A
B
C
Ø10mm
Ø10mm
Ø20mm
Step 2
Mount the luminaire (A) and feed the cable through the grommet provided
(B) and secure into the cable retaining clip (C) on the bracket.
Step 3
Mount the power supply enclosure to the wall mount bracket using the
four M8 nylock nuts and washers.
Step 4
Feed the cables through the cable glands and connect as shown below,
making sure polarities are adhered to. Once the cables are positioned as
required secure the cable gland nut sufciently for an adequately
sealed connection.
Step 5
The power supply enclosure can now be closed and secured using the eight
M6x20 hexagonal cap screws.
Page 2 / 2
MOUNTING INSTRUCTIONS
Step 1
Mount the wall bracket using the slots provided
240 VAC
Cable from luminaire
-
+N E L
N L
- +
WARDEN LED LUMINAIRE MANUAL EDITION 0.5
Nord lock washer &
Nylock nut
M10x25 hex head bolt &
M10 at washer
Page
2
/
2
[email protected] •
aus. 1300
287
533
•
intl. +613
8681
3633
•
www
.coolon.com.au
Product must be installed by a suitably qualied person. All documentation is subject to change without notice. Refer to our website for the latest information.
www.coolon.com.au
