Condair HumiLife RH Series Planungshandbuch

Homeowner's Manual

Condair HumiLife – The proven steam solution

Condair RH

2598849_A_EN_2005_Condair-RH_HOM

Humidification and Evaporative Cooling

Cautions and Warnings

Cautions and Warnings |22598849_A_EN_2005_Condair-RH_HOM Condair RH

CAUTION: Servicing

nThe unit is mains powered. Disconnect main power before any servicing.

nElectrical compartment contains high voltage components. Access should be limited to authorized personnel only.

nThe unit is hot. Wait for the unit to drain and cool before servicing. During and following operation of the humidifier,

the steam and components in contact with the steam such as the steam lines, steam distributors, and condensate

lines can become hot and can burn if touched.

nCondair does not accept any liability for installations of humidity equipment installed by unqualified personnel, or the

use of parts, components, or equipment that are not authorized or approved by Condair.

CAUTION: Electrical

nAll electrical work should be done according to all applicable local and national codes.

nElectrical connection to be performed by a licensed electrician.

CAUTION: Plumbing

n(Recommended) Plumbing to be performed by a licensed plumber.

nDrain water from the humidifier can be very hot. Drain to an appropriate floor drain.

nAll plumbing work should be done according to local plumbing code.

CAUTION: Installation

nDo NOT mount in area where freezing can occur.

nDo NOT mount on vibrating surface.

nDo NOT mount on the floor.

nDo NOT block the steam outlet.

n(Recommended) Install an air proving switch.

nDo install steam lines to prevent any restrictions that may cause back-pressure in the humidifier.

nEnsure furnace fan is operating while the humidifier is generating steam.

Thank you for choosing Condair

Condair RH 2598849_A_EN_2005_Condair-RH_HOM Thank you for choosing Condair |3

The Condair HumiLife RH is a residential steam humidifier designed by Condair. It is designed to

provide steady, clean humidification for the home, and is designed to connect to a supply air duct. The

humidifier may be mounted directly onto the duct, or remotely with connected steam hoses and

distributor.

This homeowner's manual provides a basic overview of the humidifier and its operation. Use of this

manual assumes that the Condair HumiLife RH is already installed. If the Condair HumiLife RH has not

been installed, refer to the quick start guide.

For more information, including troubleshooting, refer to the installation, and operation and

maintenance manuals available at www.condairhumilife.com.

Connecting to Condair HumiLife

Once the humidifier is mounted, and steam, water, drain, and wiring connections have been

established, you can turn on the unit and control it with the Condair HumiLife app on your mobile

device.

Downloading Condair HumiLife

Use your phone's camera or QR scanner to go to Google Play (Android) or the App Store (iOS).

Google Play (Android) App Store (iOS)

Connecting to Condair HumiLife

1. Download and install the Condair HumiLife app from the App Store or Google Play Store.

Ensure your mobile device is connected to your home Wifi network.

2. Turn on your humidifier (press and hold the power button for 2 seconds).

3. Open the Condair HumiLife app. You enter a screen allowing you to choose a humidifier to

connect. On the app, press Add Device. Your mobile device will begin to scan the area for the

Condair HumiLife RH.

4. On the humidifier, press and hold the power button for 5 seconds. The wireless light will

flash green. The humidifier will be discoverable to the app.

5. Follow the instructions in the Condair HumiLife app to finalize the connection.

6. The wireless light remains solid blue once completed. A red light indicates a disconnect.

User Interface

User Interface |42598849_A_EN_2005_Condair-RH_HOM Condair RH

The humidifier has a single button that turns the unit on/off, drains the cylinder, resets faults and

warnings, and connects to your wireless network.

The humidifier also has four LEDs that indicate the status of the humidifier

Description

Blue Humidifier is on (operational).

Fading (Blue) The unit is on standby. The humidifier will product steam when the humidity is lower than the

setpoint (defined in the Condair HumiLife app).

(Red) The unit is on standby. The humidifier is disabled through the Condair HumiLife app.

Blinking Security loop is open.

Red Humidifier is not on. It is still connected to the power supply.

Description

Blue Wifi/Cloud/Hostpot connection established.

Green Hotspot (AP) mode activated. The humidifier is connected to your phone.

Fading (Blue) The software in the humidifier is updating.

(Green) The humidifier is in Hotspot (AP)mode. The humidifier is attempting to connect to your

phone.

Red No Wifi connection .

Description

Blue Cylinder OK.

Blinking Cylinder is draining.

Fading Cylinder is filling. Appears on first fill cycle on a new cylinder.

Yellow Cylinder end of life approaching expiry. Replace soon.

Red Cylinder end of life reached.

Invalid cylinder installed.

Description

Yellow Warning: The humidifier will still operate, but requires maintenance.

Red Error: The humidifier stops operation to protect system components.

Understanding the Main Page

Condair RH 2598849_A_EN_2005_Condair-RH_HOM Understanding the Main Page |5

Swipe to show other

connected devices

View the humidity

level history

Enable or disable

humidification

Deactivating will put

the unit on standby

Opens the menu

Actual (relative)

Humidity

Move the slider* to

adjust your desired

humidity level

(setpoint)

Go to home screen

* Absence of slider indicates an installed external humidity controller. Change the settings on the controller

to change the setpoint.

Operation

Operation |62598849_A_EN_2005_Condair-RH_HOM Condair RH

Starting Up

IMPORTANT! Damaged or improperly installed units must NOT be operated. Damaged or improperly

installed units may present a danger to persons and property.

To turn on the humidifier:

1. See the below instructions if you are starting the humidifier for the first time.

Press the power button for 2 seconds. The unit will turn on. The unit will begin humidification

once it receives a demand for humidity.

Shutting Down

IMPORTANT! Shutting down the unit does not remove power from the unit. To remove power to the

unit, use the external disconnect switch.

To turn off the humidifier:

1. Press and hold the power button for 2 seconds.

lThe humidifier stops humidifying.

lThe cylinder drains (approximately 11 minutes).

Should the unit be disconnected for an extended period of time, allow the humidifier to drain and shut

down prior to disconnecting the power with the external disconnect. After removing power from the

humidifier, close the water supply valve.

Draining the Humidifier

To drain the humidifier:

1. Drain the cylinder by proceeding with the shut down sequence (refer to "Shutting Down" above).

Press and hold the power button for 2seconds.

Changing the Setpoint

Changing the setpoint of your HumiLife humidifier requires the Condair HumiLife app.

The ideal indoor humidity range is between 40% and 60%. To reach a particular humidity level, a

setpoint (or desired humidity) is determined for the humidifier. If the humidity of your home is lower than

the setpoint the humidifier will produce steam. It will continue to produce steam until the humidity in your

home reaches the setpoint.

To change the setpoint:

1. Open then Condair HumiLife app.

2. On the home screen, select your humidifier.

3. Move the humidity slider to your desired <%>.

4. Press the <Home> button to save your changes.

Resetting Faults and Warnings

Error and warning codes may be reset (active faults cleared), however, if the issue has not been

resolved, the warning or error code will return.

To reset the error/warning:

1. Press and hold the power button for 3 seconds.

Condair RH 2598849_A_EN_2005_Condair-RH_HOM Operation |7

Replacing the Cylinder

Replacing the Cylinder |82598849_A_EN_2005_Condair-RH_HOM Condair RH

IMPORTANT! Ensure that the new cylinder is free of damage or defects.

15min

99 °C

210 °F

“klik ”

Figure 1 - Removing the Cylinder (front panel removed for clarity)

Replacing the Cylinder: Warning/Fault

When the cylinder needs to be replaced, you will receive a notification on the Condair HumiLife and on

the humidifier ( and ). If the cylinder is not replaced within roughly 3 weeks, the warning notification

upgrades to a fault notification and the humidifier stops steam production.

Replacing the Cylinder:

1. Turn off the humidifier. The unit will fully drain in approximately 10 minutes and then enter Off

mode. The power LED will turn red. (Suggested) Wait an additional 5 minutes for the unit to cool.

2. Use the electrical disconnect to remove power from the humidifier.

3. Open the door to the humidifier. Pull the lever upwards. The lever will push the cylinder out. Pull

the cylinder out of the humidifier.

4. Replace the cylinder with a new one. Put the new cylinder into the humidifier and secure it with

the lever.

5. Restore power to the humidifier with the electrical disconnect.

6. Turn on the humidifier. Allow the cylinder to fill. The unit will go through a new cycle and will

automatically detect a new cylinder.

Condair RH 2598849_A_EN_2005_Condair-RH_HOM Replacing the Cylinder |9

Troubleshooting

Troubleshooting |10 2598849_A_EN_2005_Condair-RH_HOM Condair RH

General Troubleshooting

Condensation on the inside of windows.

Humidity is set too high nReduce the humidity setting on the humidifier.

