Cyber Acoustics CA-2880 Bedienungsanleitung

06-Dec-21 page 1 of 3

SPEAKER BAR SETUP GUIDE

SPEAKER BAR SETUP GUIDESPEAKER BAR SETUP GUIDE

SPEAKER BAR SETUP GUIDE

INTRODUCTION

INTRODUCTIONINTRODUCTION

INTRODUCTION

The External Speaker Bar is an add on module for the Konnekt Videophone. It is used to increase volume when the

Videophone speakers are not loud enough, or to improve audio uality for those that find the standard speakers need more

bass. The External Speaker Bar can provide a significant increase in volume, and provides improved sound uality, with more

bass tones in particular.

The External Speaker Bar is a Cyber Acoustics model CA-2880. It has been chosen for use with the Videophone due to the

sound uality and volume, but also because it conforms to the Konnekt philosophy of simplicity, and reliability ....

• It derives power from a standard USB port. It therefore does not need charging and cannot accidentally go flat.

• It has a simple, real power switch, instead of an intelligent "soft" switch, so it is on when the Videophone is on.

• No USB audio drivers or setup re uired. Sound is instead obtained from the Videophone 3.5mm Audio Out socket.

• Volume can be adjusted using a physical volume knob on the Speaker Bar. No computer skills re uired.

Installation Tips

Installation TipsInstallation Tips

Installation Tips

• To avoid feedback, the Speaker Bar must not be installed close to the microphone, and the speakers should be aimed

away from the microphone. Placing on top of the Videophone is NOT recommended.

• If necessary, cover the Power Switch and Volume Knob with electrical tape or similar, to prevent accidental

adjustment or switching off by the Videophone user.

• If the blue LED is too bright at night, cover it with a small piece of black electrical tape or similar.

However, DO NOT cover the entire speaker bar or any part of the Videophone with cloth or other objects.

Important Note

Important NoteImportant Note

Important Note

The External Speaker Bar plugs into the 3.5mm Audio Out Socket on underside of the Videophone. Once plugged in, the

Videophone speakers become disabled, and speaker audio is redirected to the External Speaker Bar.

So please be aware after connection to the Audio Out Socket, SOME OR ALL SOUNDS WILL BE DISABLED if ....

• the Speaker Bar is unplugged from the USB port

• the Speaker Bar Power Switch is turned off

• the Speaker Bar volume knob is set to zero

(1) 3.5mm Audio Connector

Connect to the Audio Out Socket

or Combo Audio Socket on the

bottom of the Videophone:

(2) USB Connector

Connect to one of the Videophone USB Ports.

Take great care to ensure correct orientation,

otherwise you will damage the USB port.

(3) Speakers

Ensure they are facing away from the

Videophone microphone.

(4) Clamp

Spring loaded, with rubber feet.

(5) Controls

- Power Switch

- Volume Knob

- LED Power Indicator (blue = ON)

06-Dec-21 page 2 of 3

SPEAKER BAR SETUP GUIDE

SPEAKER BAR SETUP GUIDESPEAKER BAR SETUP GUIDE

SPEAKER BAR SETUP GUIDE

INSTALLING THE SPEAK

INSTALLING THE SPEAKINSTALLING THE SPEAK

INSTALLING THE SPEAKER BAR

ER BARER BAR

ER BAR

The options for mounting are ....

• Mount out of sight behind the Videophone, onto the Kickstand

• Mount out of sight behind the Videophone, to suit your particular bracket

The recommended placement of the Speaker Bar is at the rear of the Videophone, attached to the kickstand handle, upside

down. This provides maximum distance between Speaker Bar and microphone, to minimise echo and feedback. IT also

minimises the chance of accidental adjustment of the Speaker Bar controls.

Due to vision, mobility, or cognitive difficulties, some Videophone users may be prone to knocking the Speaker Bar, or

inadvertently altering the Speaker Bar controls, which can cause sound to be disabled. So placing the Speaker Bar upside

down at the back, out of sight, is the best option. In an Aged Care environment, this placment also minimise the chance of

the Speaker Bar controls being inadvertently altered by staff, especially cleaning staff.

