Crosswater Limit LI110DNC Bedienungsanleitung

Designed to comply with BS EN 200 for single taps

/combination taps and BS EN 817 for single lever mixers, for

water systems of type 1 and 2 general technical specifications

and to be used within systems designed to BS 6700. BS 6700

recommends the temperature of stored water should never

exceed 65°C.

meet all normal requirements and will minimise the build up

of lime scale in hard water areas. If the fitting is installed at

low pressure (tank fed), then the minimum distance from the

highest installed position of the outlet to the underside of the

cold tank should be at least 2 metres to ensure adequate

performance.

V10423

LIMIT

IMPORTANT INFORMATION BEFORE YOU START

Please read carefully and keep this information for further reference.

Basin Mono No Pop-Up Waste

PRODUCT CODES:

LI110DNC

LI110DNF

LI110DNM

All products manufactured and supplied by

Crosswater are safe provided they are installed, used

correctly and receive regular maintenance in accordance

with these instructions. If you are in any doubt about your

ability to install this product safely you must employ the

services of an experienced qualified plumber.These fittings

need to be installed in accordance with, and meet the

requirements of the Water Supply (Water Fittings)

Regulations 1999 and Scottish Byelaws 2004.

Operating pressure range: Minimum 0.2 bar, Maximum 5.0

bar. Maximum static pressure: 10.0 bar.

Note: Nominally equal (balanced) inlet supply pressures are

recommended for optimum performance with mixer taps.

NOTE: ALL DIMENSIONS IN MILLIMETRES

DIMENSIONS

189

138

113

13.5

143.6

108

IMPORTANT INFORMATION

Please read carefully and keep this information for further reference.

These taps and mixers should be installed in compliance with the Water Regulations.

Where the supplies are unbalanced, i.e. Hot water from cylinder tank / cold from the mains, approved check valves must be

fitted in the supply pipes.

For further details contact your Local Water Authority.

INSTALLATIONINSTALLATION

tighten. Place mixer in position to see if any alteration to

any necessary alterations to the pipework, pass the mixer

through the hole in the basin from above and place the

mixer in position on the basin.

Slide the C-shaped black washer and then the metal

Check that the mixer body is correctly positioned to the

but do not over tighten as damage may be caused to the

sink.

If using copper tails, they will need to be gently turned

outwards, then supported approximately half-way down

and turned inwards, making the two pipes parallel again

but further apart thus making room for the couplings to be

from the front.

ATTENTION

mains stop cock, close all taps except the new mixer and

water heating.

Remove all packaging and check the fitting for damage before starting installation.

Before starting any installation please consider the following: before drilling into walls, check that there are no

hidden electrical wires, cables or wate supply pipes. This can be checked with the aid of an electronic detector.

If power tools are used do not forget to: -

Wear eye protection

feeds is recommended for ease of maintenance.

Before installing the new fitting it is essential that you thoroughly flush through the pipework in order to remove any

remaining swarf, solder, etc. Failure to carry out this procedure could cause problems or damage to the workings of the fitting.

Take care when handling the ‘flexible connecting pipes’, do not bend, twist or crush them. Only tighten the pipes by hand. Do not

crush or kink the shower hose, this could damage the hose and cause leaks.

BEFORE YOU START

Important pre-Installation Notes

CARE & MAINTENANCE

CLEANING THE CARTRIDGE

The concealed cartridge should give trouble free service, but

in the event of any problems, servicing is straight forward.

To remove the cartridge:

CLEANING THE PRODUCT

The material we use in our taps is very durable, nevertheless

care should be taken when cleaning them. They should be

cleaned only with warm soapy water followed by rinsing

vulnerable to acid attack and some strong substances such

as household cleaners, disinfectants, denture cleaners, hair

dyes, wine making, and photographic chemicals can cause

the surface to go black or peel.

Note: Never use abrasive detergents or disinfectants or those

containing alcohol, hydrochloric acid or phosphoric acid.

BODY

CARTRIDGE

RETAINING NUT

COVER CUP

ALLEN KEY

HANDLE

With an hexagonal key loosen the screw, but do not remove

it. Pull o the handle and unscrewthe cover. Using the

correct size spanner unscrew and removethe retaining nut.

Pull out the cartridge taking note of itsorientation. Wash the

cartridge with clean running waterand make sure that any

trapped debris has been removed.Dry and lightly grease the

seal (only use silicone grease) andreplace the cartridge

followed by the nut, cover and handle.

Part of the

Bathroom Brands Group

Rennie Drive, Dartford

Kent DA1 5FU

United Kingdom

0345 873 8840

Dieses Handbuch passt für folgende Modelle

Andere Crosswater Badezimmerarmatur Handbücher

Crosswater

Crosswater Taos 17-59 Bedienungsanleitung

Crosswater

Crosswater MPRO US-PRO391 Bedienungsanleitung

Crosswater

Crosswater Fenmore 28-58 Bedienungsanleitung

Crosswater

Crosswater Darby 15-59 Bedienungsanleitung

Crosswater

Crosswater Leyden 14X-15P-T Bedienungsanleitung

Crosswater

Crosswater Drift DR416FC Bedienungsanleitung

Crosswater

Crosswater ISLSC1200 Bedienungsanleitung

Crosswater

Crosswater SB035B C Bedienungsanleitung

Crosswater

Crosswater Palmero US-B3CCS Bedienungsanleitung

Crosswater

Crosswater Arcade US-ARCV17 Bedienungsanleitung

Crosswater

Crosswater Fenmore 28-51 Bedienungsanleitung

Crosswater

Crosswater Waldorf 31 US-WF80X81 Bedienungsanleitung

Crosswater

Crosswater Arcade US-ARCA5 Bedienungsanleitung

Crosswater

Crosswater Taos 17-14-T Bedienungsanleitung

Crosswater

Crosswater Wisp Series Bedienungsanleitung

Crosswater

Crosswater Lazo LA1416FC Bedienungsanleitung

Crosswater

Crosswater Darby 15-51 Bedienungsanleitung

Crosswater

Crosswater PRO945 Bedienungsanleitung

Crosswater

Crosswater MPRO US-PRO241 Bedienungsanleitung

Crosswater

Crosswater US-L1 Bedienungsanleitung

Crosswater

Crosswater Limit LI120WNC Bedienungsanleitung

Crosswater

Crosswater Revive FHX310C Bedienungsanleitung

Crosswater

Crosswater Fenmore 7 28-60 Bedienungsanleitung

Beliebte Badezimmerarmatur Handbücher anderer Marken

DURAVIT

DURAVIT C.1 C15240 0090 Handbuch

Sunshower

Sunshower PURE SOLO Bedienungsanleitung

Heatstore

Heatstore HSTRL500WTN Bedienungsanleitung

Delabie

Delabie Delabie Sporting 714700 Bedienungsanleitung

Kohler

Kohler K-13056 Montageanleitung

ESS

ESS Container TCL-11 Bedienungsanleitung

Mustee

Mustee 22C Bedienungsanleitung

VITRA

VITRA V-Flow Bedienungsanleitung

Malmet

Malmet B105BT Bedienungsanleitung

bathstore

bathstore Transition H1690MM Leitfaden

baliv

baliv DUK-80.30 T Bedienungsanleitung

baliv

baliv DU-5160 Bedienungsanleitung

BELLOSTA

BELLOSTA Edward 0800/M Bedienungsanleitung

Franke

Franke PRTR0006 Bedienungsanleitung

Gessi

Gessi RILIEVO 59011 Bedienungsanleitung

noken

noken VITAE 100188525-N299998810 Bedienungsanleitung

Allen + Roth

Allen + Roth 1142VA-30-201 Bedienungsanleitung

Britex

Britex HBDA Bedienungsanleitung