7
✔The first time you use your
Refrigerator, it is most likely that
there is air in the gas lines. However,
keep the selector valve button
pressed for 1 or 2 minutes, and use
the ignite button every 3 to 5
seconds until the flame is ignited.
✔Keep the selector valve button
pressend for 5 seconds.
If the flame goes out when the
button is released, repeat the
operation.
Keeping the selector valve button
pressed for 10 seconds and check to
see if the flame remains lit after
your release the button.
✔If there are any problems doing this,
see the section on Troubleshooting,
on page 15.
✔To test the operation of the
appliance, use the following
procedures.
Testing Operation
For your own safety and that of the
appliance, it is fundamental that you
perform the tests described below,
immediately after your first turn on the
appliance.
ATTENTION
When trying to light the flame, press
the selector valve button for more
than 10 seconds.
✔The Refrigerator must be turned on
and without the protection hood on
the back (if the protection hood is
still in place and the Refrigerator
turned on, turn it off and remove
the hood.
Be careful, as the hood could be
very hot.
Turn the Refrigerator back on).
✔Let the Refrigerator operate for at
least 30 minutes, during this time
check if there is any gas leakage.
Check each connection from the
source to the gas injector using a
mixture of detergent and water.
✔Check that the flame does not
touch the heat deflector (the curved
metal part located inside the
heating pipe). It normally is slightly
incandescent.
✔Check the flame, comparing it with
that in ilustration.
The blue flame should be 10 to
15 mm in height and be very close
to the burner screen, without any
extra large areas of flame.
