Daikin 3MWKS80LV1 Bedienungsanleitung

REMOVAL

PROCEDURE

SERVICE MANUAL

80 kW Class

Outdoor Unit

Inverter

Multi Type

Si121557E

Service Manual

Removal Procedure

Outdoor Unit

zCooling Only

3MWKS80LV1

zWater Heater

TUL-55KVM

TUL-75KVM

TUL-100KVM

TUR-55KVM

TUR-75KVM

TUR-100KVM

Si121557E

Removal Procedure 1

Table of Contents

1. Outdoor Unit............................................................................................2

1.1 Outer Panels / Outdoor Fan .....................................................................2

1.2 Fan Motor ...............................................................................................10

1.3 Electrical Box..........................................................................................12

1.4 PCBs ......................................................................................................18

1.5 Reactor...................................................................................................24

1.6 Coils / Thermistors .................................................................................25

1.7 Sound Blankets ......................................................................................27

1.8 Compressor............................................................................................29

2. Water Heater.........................................................................................31

Note: The illustrations may be slightly different depending on the model.

Outdoor Unit Si121557E

2Removal Procedure

1. Outdoor Unit

1.1 Outer Panels / Outdoor Fan

Warning Be sure to wait for 10 minutes or more after turning off all power supplies before

disassembling work.

Step Procedure Points

1. Remove the suction grille. The hooks are secured in

the clearances of the

outdoor heat exchanger fins.

Unfasten the 5 hooks.

Remove the suction

grille.

2. Remove the top panel.

Remove the 8 screws.

Lift up the top panel and

remove it.

3. Remove the front panel

(2).

This screw is M5 × 16.

1 Remove the 5 screws.

(R17585)

Hook

Suction grille

(R22022)

Top panel

Front Panel (2)

Front

Panel (1)

(R13637)

Si121557E Outdoor Unit

Removal Procedure 3

2 Slide the front panel (2)

downward to release

the hook.

3 Remove the front panel

(2).

4. Remove the right side

panel.

1 Remove the 2 screws.

Step Procedure Points

(R21942)

Hook

(R13639)

Right side panel (R13640)

Outdoor Unit Si121557E

4Removal Procedure

2 Slide the right side

panel downward to

unfasten the 2 hooks on

the back side.

Step Procedure Points

(R13645)

Hook

(R6378)

Hook

(R13646)

Si121557E Outdoor Unit

Removal Procedure 5

5. Remove the outdoor fan

and the front panel (1).

Remove the discharge grille

and outdoor fan first to

remove the front panel (1).

1 Remove the 4 screws

on the discharge grille.

Slide the discharge

grille downward to

unfasten the 2 hooks at

the top.

Remove the discharge

grille.

4 Remove the nut and

remove the outdoor fan.

Nut size : M8

When reassembling, align

the mark of the outdoor

fan with the D-cut section of

the motor shaft.

Step Procedure Points

(R13641)

Discharge grille

Front

Panel (1)

(R21943)

Hook

(R13644)

Outdoor fan

13 mm

(0.51 inch)

(R18965)

Outdoor Unit Si121557E

6Removal Procedure

5 Remove the 5 screws

on the front panel (1).

6 Release the hook and

remove the front panel

(1).

6. Remove the rear panel.

1 Remove the screw on

the partition plate (2)

and remove the

partition plate (2).

Step Procedure Points

(R18785)

(R17716)

(R13650)

Partition

plate (2)

Rear panel

Si121557E Outdoor Unit

Removal Procedure 7

2 Remove the 5 screws

and remove the wire

fixture.

3 Disconnect the

connecting wires.

4 Disconnect the

connector [S402].

[S402]: water heater thermistor

Step Procedure Points

(R21944)

Wire fixture

(R13652)

[S402]

(R22025)

Outdoor Unit Si121557E

8Removal Procedure

5 Remove the screw of

the resin clamp.

When reassembling, attach

the resin clamp as below.

6 Remove the water

heater thermistor.

7 Pull out the holder of

the outdoor

temperature thermistor.

The holder is secured in the

clearances of the outdoor

heat exchanger fins.

Step Procedure Points

(R13654)

Resin

clamp

<Wrong>

(R22023)

(R15740)

Water

heater

thermistor

(R10388)

Outdoor temperature thermistor

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Daikin Temperaturregler Handbücher

Daikin

Daikin OM-SLM-0501 Bedienungsanleitung

Daikin

Daikin EHBH04CB Bedienungsanleitung

Daikin

Daikin BACnet 2508031 Handbuch

Daikin

Daikin IOM 1177-1 Betriebsanleitung

Daikin

Daikin EHVH04S18CA Bedienungsanleitung

Daikin

Daikin FWEC2 Bedienungsanleitung

Daikin

Daikin 669529101 Bedienungsanleitung

Daikin

Daikin Altherma ERHQ011-014-016BA Anleitung zur Verwendung

Daikin

Daikin BYCQ140E2GW1 Bedienungsanleitung

Daikin

Daikin REYQ-XA Bedienungsanleitung

Daikin

Daikin Altherma EHVZ08S18CB Produktinformationsblatt

Beliebte Temperaturregler Handbücher anderer Marken

Swegon

Swegon LUNAd MB Bedienungsanleitung

Lucky Reptile

Lucky Reptile Thermo Control II Bedienungsanleitung

SENSORMETRIX

SENSORMETRIX Argon 100 Bedienungsanleitung

Fuji Electric

Fuji Electric PXE4 Bedienungsanleitung

Yuyao gongyi

Yuyao gongyi XMT-808 series Bedienungsanleitung

Selec

Selec TC544C Bedienungsanleitung

P.W. KEY

P.W. KEY rt-208gt Bedienungsanleitung

Future Design

Future Design FDC-9200 Bedienungsanleitung

BH Thermal

BH Thermal BriskONE Bedienungsanleitung

Omron

Omron E5EX-H Bedienungsanleitung

West Control Solutions

West Control Solutions KS 45 Kurzanleitung

MCS

MCS RITC-15B Bedienungsanleitung

SMC Networks

SMC Networks Thermo-con INR-244-639 Bedienungsanleitung

eltherm

eltherm Ex-TC It Series Bedienungsanleitung

Omron

Omron C200H-TV Series Bedienungsanleitung

industrie technik

industrie technik CA1 Bedienungsanleitung

KRAL

KRAL EET 32 Bedienungsanleitung

dixell

dixell XR420C Verdrahtungsschema