Seals around window are broken nSeal any gaps between the window pane and the window.

Humidifier appears to have no power and nothing happens when the On/Off/Drain button

is pressed.

Electrical disconnect is engaged nDisengage the electrical disconnect to allow power to the

humidifier.

Incorrect wiring nEnsure all high-voltage (mains) wires are connected. Check

with a multimeter to register the connection between end

points.

nCheck if the switch mode power supply is functional.

nCheck if the 'heart beat' LED on the PCB is lit.

Humidifier will not humidify or is not reaching the relative humidity setpoint.

Humidity sensor is not working nCheck the voltage on the humidity sensor. If the Condair

sensor (supplied) is being used, 10 V indicates no demand,

and 0 V indicates full demand.

If another control device is used, refer to the manual of that

device.

nCheck the humidity setpoint on the humidifier. Ensure that the

setpoint is higher than the sensed humidity.

Humidistat terminals are not closed nCheck the voltage.

Safety loop open nCheck if there is 24 VAC at terminal "SC" (Safety Chain).

nCheck wiring and operation of On/Off devices connected to

"SC" terminals.

No demand signal nCheck the voltage between terminals GND and HUM. For

demand configuration 20% of full-scale signal must be present

for the humidifier to start.

Low conductivity water nThe cylinder includes a salt tablet that allows quick boil when

run for the first time on low conductivity water. The salt tablet

will be consumed and washed away after the first 20 minutes of

operation.

nA minimum inlet water conductivity of 125 µS/cm is required for

continuous operation.

nEnsure the supplied water is NOT reverse osmosis or

deionized water. Clean tap water (or potable) is acceptable.

Andere Handbücher für HumiLife RH Series

Inhaltsverzeichnis

Andere Condair Luftbefeuchter Handbücher

Condair

Condair ML Series Bedienungsanleitung

Condair

Condair RS series Bedienungsanleitung

Condair

Condair Control GS-C Series Bedienungsanleitung

Condair

Condair Nortec GS II Series Bedienungsanleitung

Condair

Condair ME series Bedienungsanleitung

Condair

Condair MD Series Installations- und Betriebshandbuch

Condair

Condair 505 Bedienungsanleitung

Condair

Condair RH Series Bedienungsanleitung

Condair

Condair DL Bedienungsanleitung

Condair

Condair HP Series Bedienungsanleitung

Condair

Condair HumiLife RH Series Bedienungsanleitung

Condair

Condair ABS3 Bedienungsanleitung

Condair

Condair HP Bedienungsanleitung

Condair

Condair ME series Montage- und Bedienungsanleitung

Condair

Condair HumiLife RE Series Bedienungsanleitung

Condair

Condair Nortec EL-Series Installations- und Betriebshandbuch

Condair

Condair Nortec GS II Series Bedienungsanleitung

Condair

Condair US Series Bedienungsanleitung

Condair

Condair CP3MINI Bedienungsanleitung

Condair

Condair DL Series Bedienungsanleitung

Condair

Condair RH Series Bedienungsanleitung

Condair

Condair Links Series Bedienungsanleitung

Condair

Condair MD Series Technisches Handbuch

Condair

Condair TE Series Bedienungsanleitung

Beliebte Luftbefeuchter Handbücher anderer Marken

Bionaire

Bionaire CM1 Handbuch

Air-O-Swiss

Air-O-Swiss AOS 7131 Handbuch

KING

KING K 5002 Rainbow Bedienungsanleitung

Crane

Crane EE-6902 Bedienungsanleitung

Glaziar

Glaziar Ness Bedienungsanleitung

Philips

Philips DreamStation Go Abmessungen

Honeywell

Honeywell MISTMATE HUL520BC Bedienungsanleitung

Stadler Form

Stadler Form Hera Bedienungsanleitung

Hunter

Hunter 31206 Bedienungsanleitung

TaoTronics

TaoTronics TT-AH004 Bedienungsanleitung

adorini

adorini Cigar Heaven Bedienungsanleitung

Lanaform

Lanaform Aroma Bedienungsanleitung

Aprilaire

Aprilaire 800 Series Bedienungsanleitung

Pyle

Pyle SereneLife PHUMDIF8 Bedienungsanleitung

Trotec

Trotec B 200 Bedienungsanleitung

Pure Humidifier

Pure Humidifier EC Series Bedienungsanleitung

Crane

Crane EE-864 Bedienungsanleitung

air&me

air&me Solnan Bedienungsanleitung