Cree CPY Series Bedienungsanleitung

CPY SERIES

LED CANOPY LUMINAIRE

HOOK AND CORD/PENDANT MOUNT

INSTALLATION INSTRUCTIONS

1 of 2 CI391X09R0

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed

including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. To reduce the risk of electrical shock, turn off power supply before installation or

servicing.

2. This luminaire must be installed in accordance with the NEC or your local electrical

code. If you are not familiar with these codes and requirements, consult a qualied

electrician.

3. DO NOT lift luminaire by the power leads or cord.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

TO INSTALL:

PENDANT MOUNT/ HINGED SPLICE BOX

MOUNTING

STEP 1:

Remove hinged splice box cover from top of housing by

loosening set screw and sliding box to the right and up

from “L” channel. Unhook from hinge holes. See Figure 2.

STEP 2:

Attach hinged splice box cover to customer supplied

pendant or mounting surface and pull supply leads to open

end. See Figure 1.

For pendant entering the hinge box:

Use 3/4” threaded pendant, along with two locknuts (one

for inside the splice box and one for outside the splice

box).

Note: The luminaire should already be factory set for

correct balance. However, should you need to, the luminaire

may be balanced by loosening (2) set screws for pendant

adjustment on the top of the hinged splice box and sliding

the adjustment plate as necessary for correct balance.

Tighten (2) set screws when ﬁnished. See Figure 2.

For surface mounting the hinge box:

Use designated mounting holes on top of hinge splice box.

See Figure 2. For conduit entering the hinge splice box

from the side, use appropriately-sized threaded conduit

(1/2” or 3/4”), along with two locknuts (one for inside the

box, and the other for outside).

STEP 3:

Attach one end of the hinged splice box to luminaire by

aligning hinge slots on Mounting Bracket with hinges (on

splice box), and then inserting the hinges into the slots.

STEP 4:

Make wire connections per Electrical Connection section

and then push the leads into hinged splice box.

STEP 5:

Secure other end of the hinged splice box to luminaire

by sliding screw on Mounting Bracket up and over in “L”

channel on the hinged splice box. See Figure 2.

STEP 6:

Secure luminaire to hinged splice box by tightening screw.

2Holes for Surface Mounting

and Splice Box Mounting

3/4” ( 19mm )

Pendant Mount Hole

1/2” ( 13mm ) Knockouts

“L” Channel

3/4” ( 19mm )

Knockouts

Pendant

Adjustment

Mounting Bracket

Hinged Splice Box

Customer Supplied

3/4” Pendant

2 of 2 CI391X09R0

www.cree.com/lighting

See www.cree.com/lighting for warranty and speciﬁcations. Cree® and the Cree logo are registered

trademarks.

HOOK AND CORD MOUNTING

STEP 1:

Push down on retainer spring until top of spring is

free of luminaire hook.

STEP 2:

Slide hook into securely mounted customer supplied

eye hanger and return retainer spring to original

position.

Note: The luminaire should already be factory set

for correct balance. However, should you need to,

the ﬁxture may be balanced by loosening the hook

adjustment set screw on the top of the housing and

sliding the hook as necessary for correct balance.

Tighten hook set screw when ﬁnished. See Figure 3.

ELECTRICAL CONNECTIONS

STEP 1:

Make the following Electrical Connections :

a. Connect the black ﬁxture lead to the voltage supply

position of the terminal block or Hot 1 (for 208/240V

wiring).

b. Connect the white ﬁxture lead to the neutral supply

position of the terminal block or Hot 2 (for 208/240V

wiring).

c. Connect the green or green/yellow ground lead to the

green wire position of the terminal block.

d. If Dimming is an option; connect the violet dimming

positive lead to the supply dimming positive lead.

e. If Dimming is an option; connect the grey dimming

negative lead to the supply dimming negative lead.

LINE

OR HOT 1

GREEN

LINE-BLACK

GROUND-GREEN

NEUTRAL-WHITE

DIM (-) GREY

DIM (+) VIOLET

NEUTRAL

OR HOT 2

VIOLET

GREY

SUPPLY WIRING

(DIMMING OPTIONAL)

LUMINAIRE

Mount Hook

Power Cord

Hook Adjustment

Retainer Spring

Andere Cree Beleuchtungsausrüstung Handbücher

Cree

Cree OSQ Series Bedienungsanleitung

Cree

Cree OSQ Series Bedienungsanleitung

Cree

Cree Link With SmartCast Technology Bedienungsanleitung

Cree

Cree OSQ Series Bedienungsanleitung

Cree

Cree C-LITE C-WP-A-FCT3 Series Bedienungsanleitung

Cree

Cree SmartCast FLEX Series Bedienungsanleitung

Cree

Cree TRDL6 Series Bedienungsanleitung

Cree

Cree EB14SMK Bedienungsanleitung

Cree

Cree ZR Series Bedienungsanleitung

Cree

Cree CR Series Bedienungsanleitung

Cree

Cree ESSENTIA ESA-ADR-414 Bedienungsanleitung

Cree

Cree Essentia S-DL4-EB Bedienungsanleitung

Cree

Cree LR24 Series Bedienungsanleitung

Cree

Cree XLamp MH Series Bedienungsanleitung

Cree

Cree ESSENTIA AE Series Bedienungsanleitung

Cree

Cree OSQ Series Bedienungsanleitung

Cree

Cree FLEX Series Bedienungsanleitung

Cree

Cree LS8 Bedienungsanleitung

Cree

Cree TDS Series Bedienungsanleitung

Cree

Cree LQ6 Series Bedienungsanleitung

Cree

Cree OSQ Series Bedienungsanleitung

Cree

Cree XLamp XR Series Bedienungsanleitung

Cree

Cree ESSENTIA S-CT-FB-25L Bedienungsanleitung

Cree

Cree XA-NEMA Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung