Cumberland PNEG-2276 Bedienungsanleitung
Date: 08-07-19 V1.0 PNEG-2276
Instructions
1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421
PNEG-2276
Page 1 of 3
Printed in the U.S.A.
Copyright © 2019 by The GSI Group, LLC
www.gsiag.com CN-345091
Hopper Switch Extension
Bracket Installation
Installing the Hopper Switch Extension Bracket
1. Measure down from the top center of the hopper panel (4) and make a mark. (See Figure 1.)
Measure down:
a. 6" for a #300 hopper panel (1)
b. 12" for a #400 hopper panel (1)
Figure 1 Hopper Panel Extension Layout
2. Align the holes in the hopper extension bracket (2) on the mark and center the bracket horizontally
on the panel.
NOTE: The bracket (2) must face toward the bottom of the hopper (1).
3. Mark the hole locations and drill two 5/16" holes (3).
Ref # Description
1#300 Hopper (6")
#400 Hopper (12")
2 Hopper Extension Bracket (C2000810)
3Drill 5/16" Holes
4 Hopper Panel
Page 2 of 3 PNEG-2276
Hopper Switch Extension Bracket Installation
4. Remove the clamp bracket (5) from the top of the long mounting bracket (7) and keep the hardware.
(See Figure 2.)
NOTE: The top clamp bracket (5) will no longer be used.
Figure 2
5. Remove the U-shaped adjustment guide (6) from the back of the long mounting bracket (7) with the
slots and keep the hardware. (See Figure 3.)
NOTE: The U-Shaped adjustment guide (6) will no longer be used.
Figure 3
6. Flip the long mounting bracket (7) with the slots over and align the bottom edge flush with the bottom
edge of the hopper level control (8). (See Figure 4.)
7. Fasten the long mounting bracket (7) to the hopper level control sensor (8) using the washers (9)
and wing nuts (10). (See Figure 4.)
Figure 4
5
7
Ref # Description
5Clamp Bracket (272800)
7 Long Mounting Bracket (273000)
67
Ref # Description
6U-Shaped Adjustment Guide (272900)
7 Long Mounting Bracket (273000)
7
8
10 9
Ref # Description
7Long Mounting Bracket (273000)
8Hopper Level Control
9Washer
10 Wing Nut
PNEG-2276 Page 3 of 3
Hopper Switch Extension Bracket Installation
8. Mount the top of the long mounting bracket (7) to the bottom lip of the hopper extension bracket (2)
using the washers (9) and wing nuts (10). (See Figure 5.)
Figure 5
9. Install the hopper switch extension bracket assembly (11) to the hopper panel (4) using the supplied
1/4" bolts, 1/4" washers and 1/4" nuts (12). (See Figure 6.)
Figure 6
Figure 7 Complete Assembly
10. Continue installing the hopper panels (4) together to complete the hopper assembly.
Ref # Description Ref # Description
2Hopper Extension Bracket (C2000810) 9Washer
7Long Mounting Bracket (273000) 10 Wing Nut
7
2
7
7
210
9
Ref # Description
4Hopper Panel
11 Hopper Switch Extension Bracket Assembly
12 1/4" Bolts, 1/4" Washers and 1/4" Nuts
11
412
11
Andere Cumberland Schalten Handbücher
