Dali PHANTOM IW SUB S-100 Bedienungsanleitung
DALI PHANTOM
IW SUB S-100
INSTALLATION MANUAL
Contents
2.0 Safe Precautions 4
3.0 Unpacking 5
4.0 Positioning and Installation 6
4.1 Positioning 7
4.2 In-wall Installation 9
4.2.1 Cables 9
4.2.2 Wall Aperture 10
4.2.3 In-wall Installation 11
4.2.4 On-wall Installation 15
4.2.5 Unmounted Installation 17
5.0 Cleaning 19
6.0 Disposal 19
7.0 Technical Specifications 20
2
Congratulations on your new DALI PHANTOM
IW SUB S-100 In-wall subwoofer. In order to
get the most from your purchase, please read
this manual carefully before you unpack and
install your new subwoofer. You can find more
information on our website: www.dali-speakers.
com or by contacting your authorised DALI
retailer.
The DALI PHANTOM IW SUB S-100 subwoofer
is designed to be used with the matching DALI
PHANTOM CI AMP-2500 DSP amplifier.
Comprehensive information on amplifier to
subwoofer routing and connections, can be
found in the CI AMP-2500 DSP Installation
Manual available for download from dali-
speakers.com
NOTE
The matching DALI PHANTOM CI AMP-2500
DSP power amplifier is required for the correct
operation of PHANTOM SUB S-100 subwoofers.
Each CI AMP-2500 DSP can power up to
four SUB S-100 subwoofers. The SUB S-100
subwoofer has been developed with- and is to
be amplified by, the AMP-2500 DSP amplifier to
achieve the best performance.
NOTE
Comprehensive information on AMP-2500
DSP amplifier installation can be found in the
AMP-2500 DSP installation manual available for
download from dali-speakers.com.
3
2.0 Safety Precautions
• Always follow all safe precautions.
• It is recommended that the PHANTOM IW SUB S-100
should be installed by competent professional audio
installation technicians.
• The SUB S-100 must only be used indoors and never in
extreme humid, hot or cold temperatures.
• The SUB S-100 must only be used with the matching AMP-
2500 DSP amplifier.
• The SUB S-100 should not be exposed to continual direct
sunlight.
• Ensure that there are no service installations such as
electrical or data cables, gas or water pipes, or ventilation
ducts present in the wall at the SUB S-100 mounting
location.
• Ensure that the wall is easily able to support the weight of the
SUB S-100 subwoofer. If necessary consult an appropriately
qualified structural engineer for advice.
• When installing a SUB S-100 in a plasterboard/dry wall we
recommend that two layers of plasterboard are used in the area
around the subwoofer. If it is not possible to use two layers of
plasterboard, we recommend one of these measures:
• Reinforce the single layer plasterboard beneath the dogleg
clamps using wood pieces measuring at least 75 mm x 30 mm x
3 mm thick (3 in x 1.2 in x 0.125 in). Or…
• Install the SUB S-100 on-wall using a DALI PHANTOM S-80
On-Wall Frame (OW FRAME S-80).
• If the SUB S-100 subwoofer is to be installed in a wall where
a vapour barrier is present, ensure that the barrier is not
compromised during installation.
• Ensure that the AMP-2500 DSP driving amplifier is switched o
when connecting cables between the SUB S-100 subwoofer and
the amplifier.
4
3.0 Unpacking
Take care not to damage the box contents
when unpacking the SUB S-100 subwoofer.
Once unpacking is complete, check that all
components listed and illustrated in Diagram 1
are present.
1 x DALI PHANTOM
IW SUB S-100
1 x Grille (magnetic) 1 x Cut-out template 4 x Rubber pads
DIAGRAM 1: CONTENTS
We recommend that packaging materials are
retained in case the SUB S-100 subwoofer requires
relocation. If however the packaging materials are
to be discarded, please ensure they are disposed of
responsibly and recycled where possible.
5
4.0 Positioning and Installation
The SUB S-100 is a passive In-wall subwoofer designed for use in both
conventional stereo and multi-channel home theatre audio systems.
SUBS-100 subwoofers can be installed singularly or in multiples.
Although the SUB S-100 is primarily intended for In-wall installation, it
can also be installed on-wall using an appropriate DALI On-wall Frame, or
be used unmounted lying on its back, also using an On-wall Frame as an
external cabinet.
ON-WALL
INSTALLATION
IN-WALL
INSTALLATION
UNMOUNTED
INSTALLATION
6
DIAGRAM 2: IN-WALL/ON-WALL SUBWOOFER POSITIONING
Example single In-wall or on-wall subwoofer positions Example multiple In-wall or on-wall subwoofer positions
4.1 Positioning
By their very nature, the positioning of
subwoofers such as the SUB S-100 is
less critical than the positioning of stereo
speakers, but still there are some guidelines
to follow, described below and illustrated in
the Diagrams 2 and 3, that will help ensure
optimal performance.
• If a single SUB S-100 is to be installed, it is
best located near the floor of the listening
room in or on the wall that also carries
the front le and right channel speakers.
The closer the subwoofer is to the corner
of the room, the more it will gain acoustic
reinforcement from the room and the less
volume level it will require.
• If a pair of SUB S-100 subwoofers are to
be installed, they are best located near the
floor of the listening room in or on the wall
that also carries the front le and right
channel speakers. As with single subwoofer
installations, the closer the subwoofers
are to the corner of the room, the more
they will gain acoustic reinforcement from
the room and the less volume level they will
require.
