Cooper Security I-SD01 Installationsanleitung

I-SD01

Speech Dialler

Installation and

Programming Guide

Page 2

Introduction

The I-SD01 module is designed to fit on the I-ON16 control unit.

The I-SD01 allows the control unit to report alarm conditions over

the public switched telephone network (PSTN) using either recorded

speech messages, or SMS (Short Message Service) texts to mobile

telephones by way of the PSTN.

Installation

Preparation

Before fitting the I-SD01 module, check whether the telephone line

you intend to use is shared with an ADSL (broadband) modem. If it

is, then fit filter ADSL01 as shown in Figure 1 .

ADSL01

Figure 1. Fitting ADSL01 to I-SD01

Note: If the telephone line is NOT shared with an ADSL modem

then leave the factory fitted jumpers in place.

Recording Voice Messages

The microphone for recording speech messages is on the I-SD01

module, as well as a small speaker that allows you to playback the

messages.

If you intend to record speech messages, and the user’s keypad is

already fixed at some distance from the central station, you may

wish to temporarily connect a second keypad to the end station.

This will enable you to program the system and easily

record/playback any speech messages.

Page 3

Installing the Module in the End Station

1. Remove mains power from the end station.

2. Open the end station lid and disconnect the battery.

3. Fit the I-SD01 to the plug on module sockets (see Figure 2).

Figure 2. Fitting I-SD01 Module

4. Connect the module to the PSTN.

The person connecting the I-SD01 module to the PSTN must be

suitably qualified. Connect the I-SD01 telephone connector (see

Figure 3) ONLY to the PSTN or to other circuits designated as

Telecommunications Network Voltage.

ABCEA1B1

See Note

PSTN

Warning: Telecommunications Network Voltage

A, B Connect to PSTN

A1, B1 Connect to local phone extension (if required)

E For added surge protection connect to a suitable protective earth.

C Note: (UK only) connect to ringing wire from PSTN and to ringing wire on extension

phone, if fitted.

Figure 3. Telephone Connection

Page 4

5. If necessary, temporarily connect a keypad.

5. Reconnect the battery.

6. Apply mains power.

Programming

For details on programming the I-SD01 please refer to the

I-ON16 Installation and Programming Guide. All the options

necessary for programming the module are in the Installer Menu

under the Reporting option.

Note: The control unit hides the Reporting option if there is no I-

SD01 fitted.

Finishing the Installation

Once programming is complete:

If you connected a temporary keypad earlier, then remove all

power (mains and battery) before disconnecting the keypad. Re-

apply mains and battery power afterwards.

NOTE: If you enabled the end station tamper switch to

control speech recording and playback then remember to

disable it BEFORE fitting the end station lid.

Re-fit the lid of the end station.

Test the module using the options in the Installer Menu - Testing

option.

Every effort has been made to ensure that the contents of this book are correct. However,

neither the authors nor Cooper Security Limited accept any liability for loss or damage caused

or alleged to be caused directly or indirectly by this book. The contents of this book are subject

to change without notice.

Printed and published in the U.K.

This manual applies to software used in the I-ON16 control unit with version 1.xx.xx software.

www.coopersecurity.co.uk

Product Support (UK) Tel: +44 (0) 870 757 5400.

Available between:

08:15 and 17:00 Monday to Friday.

Product Support Fax: (01594) 545401

Part Number 11847980 Issue 1

Inhaltsverzeichnis

Andere Cooper Security Sicherheitssystem Handbücher

Cooper Security

Cooper Security i-On 40 Betriebsanleitung

Cooper Security

Cooper Security i-on16 Installationsanleitung

Cooper Security

Cooper Security FOB-2W-4B Bedienungsanleitung

Cooper Security

Cooper Security i-On 40 Bedienungsanleitung

Cooper Security

Cooper Security Scantronic 770r Bedienungsanleitung

Cooper Security

Cooper Security i-on30EX Bedienungsanleitung

Cooper Security

Cooper Security i-On 40 Bedienungsanleitung

Cooper Security

Cooper Security i-On 40 Service-Handbuch

Cooper Security

Cooper Security i-On 40 Service-Handbuch

Cooper Security

Cooper Security 9940 Bedienungsanleitung

Cooper Security

Cooper Security Homelink 75 Bedienungsanleitung

Cooper Security

Cooper Security M-Series Bedienungsanleitung

Cooper Security

Cooper Security 9651PD Bedienungsanleitung

Cooper Security

Cooper Security i-On 40 Bedienungsanleitung

Cooper Security

Cooper Security Menvier300 Bedienungsanleitung

Cooper Security

Cooper Security Homelink55 Bedienungsanleitung

Cooper Security

Cooper Security i-on160EX Bedienungsanleitung

Cooper Security

Cooper Security i-on16 Bedienungsanleitung

Cooper Security

Cooper Security i-on160EX Bedienungsanleitung

Cooper Security

Cooper Security M-Series Installations- und Betriebshandbuch

Cooper Security

Cooper Security Homelink 75 Bedienungsanleitung

Cooper Security

Cooper Security Scantronic 9853 Bedienungsanleitung

Cooper Security

Cooper Security i-On 40 Bedienungsanleitung

Cooper Security

Cooper Security Homelink 75 Service-Handbuch

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

CADDX

CADDX NX-6 Bedienungsanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

Blaupunkt

Blaupunkt SA 2700 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Highway Safety Group

Highway Safety Group EA401 Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung