ConeMount B Bedienungsanleitung
Model B Bearing Heater Instructions
General:
Carefully unpack your ConeMount Bearing Heater and remove all packaging materials and
wrappings.
1. Always wear heavy safety gloves to avoid risk of burn or shock
2. Remove the Cone Safety Guard from the ConeMount Bearing Heater.
3. Place the bearing or gear to be heated on the cone of the ConeMount Bearing
Heater
4. Mark the inner race of the bearing or gear with the temperature crayon which is
provided.
5. Plug the ConeMount Bearing Heater into an electrical outlet of correct voltage.
6. Turn the switch on the power cord to the “ON” position.
7. When the crayon mark melts the bearing or gear is ready for mounting.
8. Turn the switch on the cord to the “OFF” position.
9. Disconnect the cord from the electrical outlet.
10. Replace the Cone Safety Guard over the ConeMount Bearing Heater to warn of
possible high temperatures.
**NOTE –The ConeMount Bearing Heater is not recommended for continuous use.
Bearings in excess of 100lbs should be supported on the outer race to prevent damage to
the cone unit.
Care:
Periodically, wipe the cool unit with a clean, dry, soft cloth to remove possible dirt or
grease residue. The thermostat should be gently cleaned to assure proper calibration.
IMPORTANT SAFETY INSTRUCTIONS:
1. DRESS PROPERLY. Always wear heavy safety gloves to avoid risk of burn or
shock.
2. AVOID DANGEROUS ENVIRONMENTAL CONDITIONS. Do not use the
ConeMount Bearing Heater in damp or wet locations, in or around water.
3. DO NO OPERATE the ConeMount Bearing Heater in gaseous or explosive
atmospheres, around combustible or flammable liquids, or hazardous
materials.
4. DO NOT OPERATE the ConeMount Bearing Heater on any surface which may
burn. Always place the unit on a flat surface for use.
5. DO NOT leave unit unattended
6. DISCONNECT TOOL. Always disconnect the power cord from the wall receptacle
when the unit is not in use.
7. USE THE RIGHT TOOL. Do not use the ConeMount Bearing Heater for any job
except that for which it is intended.
8. DON’T ABUSE CORD. Do not yank the power cord from the wall receptacle.
Keep cord from heat, oil and sharp edges. Do not operate unit if power cord or
plug show signs of damage.
9. WARNING: Keep unit dry, clean, and free from oil and grease. Keep work area
clean.
10. SAVE THESE INSTRUCTIONS.
Inhaltsverzeichnis
Andere ConeMount Heizung Handbücher
Beliebte Heizung Handbücher anderer Marken
Empire Heating Systems
Empire Heating Systems WCC65 Bedienungsanleitung
Wetekom
Wetekom 92 86 43 Bedienungsanleitung
Desa
Desa SPC170-F Bedienungsanleitung
Watlow
Watlow Watrod Electric Tubular Heaters Bedienungsanleitung
Haverland
Haverland ECO-DRY GPS Series Stücklistenhandbuch
Stelpro
Stelpro ASILVC2060 Series Bedienungsanleitung