Swimming pool heat pump
- 1 -
To our customers
Attention
1. Before installing the heat pump, please check whether the local power supply corresponds
with the requirement of the heat pump. For details, please refer to the nameplate on the unit
or the installation and operation instruction.
2. Please install the electrical protection devices according to local regulations.
3. Connecting the heat pump to a ground wire is necessary, in order to prevent electric shock
caused by an unexpected short circuit inside the unit.
4. In wire connection, the electrician can refer to the wiring diagram in this manual. Wiring tasks
should be carried out by qualified electricians only. In addition, they should check the safety
conditions of power utilization, for example, check if the cable capacity is adequate, and check
if the power cable is damaged.
5. Do not insert any objects into the heat pump when running. It may touch the fan and damage
it or lead to accidents (especially for the children).
Do not use the unit without the grid in case it may lead to any accidents.
6. For safety reasons, please do not change or repair unit by yourself. If it is necessary, please
contact local distributor for help.
7. If there is something wrong with the unit, contact immediately with local distributor or our
factory. The unit can be reused only after check and solution by the technical staff.
8. Make sure that cut off the electric supply before maintaining the unit.
9. Please follow the instruction below when cleaning the unit.
a. Before cleaning, cut off the electric supply of the unit firstly to avoid injuries caused by fan
in operation.
b. Do not rinse the unit by water because the rinsed unit may cause electric shock.
Note!
Dear customers, thank your for your kind support to our products. Please read this
instruction carefully before the installation and application of this product. The precautions
listed below are all-important for safety. Please follow the instructions strictly.