Mountin Onto Kick Stand

Mountin Onto Kick StandMountin Onto Kick Stand

Mountin Onto Kick Stand

• Using the Speaker Bar Clamp, mount onto the Kickstand as shown.

• Carefully route the Speaker Bar cables to ensure that ....

o they do not protrude underneath or around the Videophone

o they cannot be snagged on fingers / hands / clothing

• Plug the 3.5mm Audio Connector into the Audio Out

socket on the bottom of the Videophone labeled thus:

• Note that some Videophones have a 3.5mm Combo Audio Socket with

a slightly different label - plug into that socket.

• Plug the USB Connector into one of the USB Ports on the bottom of

the Videophone.

• Turn on the Speaker Bar using its Power Switch.

• Conduct test calls, and adjust the Volume Knob to preference.

Correct Connection of USB and Audio Cables

Correct Connection of USB and Audio CablesCorrect Connection of USB and Audio Cables

Correct Connection of USB and Audio Cables

Connection to USB & Audio Out Socket ... Connection to USB & Combo Audio Socket ...

06-Dec-21 page 3 of 3

SPEAKER BAR SETUP GUIDE

SPEAKER BAR SETUP GUIDESPEAKER BAR SETUP GUIDE

SPEAKER BAR SETUP GUIDE

Custom Mountin To Suit Your Particular Bracket

Custom Mountin To Suit Your Particular BracketCustom Mountin To Suit Your Particular Bracket

Custom Mountin To Suit Your Particular Bracket

If you have supplied your own bracket, and need to ensure that the Speaker Bar is installed behind the Videophone out of

sight, you may need a customised installation of the Speaker Bar. With some brackets, it is possible to simply clamp the

Speaker Bar onto a section of bracket, and carefully route cables. But this is highly dependent upon the type of bracket, and

therefore no specific instructions can be provided here. If in doubt, consider a professional installation by a Konnekt

technician.

GUIDELINES, SHOULD YOU DECIDE TO PROCEED

• If possible, use the Clamp to secure the Speaker Bar to a section of the bracket that moves with the Videophone.

• If there is no suitable section of bracket to clamp onto, you will need to secure the Speaker Bar to a section of

bracket, or to the back of the Videophone itself. Depending on the particular installation, you could try ....

o high grade double sided tape (ensure it will not come adrift over time)

o high grade adhesive velcro (ensure it will not come adrift over time)

o cable ties

NOTE: Do not drill into any part of the Videophone, or block Videophone air vents in any way

• If you use double sided tape to adhere the Speaker Bar onto the back of the Videophone or onto the bracket,

consider using spacers to provide an air gap for heat dissipation, and to ensure cables are not s uashed or bent.

• Carefully route the Speaker Bar cables to ensure that ....

o they do not protrude or dangle underneath or around the Videophone

o they cannot be snagged on fingers / hands / clothing

o they are not s uashed or bent at any point

• Plug the 3.5mm Audio Connector into the Audio Out socket on the bottom of the Videophone labeled thus:

• Note that some Videophones have a 3.5mm Combo Audio Socket with a slightly different label - plug into that

socket.

• Plug the USB Connector into one of the USB Ports on the bottom of the Videophone.

• Turn on the Speaker Bar using its Power Switch.

• Conduct test calls, and adjust the Volume Knob to preference.

Inhaltsverzeichnis

Andere Cyber Acoustics Sprecher Handbücher

Cyber Acoustics

Cyber Acoustics PS-2350 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-2880 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-2885BT Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-2890BT Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-4100 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics PS-2370 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-3488 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-4100 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-3712BT Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-MP50 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-901BT CM Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-901BT Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-SP29BT Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-2908 Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics AC-2.1A Bedienungsanleitung

Cyber Acoustics

Cyber Acoustics CA-2890 Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung