio Link Protocol

RSSI Receive Signal Strength Indication

RTC Real-Time Clock

RX Receiver

6 of 42

SCL Serial Clock

SDA Serial Data

SISO Single Input Single Output

SPD Switching Point Detector

SRMU Subrack Master Unit = OTRx (Optical Transceiver)

TCH Traffic Channel

TDD Time-Division Duplex

TDMA Time Division Multiple Access

TX Transmitter

UL Uplink

UMR Universal Measurement Receiver

UMTS Universal Mobile Telecommunication System

UPS Uninterruptible Power Supply

VSWR Voltage Standing Wave Ratio

WDM Wavelength Division Multiplex

WiMAX Worldwide Interoperability for Microwave Access

7 of 42

1.2. HEALTH AND SAFETY WARNINGS

1. Only suitably qualified personnel is allowed to work on this unit and only after

becoming familiar with all safety notices, installation, operation and maintenance

procedures contained in this manual.

2. Read and obey all the warning labels attached to the unit. Make sure that the

warning labels are kept in a legible condition and replace any missing or

damaged labels.

3. Obey all general and regional installation and safety regulations relating to work

on high voltage installations, as well as regulations covering correct use of tools

and personal protective equipment.

4. Keep operating instructions within easy reach and make them available to all

users.

5. It is the responsibility of the network provider to implement prevention measures

to avoid health hazards which may be associated to radiation from the antenna(s)

connected to the unit.

6. Note for a Class A digital device or peripheral:

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may

cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in

which case the user will be required to correct the interference at his own

expense.

7. Make sure, access is restricted to qualified personnel.

8. Only licence holders for the respective frequency range are allowed to operate

this unit.

9. Corresponding local particularities and regulations must be observed. For national

deviations please refer to the respective documents included in the manual CD

delivered.

10.Use this equipment only for the purpose specified by the manufacturer. Do not

carry out any modifications or fit any spare parts which are not sold or

recommended by the manufacturer. This could cause fires, electric shock or other

injuries.

11.Due to power dissipation, the repeater may reach a very high temperature. Do not

operate this equipment on or close to flammable materials.

8 of 42

12.Before opening the unit, disconnect mains.

13.ESD precautions must be observed! Before commencing maintenance work, use

the available grounding system to connect ESD protection measures.

14.This unit complies with European standard EN60950.

15.Make sure the repeater settings are according to the intended use (see also

product information of manufacturer) and regulatory requirements are met.

16.Although the repeater is internally protected against overvoltage, it is strongly

recommended to earth the antenna cables close to the repeater’s antenna

connectors for protection against atmospheric discharge.

17.Laser radiation! Do not stare into the beam; do not view it directly or with optical

instruments.

9 of 42

1.3. ABOUT ANDREW SOLUTIONS

Andrew Wireless Systems GmbH based in Buchdorf/ Germany, is a leading

manufacturer of coverage equipment for mobile radio networks, specializing in high

performance, RF and optical repeaters. Our optical distributed networks and RF

repeater systems provide coverage for every application: outdoor use, indoor

installations, tunnels, subways and many more.

Andrew Wireless Systems GmbH has unparalleled experience in providing RF

coverage and capacity solution for wireless networks in both indoor and outdoor

environment and belongs to Andrew Solutions, a CommScope Company.

Andrew Solutions is the foremost supplier of one-stop, end-to-end radio frequency

(RF) solutions. Our products are complete solutions for wireless infrastructure from

top-of-the-tower base station antennas to cable systems and cabinets, RF site

solutions, signal distribution, and network optimization.

Andrew Solutions has global engineering and manufacturing facilities. In addition, it

maintains field engineering offices throughout the world.

We operate a quality management system in compliance with the requirements of

ISO 9001. All equipment is manufactured using highly reliable material. In order to

ensure constant first-rate quality of the products, comprehensive quality monitoring is

conducted at all fabrication stages. Finished products leave the factory only after a

thorough final acceptance test, accompanied by a test certificate guaranteeing

optimal operation.

Note: Exceptions of and national deviations from this intended use may be

possible. To observe corresponding local particularities and

regulations, please refer to the respective documents (also in

national language) which are included in the manual CD delivered.

To make the most of this product, we recommend you carefully read the instructions

in this manual and commission the system only according to these instructions.

For technical assistance and support, please also contact the local office or Andrew

Solutions directly at one of the addresses listed in the following chapter.

10 of 42

Inhaltsverzeichnis

Andere CommScope Antenne Handbücher

CommScope

CommScope ValuLine VHLP Series Bedienungsanleitung

CommScope

CommScope CMAX-DMF3-43-Ci53 Bedienungsanleitung

CommScope

CommScope ASP7A Bedienungsanleitung

CommScope

CommScope CELLMAX-D-CPUSE Bedienungsanleitung

CommScope

CommScope F-042-GL-E Bedienungsanleitung

CommScope

CommScope ARGUS U Series Bedienungsanleitung

CommScope

CommScope CMAX-OMF8-43-UWI53 Bedienungsanleitung

CommScope

CommScope DB224 Bedienungsanleitung

CommScope

CommScope CMAX-DMF-43-UW-i53 Bedienungsanleitung

CommScope

CommScope CMAX-OUS-UW43-i53 Bedienungsanleitung

CommScope

CommScope CMAX-DM CPUSE Series Bedienungsanleitung

CommScope

CommScope ValuLine VHLP Series Bedienungsanleitung

CommScope

CommScope ValuLine VHLP3 Series Bedienungsanleitung

CommScope

CommScope DB404 Series Bedienungsanleitung

CommScope

CommScope CMAX Series Bedienungsanleitung

CommScope

CommScope 5UPX0805F Bedienungsanleitung

CommScope

CommScope CMAX-DMF-43-UW-i53 Bedienungsanleitung

CommScope

CommScope CMAX-OMF-6-43-UWI53 Bedienungsanleitung

CommScope

CommScope CMAX-OMF7-43-UWI53 Bedienungsanleitung

CommScope

CommScope CMAX-OUS-43-i53 Bedienungsanleitung

CommScope

CommScope MC-MNT-3XV-TS1 Bedienungsanleitung

CommScope

CommScope CMAX-O Series Bedienungsanleitung

CommScope

CommScope CMAX-LHM2-30-I53 Bedienungsanleitung

CommScope

CommScope CMAX-D-43-UW-i53 Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

Proxim

Proxim 5054-PA-23 Bedienungsanleitung

IWCS

IWCS iriBelt II Einrichtungshandbuch