I
0
I
-
CE] iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii.iiiiiiiiii.iiiiiiiiiiiiiiiiii.iiiiiiiiii.iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii-i.iiiiiiiiiii.ii.iiiiiiiiiiiiiiiii;iiiiii:::
■
INSTALLLATON
I.
WHERE
AND
HOW
TO
MOUNT
YOUR
MOBILE RADIO
a)You should choose the most appropriate setting from a simple and
practical point
of
view.
b)Your
radio should not interfere with the driver
or
the passengers.
c) Remember to provide different wires for passing and protection.
(e.g.: power, antenna, accessory cabling) so that they do not
in
any
way
Interfere with the driving
of
vehicles.
d)To Install your equipment, use the cradle (1) and the self-tapping
screws
[2]
provided
(drilling
diameter
5 mm). Take care not to
damage
the
vehicle's
electrical
system while drilling the dash
board.
e)Do
not
forget to insert the rubber joints [3] between the TX and
its support as these have a shock-absorbing effect which permits
gentle orientation and tightening
of
the set.
f)Choose where to place the microphone support and remember that
the microphone cord must stretch to the driver without interfering
with the controls
of
the vehicie.
2. ANTENNA INSTALLATION
a) Choosing
your
antenna:
For radios, the longer the antenna, the
better
Its results. Your
dealerwill help
you
with your choice
of
antenna.b) Antena
Movel.
b) Mobile antenna:
-Must
be
fixed to the vehicle where there is a maximum of metallic
surface(ground plane), away from windscreen mountings.
-There are two types
of
antenna: Pre-Regulated Antenna
which
should
be
used on a good ground plane
(e.g.
car roof or lid of
the
boot), and Adjustable Antenna which offer a much larger frequency
range and can be used on a smaller ground plane.
For an antenna which must be fixed
by
drilling, you will need a
good contact between the antenna and the ground plane.
To
obtain
this, you should lightly scratch the surface where the screw
and
tightening star are to be placed.
-Be careful not to pinch or flatten the coaxial cable (as this runs
the
risk
of
break down and/or short circuiting).
-Connect the antenna to location (8).
c)
Fixed
antenna:
A fixed antenna should be installed
In
a space as clear as possible.
If
it
is fixed to a mast,
it
will
perhaps
be
necessary
to stay it,
according
to
the
laws
in
force
(you
should
seek
professional
advice). All SS 6900N antennas and accessories are designed
to
give maximum efficiency to each radio within the range.
(((Cl-)-
-
--------------------------------
•
\
