The fan does not fit Contura 580.
Unpack and check the contents. Follow the procedures in the instructions for the
stove and install the top and sides of the stove. Also remove the knockout in the
stove’s back panel before starting the fan installation. Remove the heat deflector
that is installed under the heart, it is not required when the fan is installed.
For the air supply connection from the outside, a distance of 75 mm is required
between the condensation insulation and the heart. This is to make space for the
fan. Ensure that the hose clamp is turned forwards.
Parts supplied
25 mm
Existing plinth panels of older types need 25 mm to be cut
at each end of the clamp strip as illustrated.
Screws M6 x 20, 1 pcs
Screws M6 x 8, 2 pcs
Vibration dampers, 2 pcs
Nut M6, 2 pcs
Mounting plate Flow guide
Fan Left and right pipe
Read through the entire installation instruction before installing the fan. The fan is
installed under the heart and the installation is usually concealed by a plinth. The plinth is
a separate accessory. The fan increases the heating from the stove and makes the air in
the room circulate which gives better heat distribution and a more even temperature.
Preparations
General
The fan is powered by 230V, ignoring the instructions is potentially lethal. The fan or
its components must not be worked on. Impacts on the cable sheaths are potentially
lethal. If there is a fault in the fan it must be returned to the place of purchase.
Clamp strip
Blind plug, 2 pcs
!
!
This appliance may be used by children over the age of 8 years, by persons with reduced physical, sensory or mental
capabilities and by persons with a lack of experience or knowledge provided that they are supervised and have been
instructed how to use the appliance in a safe way and they understand the hazards involved. Children must not
play with the appliance. Children must not clean or carry out maintenance on the appliance unless they are being
supervised.
GB
8
