4
SAFETY PROCEDURES
BEFORE USE:
•Read through the owner’s manual. Follow instructions CAREFULLY.
•NEVER use a wet area. Electric shock could occur.
•Use a GROUNDED outlet and a GROUNDED circuit. Do no use ungrounded
equipment on the same circuit.
•Always use a dedicated line. DO NOT use with line splitting surge protector.
DURING USE:
•Keep fingers and hands away from score blades, perf blades, and rubber
rollers.
•Keep cords clear of moving parts.
AFTER USE:
•Turn off machine at the side panel, then unplug the main power cord. This
will prevent damage to your machine by power/voltage spikes.
•To unplug cords, always grasp the plug body, never pull on cords to
disconnect. Wire fatigue and possible shock could result from improper
disconnect procedures.
BE ALERT! BE CAREFUL!
CARE AND MAINTENANCE
The PERFMASTER AIR V2 is a precision machine. It is very important to keep it free of
excessive dust, dirt and foreign matter. We recommend that you keep the machine
covered when not in use.
BEARINGS/BUSHINGS: The bearings are sealed roller bearings and are designed to
be self lubricating, however dirt and dust can get into them causing clogging and dirt
build up. It is recommended to oil them daily under heavy use or monthly under light
use. The Bushings are Bronze and do require lubrication more frequently. Oil these
once a week under heavy use.
RUBBER ROLLERS: These tend to harden when exposed, and in use, use “water to
clean them before and after each use. This will increase the life and require less
replacement. “Do not use Blanket Wash or Other Cleaners.”
REMOVEABLE SCREWS: When these show signs of wear or stripping, replace as soon
as possible. If these strip or hollow out they can be costly to remove. If you do keep
your Perfmaster Air V2 clean and in top condition, it will give you years of service.