7
>50 mm / 1,98 in
DIAGRAM 3: UNMOUNTED SUBWOOFER POSITIONING
Examples concealed installation on the floor beneath furniture
• If SUB S-100 subwoofers are to be installed on the surface of a
wall using an On-wall Frame, or unmounted lying on their back using
On-wall Frames as cabinets, the same location guidelines as for In-
wall installation should generally be followed. The use of SUB S-100
subwoofers unmounted lying on their back however does potentially
enable concealed installation on the floor beneath furniture.
• In either single or multiple subwoofer installations, if it is not practical
to install SUB S-100 subwoofers in the same wall as the front le and
right channel speakers, installation in the side walls of the room, close
to the front corners is also viable.
8
4.2 In-wall Installation
4.2.1 Cables
The choice of cables used to connect SUB S-100 subwoofers to the
AMP-2500 DSP power amplifier is important. Replacing cables following
installation is potentially dicult so it is best to select quali cables from
the start. Your authorised DALI retailer will be able to advise on cable
choice.
When connecting cables to the subwoofer and the amplifier it is
important that correct polari is retained. The red (positive +)
subwoofer terminal must be connected to the positive (+) amplifier
terminal. The black (negative -) subwoofer terminal must be connected
to the negative (-) amplifier terminal.
To insert the cable end into the spring loaded terminals of the IW SUB
S-100 subwoofer, remove the cable insulation so that approximately
12 mm (½ in) of bare wire is exposed. Press the top of the terminal
down and insert the bare wire into the opening. When the wire is fully in
place with no loose strands exposed, release the terminal. Use of the
subwoofer terminals is illustrated in Diagram 4.
DIAGRAM 4:
SUBWOOFER CONNECTION TERMINALS
9
The SUB S-100 subwoofer can be mounted in stud (dry wall) and
plasterboard constructed walls with a minimum free depth of 102
mm (4.02 in). The minimum and maximum plasterboard thickness that
can be accommodated by the SUB S-100 subwoofer fixings is 10 mm
(0.4in) and 50 mm (2.0 in) respectively. The SUB S-100 subwoofer
also requires 19mm (0.74 in) free space to the side, top and boom
in order to enable its dogleg clamps to be deployed. Diagram 5
illustrates SUB S-100 installation dimensions.
If SUB S-100 is to be installed in a particularly thick wall, it may be
necessary to dismount its dogleg clamps from their screws then and
replace them. Dogleg clamps make it possible to install SUB S-100 in
a wall up to 70 mm (2.75 in) thick.
The supplied cut-out template can be used initially to visualise
where a SUB S-100 is to be installed. As part of this exercise, use
a wall stud and pipe/cable finding tool to ensure that the wall space
in which a subwoofer is to be installed is free of obstructions. It is
also important to ensure that the 102 mm (4.02 in) minimum depth
clearance required for SUB S-100 subwoofers is available. If the free
depth available at the installation position is unknown, a test hole can
be drilled and a depth measuring gauge inserted.
DIAGRAM 5:
SUBWOOFER INSTALLATION DIMENSIONS
615 mm
24.2 in
Min.
19 mm
0.75 in
Min.
102 mm
4.02 in
370 mm
14.6 in
Minimum depth
102 mm
4.02 in
Max. 50 mm / 2 in
Min. 10 mm / 0.4 in
Reversed doglegs
Max. 70 mm / 2.8 in
Min. 30 mm / 1,2 in
4.2.2 Wall Aperture
10
Andere Handbücher für PHANTOM IW SUB S-100
2
Inhaltsverzeichnis
Andere Dali Sprecher Handbücher
Dali
Dali SUITE Bedienungsanleitung
Dali
Dali ALTECO C-1 Bedienungsanleitung
Dali
Dali KATCH Bedienungsanleitung
Dali
Dali MENTOR SUB Bedienungsanleitung
Dali
Dali PHANTOM H Series Bedienungsanleitung
Dali
Dali Phrame Bedienungsanleitung
Dali
Dali KATCH Bedienungsanleitung
Dali
Dali CALLISTO Bedienungsanleitung
Dali
Dali Opticon Bedienungsanleitung
Dali
Dali OBERON Series Bedienungsanleitung
Dali
Dali Evidence C70 Bedienungsanleitung
Dali
Dali PHANTOM E-60 Bedienungsanleitung
Dali
Dali SUB E-9 F Bedienungsanleitung
Dali
Dali CONCEPT CENTER Bedienungsanleitung
Dali
Dali Grand Bedienungsanleitung
Dali
Dali SUITE Bedienungsanleitung
Dali
Dali 3b Bedienungsanleitung
Dali
Dali CONCEPT 1 Bedienungsanleitung
Dali
Dali Ikon MK2 Bedienungsanleitung
Dali
Dali Zensor AX Bedienungsanleitung
Beliebte Sprecher Handbücher anderer Marken
Bowers & Wilkins
Bowers & Wilkins 4 Bedienungsanleitung
Sonance
Sonance SONOS OUTDOOR Series Bedienungsanleitung
Electro-Voice
Electro-Voice EVID FM4.2 Bedienungsanleitung
Pioneer
Pioneer XW-HTD630 Bedienungsanleitung
Onn
Onn BWA16AA002 Bedienungsanleitung
HP
HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung