Craig CHT912 Bedienungsanleitung

Bluetooth Sound Bar with Built-In Subwoofer

CHT912

INSTRUCTION MANUAL

WARNING:Changes or modifications to this unit

not expressly approved by the party responsible

for compliance could void the user’s authority to

operate the equipment.

NOTE: This equipment has been tested and

found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful interference

in a residential installation. This equipment

generates, uses, and can radiate radio frequency

energy and, if not installed and used in

accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause harmful interference to

radio or television reception, which can be

determined by turning the equipment off and on,

the user is encouraged to try to correct the

interference by one or more of the following

measures:

•Reorient or relocate the receiving antenna.

Increase the separation between the

equipment and receiver.

Connect the equipment into an outlet on a

circuit different from that to which the receiver

is connected.

Consult the dealer or an experienced radio/TV

technician for help.

•

FCC Warnings

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment.

This transmitter must not be collocated or operating

in conjunction with any other antenna or transmitter

unless authorized to do so by the FCC.

AC/DC adapter

1. Placing on the table

Ventilation

When placing the Sound Bar on an entertainment center, bookshelf, or any type of

enclosed space, be sure to allow at least 2-3 inches of space around the Sound Bar

for ventilation. If the Sound Bar is enclosed in a tight space, without ventilation, heat

generated from the Sound Bar could produce a potential heat hazard.

2. Mounting the Speaker Bar onto a wall

We recommend having this speaker professionally mounted. By using the included

wall mounting accessories, the sound bar can be mounted onto a wall.

Distance Between Two Brackets

2.1. Mounting on the wooden wall

You should use

2 pieces of short screws 2 pieces of EVA

You will need :

• Level

• Pencil

• Tape Measure

• Manual or Electric drill

1. Use the TAPE MEASURE to decide how high you’d like to hang the sound bar on

the wall. The sound bar must be hung within 5 feet of an AC power outlet for the

attached AC power cord to reach.

2. Mark the position of the mounting screws on the wall using a pencil.

3. Line the LEVEL up on both of your mark sure they are level. If they're not, adjust the

marks as needed to make them level.

4. After you've double checked your marks, drill through the EVA with screw directly

into the marks that you have made on the wall.

5. Use the LEVEL to check that the mounting screws are level.

6. Put the sound bar onto the mounting brackets, and make sure there is a firm and

stable connection before letting go of the sound bar.

7. Finally, use the LEVEL to confirm that the sound bar is level.

2.2. Mounting on the dry wall

2 pieces of plastic tubes

You should use

2 pieces of short screws

2 pieces of EVA

8VHWKH7$3(0($685(WRGHFLGHKRZKLJK\RXƍGOLNHWRKDQJWKH6SHDNHU%DU

RQWKHZDOO7KH6281'%DUPXVWEHKXQJZLWKLQIHHWRIDQ$&SRZHURXWOHWIRU

WKHDWWDFKHG$&SRZHUFRUGWRUHDFK

0DUNWKHSRVLWLRQRIWKHPRXQWLQJVFUHZVRQWKHZDOOXVLQJDSHQFLO

/LQHWKH/(9(/XSRQERWKRI\RXUPDUNVXUHWKH\DUHOHYHO,IWKH\UHQRWDGMXVW

WKHPDUNVDVQHHGHGWRPDNHWKHPOHYHO

'ULOODKROHE\DSRZHUIXOHOHFWULFGULOO

8VHDKDPPHUJHQWO\QDLOSODVWLFWXEVLQWRWKHKROHV

'ULOOWKURXJKWKH(9$ZLWKVFUHZVGLUHFWO\LQWRWKHKROHV

8VHWKH/(9(/WRFKHFNWKDWWKHPRXQWLQJVFUHZVDUHOHYHO

3XWWKH6281'%DURQWRWKHPRXQWLQJEUDFNHWVDQGPDNHVXUHWKHUHLVDILUPDQG

VWDEOHFRQQHFWLRQEHIRUHOHWWLQJJRRIWKH6RXQG%DU

)LQDOO\XVHWKH/(9(/WRFRQILUPWKDWWKH6RXQG%DULVOHYHO

(1) (2)



1. REMOTE SENSOR: Ensure this area is not covered or blocked by any object.

2. STANDBY button: Press to turn the speaker bar off or on.

3. SOURCE button: Press to switch between Bluetooth receiver, AUX, LINE in and FM.

4. VOLUME +: Press to increase the volume.

5. VOLUME -: Press to decrease the volume

6. MUTE: Press to mute the volume.

7. STANDBY Indicator.

8. FM Indicator.

9. Bluetooth Indicator.

10. AUX Indicator.

11. LINE IN Indicator.

12. FM antenna port.

13. AUX L/R IN: To insert RCA cable.

14. LINE IN jack: To insert LINE in cable.

15. DC jack in.

16. Mounting bracket.

1. STANDBY button: Press to turn the unit on or off.

2. BT button: Press to switch to Bluetooth mode.

3. SCAN button: Press to scan for available radio stations in FM Radio mode.

4. MUSIC button: Press to switch to the EQ optimized for music.

5. TREBLE button: Press to adjust the treble up or down.

5. VOL- button: Press to decrease the volume.

6. AUX button: Press to switch to AUX mode.

7. MUTE button: Press to mute the volume.

8. LINE button: Press to switch to LINE In mode.

9. FM button: Press to switch to FM Radio mode.

10. CHANNEL + button: Press to adjust the channel up.

11. CHANNEL - button: Press to adjust the channel down.

12. MOVIE button: Press to switch to the EQ optimized for movie sound.

13. VOICE button: Press to switch to the EQ optimized for dialogue.

14. BASS button: Press to adjust the bass up or down.

15. VOLUME button: Press to adjust the volume.

1. It includes one 2025 button cell battery.

(pre-installed)

2. Removes the transparent sheet.

PUSH

OPEN

CR2025

PUSH

OPEN

Lithium Cell

CR2025

SC UL

Lithium Cell

CR2025

SC UL

Audio Inputs

(1) Using the Stereo RCA Inputs

Before use, disconnect any cables connected to the LINE IN.

1. Connect the RCA Cable to the RCA Stereo Inputs located on the back of the unit,

and to the audio outputs on the television.

2. Press the STANDBY button to power on the unit.

3. Press the AUX button on the remote or SOURCE button on the unit repeatedly to

enter aux mode.

4. Audio played through the television will now be heard through the speakers.

When connecting two products using an RCA Cable, match the colored ports with the

same colored connection.

1. Plug one end of a 3.5 mm audio input cable into the LINE IN on the unit.

Before use, disconnect any cables connected to the Stereo RCA Inputs.

2. Plug the other end of the cable into the audio output /headphone output on an

MP3 Player or other audio source.

3. Press the STANDBY button to power the unit on.

4. Press the LINE button on the remote or SOURCE button on the unit repeatedly to

enter line in mode.

5. Audio played through the connected device will now be heard through the speakers.

1. Switch on the sound bar and select BT on the remote or SOURCE button on the unit

repeatedly to select bluetooth function.

2. Bluetooth blue LED indicator will flash and blink. Turn on your device, such as iPod,

iPhone, iPAD, tablets and mobiles etc, with bluetooth transmitters to search for the

sound bar.

3. When your device have successfully searched for the sound bar, it will show the name

of CHT912. Enter the default password "0000" to pair with.

(2) Using the LINE IN

LISTEN WITH BLUETOOTH RECEIVER

Andere Handbücher für CHT912

Inhaltsverzeichnis

Andere Craig Sprecher Handbücher

Craig

Craig CHT820DG Bedienungsanleitung

Craig

Craig CMA3546BT Bedienungsanleitung

Craig

Craig CMA3576 Bedienungsanleitung

Craig

Craig cma3561 Bedienungsanleitung

Craig

Craig TA-304B Bedienungsanleitung

Craig

Craig CHT825 Bedienungsanleitung

Craig

Craig CHT823 Bedienungsanleitung

Craig

Craig CMA3559 Bedienungsanleitung

Craig

Craig CSH308 Bedienungsanleitung

Craig

Craig CHT923 Bedienungsanleitung

Craig

Craig CMA3575 Bedienungsanleitung

Craig

Craig CMA3584 Bedienungsanleitung

Craig

Craig CHT923 Bedienungsanleitung

Craig

Craig MET1427 Bedienungsanleitung

Craig

Craig CMA3707 Bedienungsanleitung

Craig

Craig CHT823 Bedienungsanleitung

Craig

Craig CHT915 Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung