Hardware Installation 9
RocketModem III - Canada
company will notify you as soon as possible. Also you will be advised of your
right to file a complaint with the FCC, if you believe it is necessary.
4. The telephone company may make changes in its facilities, equipment,
operations, or procedures that could affect the operation of the equipment. If
this happens, the telephone company will provide advance notice in order for
you to make necessary modifications in order to maintain uninterrupted
service.
5. If the equipment is causing harm to the network, the telephone company may
request you to remove the equipment from the network until the problem is
resolved. If so, contact Comtrol Corporation at 651-631-7654.
6. No repairs are to be made by you. Repairs are to be made only by Comtrol or
its licensees. Unauthorized repairs void the warranty and the registration.
7. This equipment may not be used for public coin phone service provided by the
Telephone Company. Connection to Party Line Service is subject to state
tariffs. (Contact the state public utility commission, public service commission,
or corporation commission for information.)
8. The Telephone Consumer Protection Act of 1991 makes it unlawful for any
person to use a computer or other electronic device, including fax machines, to
send any message unless such message clearly contains in a margin at the top
or bottom of each transmitted page or on the first page of the transmission, the
date and time it is sent, an identification of the business or other entity, or
other individual sending the message, and the telephone number of the
sending machine or of such business, other entity, or individual. (The
telephone number provided may not be a 900 number or any other number for
which charges exceed local or long-distance transmission charges.) In order to
program this information into your fax software, you should refer to the
manual of the Fax software being used.
RocketModem III - Canada
The RocketModem III connects directly to off-premises Common Carrier facilities
using the standard two-wire telephone connection. In some cases, the building’s
inside wiring associated with a single line individual server may be extended by
means of a certified connector assembly (telephone extension card).
NOTICE: The Industry Canada label identifies certified equipment. This
certification means the equipment meets telecommunications network protective,
operational, and safety requirements as prescribed in the appropriate Terminal
Equipment Technical Requirements document(s). The Department does not
guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative
designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines, and internal metallic water pipe
system, if present, are connected together. This precaution may be particularly
important in rural areas.
Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority or
electrician, as appropriate.
NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device
Caution
