Daewoo HEA1131 Bedienungsanleitung

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should

always be followed. These instructions should be saved for future

reference:

Keep the appliance at least 100cm (1.0m) from walls and any other

combustible materials including clothing, curtains, furniture, etc.

Read and familiarise yourself with all operating instructions before

using this Halogen Heater.

Before plugging your unit into the mains, visually check that the unit is

intact and has not suffered any transit damage.

WARNING: In order to avoid overheating, do not cover the

heater.

Do not install the appliance directly below an electrical socket.

Do not use this heater with a programmer, timer, separate remote-

control system or any other device that switches the heater on

automatically, since a fire risk exists if the heater is covered or

positioned incorrectly.

Do not use this heater with an extension cable.

Check that the voltage indicated on the data plate corresponds with

that of the local network before connecting the appliance to the mains

power supply.

Close supervision is required when using this appliance near children.

Never leave this appliance within reach of children.

This appliance can be used by children aged from 8 years and above

and persons with reduced physical, sensory or mental capabilities or

lack of experience and knowledge if they have been given supervision

or instruction concerning use of the appliance in a safe way and

understand the hazards involved. Children shall not play with the

appliance. Cleaning and user maintenance shall not be made by

children without supervision.

Children of less than 3 years should be kept away unless

continuously supervised.

Children aged from 3 years and less than 8 years shall only switch

on/off the appliance provided that it has been placed or installed in its

intended normal operating position and they have been given

supervision or instruction concerning use of the appliance in a safe

way and understand the hazards involved. Children aged from 3

years and less than 8 years shall not plug in, regulate and clean the

appliance or perform user maintenance.

WARNING:This heater is not equipped with a device to

control the room temperature. Do not use this heater in small rooms

when they are occupied by persons not capable of leaving the room

on their own, unless constant supervision is provided.

CAUTION—some parts of this product can become very

hot and cause burns. Particular attention has to be given where

children and vulnerable people are present.

Do not use this heater in the immediate surroundings of a bath, a

shower or a swimming pool.

Do not immerse the appliance or its cord in water or any other liquids.

Do not leave the appliance unattended during use.

Do not leave the appliance unattended whilst connected to the mains

supply.

Always use this appliance on a solid, level, non-flammable surface.

Do not use this appliance outdoors.

It is imperative to unplug the power cord after the appliance has been

used, before it is cleaned and whilst being repaired.

Repairs to electrical appliances should only be performed by a

qualified electrician. Improper repairs may place user at serious risk.

Do not operate this appliance with a damaged plug or cord, after a

malfunction or after being dropped or damaged in any way.

Regular, periodic checks should be carried out on the mains cable to

ensure no damage is evident. Should there be any signs of damage

the appliance should not be used.

If the power cable is damaged, it should only be replaced by the

manufacturer or a suitable qualified after-sales-service in order to

avoid a hazard

Do not allow the mains cable to hang over sharp edges or come in

contact with hot surfaces.

Do not run the mains cable under carpets, rugs, etc.

Allow the unit to cool before storage.

Before cleaning, disconnect the appliance from the mains supply and

allow to cool.

Never place the appliance near to flammable material or high

pressure containers. (e.g., Paper, wood, petrol, solvents, spray

canisters etc.)

This appliance is intended for household use only and should not be

used for industrial purposes.

Do not use any accessories or attachments with this appliance other

than those supplied or recommended by supplier.

Do not use this appliance for anything other than its intended use.

Do not push objects into any openings as damage to the appliance

and/or electric shock may occur.

Ensure appliance is situated in an open area, do not allow it to come

in contact with Cupboards, Curtains, wall coverings, clothing or other

flammable materials.

The appliance should not be installed in areas which have a fire-risk,

such as garages, stables or wooden sheds; this is applicable also for

rooms in which highly inflammable gasses or dust can develop.

Danger of fire!!

Unplug after each use. Grasp the plug, not the cord.

THIS APPLIANCE MUST BE EARTHED

NBDuring the first few minutes of initial use, you may notice a

slight odour and a little smoke. This is normal and will quickly

disappear, It is the coating applied to the heating elements to

prevent any corrosion during transit.

Description of parts

Control Switches

Halogen Tube

Heater Body

Base

Plastic Headed Fixing

Screws (underside)

Anti-Tilt Switch (underside)

Before the first time you use your Halogen Heater

Please read these operating instructions thoroughly and keep them in

a safe place for future reference.

Remove all packing materials and discard responsibly.

Ensure that the two plastic headed fixing screws are present.

Assembling your Halogen Heater

Attach the base of the heater to the main body as follows:

Remove the two plastic headed fixing screws from the baseplate of

the heater.

Thread the power cord through the hole in the middle of the base and

then attach the base to the baseplate using the two plastic headed

fixing screws.

Clip the mains cable into the cord grip on the underside of the base

and feed it through the slot in the rear edge.

