LIGHTING INSTRUCTIONS
WARNING: For your safety, read and follow the Lighting Instructions
in this manual and in the Rating Plate on the appliance. IMPROPER
LIGHTING PROCEDURES COULD RESULT IN A FIRE HAZARD OR
EXPLOSION HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF
LIFE.
To perform a leak test:
1. Make 2~3 oz. of leak solution by mixing one part of liquid
dishwasher detergent and three parts of water. Noted: make sure
control knob is “OFF”.
2. Apply several drops of solution where the cylinder attaches to
regulator, (see Figure 7), inspect the solution at the connection
looking for bubbles. If NO bubbles appear, the connection is secure.
If bubbles appear, the connection has the leak, disconnect the
regulator, reconnect, perform another leak check. If you continue
to see bubbles after several attempts, cylinder valve is defective
and should be returned to cylinder’s supplier.
3. Apply several drops of solution where gas valve attaches to
bellows, (see Figure 8), where gas valve attaches to regulator
hose, (see Figure 9), and where inlet tube attaches to bellows,
(see Figure 10). If NO bubbles appear, the connections are secure.
If bubbles appear, the connection has the leak, disconnect,
reconnect, perform another leak check. If you continue to see
bubbles after several attempts, both parts are defective and should
be replaced with the new ones.
1. Push in gas control knob slightly and turn to “OFF”.
2. Turn gas control knob to “ON/MIN”.
3. Push in gas control knob all the way and hold. Continue to press
the ignition button for 15 seconds.
4. If the burner does not light in 15 seconds, release the knob and it
will pop back out. Wait 5 minutes before attempting to light the
burner again and repeat step 1 to 3.
TO TURN OFF GAS
1. Push in gas control knob slightly and turn to “OFF”.
gas valve / regulator
hose connection
(Figure 9)
inlet tube / bellows
connection
(Figure 10)
gas control knob
ignition button
1 AAA
1.5V
IGNITOR
( Encendedor )
OFF (APG.)
MAX
(MÁX.)
ON/MIN
(ENC./MÍN.)
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and turn to “OFF”.
2. Turn gas control knob to “ON/MIN”.
3. Push in gas control knob all the wayand hold.
Continue to press the ignition button for 15
seconds.
4. If the burner does not light in 15 seconds,
release the knob and it will pop back out.
Wait 5 minutes before attempting to light
the burner again, repeat step 1 to 3.
TO TURN OFF GAS
1. Push in gas control knob slightly and turn
to “OFF”.
PARA CERRAR EL GAS
1. Presione ligeramente la perilla de control del gas y gírela a la
posición “APG” (apagado)
INSTRUCCIONES DE ENCENDIDO
1. Presione ligeramente la perilla de control del gas y
gírela a la posición “APG” (apagado).
2. Gire la perilla de control del gas a “ENC/MÍN”(encendido/mínimo).
3. Presione la perilla de control del gas hasta el fondo y mantenga
presionada.
Siga presionando el botón de encendido durante 15 segundos.
4. Si el quemador no se enciende en 15 segundos, suelte la
perilla y esta volverá a su posición hacia afuera. Espere 5
minutos antes de intentar encender el quemador
nuevamente, repita los pasos 1 al 3.
Figure 11
14 15
