WARNING: Do not move or remove the mesh trim panel when the
appliance is plugged in and operating. This will cause the remote control
and touch panel to no longer function.
NOTICE: When the heater is first turned on, a slight odor may be present.
This is normal and should not occur again unless the heater is not used for
a long period of time.
NOTICE: To improve operation, aim the remote control at the front of the
fireplace. DO NOT press the buttons too quickly. Give the unit time to
respond to each command.
★Move the battery's transparent insulating piece away before using.
5.3 REMOTE CONTROLN
6.0 TROUBLE SHOOTING GUIDE
POWER
DIMMER
TIMER
HEATER
COLOR A
COLOR B
FLAME
SPPED
Turn the appliance ON/OFF.
NOTE: Make sure the main switch on the top of fireplace is
turned on before operating.
Control the Timer.
8 Settings: (1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h,9h,10h,11h,12h)
Press button until reach desired setting.
Control Flame speed.
5 Settings: (V1-V2-V3-V4-V5) Flame speed from V1 to V5. V5
is the largest setting
Control the Heater.
Press button to initiate the heater.
(OFF) no heater or blower.
(-), heater blows warm air(750 W)
(--), heater blows hot air(1500 W)
NOTE: Heater functions cycle from (OFF) (-)(--)
Control the flame color.
12 Settings: 1. red 2. yellow 3. blue 4. orange 5. red & yellow 6.
red & blue7. orange & blue 8. yellow & blue 9. yellow & orange
10. blue & white 11. red & yellow & blue 12. multi color.
NOTE: When you press the button for 6 seconds until you hear
a beep, the indicator will show digital "O", the flame color and
brightness will be changed automatically.
Control the flame bed color.
12 Settings: 1. red 2. gentian blue 3. green 4. pink 5. yellow 6.
cyan 7.
purple 8. white 9. saffron 10. sky blue 11. verdant 12. Capri blue
NOTE: When you press the button for 6 seconds until you hear
a beep, the indicator will show digital "O", the flame color and
brightness will be changed automatically.
Control Flame brightness.
5 Settings: (L1-L2-L3-L4-L5) Flame dims from L1 to L5. L5 is
the brightest setting.
NOTE: Long-press the "DIMMER" button for 6 seconds, the
appliance will go into sleep mode. All the lights off, the heating
function goes on.
Long-press for 6 seconds again, the appliance will back to
normal mode.
Battery (CR 2025)
PROBLEM SOLUTION
The mounting bracket
cannot be removed
1. The mounting bracket is pre-attached. Unscrew the
two screws at both sides of the fireplace by Phillips
screw driver, then remove the pre-attached mounting
bracket.
2. If the problem is still not solved, please contact us via
Amazon Message or message.
The mounting bracket
cannot be removed
1. Make sure the Power Switch on the control panel is
turned on before operation.
2. Make sure you have reconnected the data cable
which was pull out when you removed the glass frame.
3. If the problem is still not solved, please contact us via
Amazon Message.
Sudden power outage
during the heating
process
1. Don't cover the air outlet.
2. Unplug the plug, wait for 10 minutes and try to open it
again.
3. If the problem is still not solved, please contact us via
Amazon Message.
Battery Holder
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for
recycling advice in your
area.
18 19