Operating Instructions

NB This heater is fitted with a safety tilt switch. The heater will not

operate if placed on an uneven surface or a soft/fluffy carpet.

Place the heater on a solid, level non-flammable surface.

Ensure that all the control switches are in the off (O) position.

Insert the mains plug into the mains socket.

Press the power switch (I) to power up the heater and select the low

heat setting (400w - one tube).

For the medium heat setting (800w – two tubes) press second switch

(I) in from the right (leaving the power switch pressed).

For the full high heat setting (1200w – three tubes) press the third

switch (I) in from the right (leaving the first two pressed).

Press the power switch (O) to switch off the heater.

Oscillation Mode

Press the left hand switch (I) to enable the heater to oscillate from left

to right to disperse heat over a larger area.

Control Switches

Care and Use of your Halogen Heater

Always disconnect the halogen heater from the mains power supply

and allow to cool before cleaning.

Clean outside of the halogen heater with a clean damp cloth. Never

clean with harsh or abrasive cleaners.

Do not submerge any part of halogen heater in water or any other

liquids.

Technical Data

Voltage : 220-240V ~ 50Hz

Rated power : 1200 W (400+400+400W)

Model Number : HEA1131

Electrical Connections

This appliance is fitted with a fused three-pin plug to BS 1363. If the

plug has to be removed, it should be cut off and carefully disposed of

immediately. To avoid a possible shock hazard, do not insert the

discarded plug into a mains socket.

Press this switch to

power up the heater

and select the low

heat setting

Press this switch to

enable oscillation mode

Press this switch for

the medium heat

setting

Press this switch for

the high heat setting

Fitting a new plug

The mains lead must be connected as shown below. The wires are coloured

with the following code - Brown wire = Live (L), Blue wire = Neutral (N), Green

& Yellow = Earth (E).

The Blue wire must be connected to the terminal marked N or coloured Black.

The Brown wire must be connected to the terminal marked L or coloured Red.

The Green and Yellow wire must be connected to the terminal marked E or

coloured Green.

Check that there are no cut or stray strands of wire inside the plug.

Use a 13 Amp BS 1362 fuse, only use BSI or ASTA approved fuses.

If you are in any way unsure which plug or fuse to use, always refer to a

qualified electrician.

After replacing or changing a fuse on a moulded plug, the cover must be

refitted to the plug; the appliance must not be used without a fuse cover.

WARNING: Do not wrap the cord around the heater for storage

Connect

Blue to

Neutral

(N)

Ensure the outer sheath of the mains

lead is securely held by the cable clamp

Connect

Brown to

Live (L)

Connect

Green &

Yellow to

Earth (E)

Model

HEA1131

Item

Symbol

Value

Unit

Item

Unit

Heat output

Type of heat input, for electric storage local space

heaters only (select one)

Nominal heat

output

Pnom

1.2

manual heat charge control, with

integrated thermostat

Not applicable

Minimum

heat output

(indicative)

Pmin

0.4

manual heat charge control with room

and/or outdoor temperature feedback

Not applicable

Maximum

continuous

heat output

Pmax,c

1.2

electronic heat charge control with room

and/or outdoor temperature feedback

Not applicable

Auxiliary electricity consumption

fan assisted heat output

Not applicable

At nominal

heat output

elmax

Type of heat output/room temperature control (select

one)

At minimum

heat output

elmin

single stage heat output and no room

temperature control

[no]

In standby

mode

elSB

Two or more manual stages, no room

temperature control

[no]

with mechanic thermostat room

temperature control

[no]

with electronic room temperature control

[no]

electronic room temperature control plus

day timer

[no]

electronic room temperature control plus

week timer

[no]

Other control options (multiple selections possible)

room temperature control, with

presence detection

[no]

room temperature control, with open

window detection

[no]

with distance control option

[no]

with adaptive start control

[no]

with working time limitation

[no]

with black bulb sensor

[no]

ERP Data

Inhaltsverzeichnis

Andere Daewoo Heizung Handbücher

Daewoo

Daewoo HEA1139 Bedienungsanleitung

Daewoo

Daewoo HEA1897 Bedienungsanleitung

Daewoo

Daewoo HEA1816 Bedienungsanleitung

Daewoo

Daewoo HEA1812 Bedienungsanleitung

Daewoo

Daewoo HEA1896 Bedienungsanleitung

Daewoo

Daewoo HEA1140 Bedienungsanleitung

Daewoo

Daewoo HEA1710 Bedienungsanleitung

Daewoo

Daewoo HEA1840 Bedienungsanleitung

Daewoo

Daewoo HEA1820 Bedienungsanleitung

Daewoo

Daewoo HEA1139 Bedienungsanleitung

Daewoo

Daewoo HEA1145 Bedienungsanleitung

Daewoo

Daewoo HEA1130 Bedienungsanleitung

Daewoo

Daewoo HEA1138 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung