Cornelius 318569000 Bedienungsanleitung

EIMI Cornelius Inc; 1999–2003

February 9, 1999

569000261

Revised: October 9, 2003

IMI CORNELIUS INC gOne Cornelius Place gAnoka, MN 55303-6234

Telephone (800) 238-3600 Facsimile (800) 535-4231

INSTALLATION INSTRUCTIONS

DISPENSING VALVES KEYED LOCK-OUT SWITCH KIT (P/N 569000262)

VANTAGE POST-MIX DISPENSERS

Read and understand these instructions thoroughly before installing this Dispensing Valves Keyed Lock-out

Switch Kit (P/N 569000262) on the Post-Mix Dispensers. The purpose of the Keyed Lock-Out Switch is to shut

off electrical power to the dispensing valves to prevent dispensing of product. Retain these instructions as part

of your equipment manual.

LOOSE-SHIPPED PARTS

Note: Only qualified personnel should install this Kit.

Unpack and inspect kit. Make sure items are present and in good condition.

Table 1. Loose-Shipped Parts

Item

No. Part No. Name Qty

1 560003869 Wiring Harness 1

2 560003870 Template, Hole Drilling 1

3 318948000 Lock Key 1

4 318949000 Hex Nut 1

5 318569000 Key-Lock Switch 1

6 569000261 Installation Instructions 1

KIT INSTALLATION

WARNING: To avoid possible fatal electrical shock or serious injury to Installer, make sure

Dispenser is disconneced from power source before attempting to install this kit.

1. Disconnect electrical power from the Dispenser

2. Remove hood from the Dispenser, then lift hood straight up off the Dispenser for access to the transformer

on the refrigeration deck.

3. Refer to Figure 1 for location of hole to be drilled in the Dispenser hood for installation of the KEY-LOCK

SWITCH (item 5).

4. Place TEMPLATE, HOLE DRILLING (item 2) in position on Dispenser hood as shown in Figure 1.

5. Drill hole in Dispenser hood as indicated on the hole drilling template, then remove template from the hood.

569000261

1.50

TEMPLATE

(ITEM 2)

HOOD

LOCK KEY

(ITEM 3)

KEY-LOCK SWITCH

(ITEM 5)

HEX NUT

(ITEM 4)

FIGURE 1. DISPENSER HOOD

6. Install KEY-LOCK SWITCH (item 5) in the hood as shown in Figure 1 and secure with HEX NUT (item 4).

7. Refering to Wiring Diagram (Figure 2) disconnect black electrical wire, with push-on terminal on it’s end,

from terminal on the transformer outlet.

8. Connect black electrical wire, disconnected from the transformer outlet terminal, to mating electrical wire

terminal on the WIRING HARNESS (item 1).

9. Connect other electrical wire of the wiring harness to output terminal on the transformer where the black

electrical wire was disconnected from in step 7 preceding.

10. Connect other two wiring harness terminals to two terminals on the Key-Lock Switch.

11. Install hood on the Dispenser.

12. Connect electrical power to the Dispenser, then check Dispenser for proper operation.

13. Insert LOCK KEY (item 3) in key-lock switch, then check Dispenser for proper operation.

KEY-LOCK SWITCH

(ITEM 5 )

WHITE

BLACK

MATING

TERMINALS

FIGURE 2. WIRING DIAGRAM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Cornelius Spender Handbücher

Cornelius

Cornelius essense Bedienungsanleitung

Cornelius

Cornelius Jetspray JT20-W25 Bedienungsanleitung

Cornelius

Cornelius IDC Pro255 Bedienungsanleitung

Cornelius

Cornelius pbd175 Bedienungsanleitung

Cornelius

Cornelius VIPER Bedienungsanleitung

Cornelius

Cornelius DF250 Bedienungsanleitung

Cornelius

Cornelius QUEST ELITE QLT 2000 Handbuch

Cornelius

Cornelius ICE-COOLED CHEST-A-FIELD DISPENSER Bedienungsanleitung

Cornelius

Cornelius ED 300 BC Bedienungsanleitung

Cornelius

Cornelius Nueva Tower Handbuch

Cornelius

Cornelius Enduro/Duraflex Stand 175 Bedienungsanleitung

Cornelius

Cornelius Vitalize430 Bedienerhandbuch

Cornelius

Cornelius FlavorFusion Bedienungsanleitung

Cornelius

Cornelius PearlMini Bedienungsanleitung

Cornelius

Cornelius Quest Elite 2000 Bedienungsanleitung

Cornelius

Cornelius In-N-Out Burger NGF 255 Bedienungsanleitung

Cornelius

Cornelius FCB OVERCOUNTER POST-MIX DISPENSER Bedienungsanleitung

Cornelius

Cornelius Flavor OverLoad CG5017-1007 Bedienungsanleitung

Cornelius

Cornelius Jetspray JT20 Bedienungsanleitung

Cornelius

Cornelius VIPER (E) 2 FLAVOR Bedienungsanleitung

Cornelius

Cornelius QUEST ELITE 2 FLAVOR Bedienungsanleitung

Cornelius

Cornelius IDC 255 PROGATE DRIVE THRU UNIT Bedienungsanleitung

Cornelius

Cornelius IDC Pro Leitfaden

Cornelius

Cornelius 2 Flavor Post-Mix Cold Coffee Dispenser Quest... Bedienungsanleitung

Beliebte Spender Handbücher anderer Marken

Silver King

Silver King Majestic SK12MAJ Kurzanleitung

Franke

Franke F3Dn Twin Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON UltraHot Plus Bedienungsanleitung

DAN DRYER

DAN DRYER 282 Bedienungsanleitung

Essity

Essity Tork 473208 Bedienungsanleitung

CBS

CBS SD300BU-88 Einrichtungshandbuch

Sealey

Sealey MK77 Bedienungsanleitung

Fluid Management

Fluid Management Accutinter 1600 Bedienungsanleitung

Franke

Franke DVS SD99-010 Bedienungsanleitung

Graco

Graco Dispensit 1053-10C Fehlerbehebungshandbuch

ITALTINTO

ITALTINTO i50 Bedienungsanleitung

Coca-Cola

Coca-Cola FREESTYLE 9000 Bedienungsanleitung

Graco

Graco ProMix 2KE Bedienungsanleitung

TECHCON SYSTEMS

TECHCON SYSTEMS TS1251 Bedienungsanleitung

Wayne

Wayne GLOBAL VISTA CNG Bedienungsanleitung

clarsen

clarsen H133 Bedienungsanleitung

PicoBrew

PicoBrew Zymatic Bedienungsanleitung

BOWMAN

BOWMAN BP-007 Bedienungsanleitung