Danfoss 176F6636 Bedienungsanleitung

Description

The door fan replacement kit contains parts required to install

1 door fan in E1h/E2h drives in IP21/IP54 enclosures.

Kit Ordering Number

Kit number Kit description

176F6636 Door fan for E1h/E2h drives

Table 1.1 Ordering Number for the Door Fan Kit

Items Supplied

The door fan replacement kit contains the following:

•

1 fan

•

Installation instructions

Safety Instructions

Only qualied, Danfoss authorized personnel are allowed to

install the parts described in these installation instructions.

Handling of the drive and its parts must be done in

accordance with the corresponding operating guide.

WARNING

ELECTRICAL SHOCK HAZARD

VLT

FC series drives contain dangerous voltages when

connected to mains voltage. Improper installation, and

installing or servicing with power connected, can cause

death, serious injury, or equipment failure.

To avoid death, serious injury, or equipment failure:

•

Only use qualied electricians for the installation.

•

Disconnect the drive from all power sources before

installation or service.

•

Treat the drive as live whenever the mains voltage

is connected.

•

Follow the guidelines in these instructions and local

electrical safety codes.

WARNING

DISCHARGE TIME

The drive contains DC-link capacitors, which can remain

charged even when the drive is not powered. High voltage

can be present even when the warning LED indicator lights

are o. Failure to wait 40 minutes after power has been

removed before performing service or repair work can result

in death or serious injury.

•

Stop the motor.

•

Disconnect AC mains and remote DC-link power

supplies, including battery back-ups, UPS, and DC-

link connections to other drives.

•

Disconnect or lock PM motor.

•

Wait 40 minutes for capacitors to discharge fully.

•

Before performing any service or repair work, use

an appropriate voltage measuring device to make

sure that the capacitors are fully discharged.

Removing the Door Fan

The enclosure door includes 2 fan assemblies at the door top.

To remove and replace the door fan, use the following

procedures. Refer to Illustration 1.1.

1. Pinch together the release tabs on the front grill and

remove the grill from the enclosure door.

2. Remove the fan lter.

3. Inside the enclosure door, unplug the in-line

connector attaching the fan cable.

4. Detach 4 screws (T20), 2 nuts, and 2 corner brackets

from the corners of the fan. When removing the

screws, hold each nut (7 mm) with a wrench on the

opposite side of the fan.

5. Remove the fan from the enclosure door.

Installing the Door Fan

1. Position the fan in the door of the enclosure. Check

that the air direction arrows point away from the

internal drive components when the door is closed.

2. On the inner side of the door, replace the 2 brackets

at opposite corners of the fan and secure with 2

screws (T20).

Installation Instructions

Door Fan Replacement for E1h/E2h Drives

VLT®FC Series FC 102, FC 103, FC 202, and FC 302

3. Replace 2 screws in the remaining 2 corners of the

fan, securing each with a nut (7 mm).

4. Reconnect the in-line cable connector attaching the

fan cable.

5. Replace the lter over the fan on the outside of the

door.

6. Reposition the fan grill over the lter and press to

snap into place.

1 Front grill 5 Door fan front view

2 Release tab 6 Nut (7 mm)

3Fanlter 7 Cornerbracket

4 Screw (T20) 8 Door fan back view

Illustration 1.1 Door Fan Assembly

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on

order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss

Danfoss A/S

Ulsnaes 1

DK-6300 Graasten

vlt-drives.danfoss.com

*MI35M202*

MI35M202130R0766 03/2018

Andere Danfoss Gleichstromantrieb Handbücher

Danfoss

Danfoss VLT series Leitfaden

Danfoss

Danfoss FC 300 Betriebsanleitung

Danfoss

Danfoss VLT AutomationDrive FC 302 Betriebsanleitung

Danfoss

Danfoss VLT FC 300 Bedienungsanleitung

Danfoss

Danfoss AME 435 QM Bedienungsanleitung

Danfoss

Danfoss AMV 438 SU Bedienungsanleitung

Danfoss

Danfoss VLT AutomationDrive FC 360 Betriebsanleitung

Danfoss

Danfoss VLT HVAC Basic Drive FC 101 Bedienungsanleitung

Danfoss

Danfoss VLT CDS 803 Bedienungsanleitung

Danfoss

Danfoss vlt aqua Betriebsanleitung

Danfoss

Danfoss VLT Flow Drive FC 111 Betriebsanleitung

Danfoss

Danfoss VLT Betriebsanleitung

Danfoss

Danfoss VLT CDS 803 Bedienungsanleitung

Danfoss

Danfoss MCB 113 Bedienungsanleitung

Danfoss

Danfoss vlt aqua Bedienungsanleitung

Danfoss

Danfoss VLT DriveMotor FCP 106 Betriebsanleitung

Danfoss

Danfoss VLT AutomationDrive FC 360 Bedienungsanleitung

Danfoss

Danfoss VLT HVACDrive Bedienungsanleitung

Danfoss

Danfoss VLT HVAC Basic Drive FC 10 Bedienungsanleitung

Danfoss

Danfoss VLT AQUA Drive FC 202 Bedienungsanleitung

Danfoss

Danfoss VLT FC 103 Bedienungsanleitung

Danfoss

Danfoss VLT AutomationDrive FC 300 Leitfaden

Danfoss

Danfoss VLT AutomationDrive EZ FC 321 Betriebsanleitung

Danfoss

Danfoss 176F3167 Benutzerhandbuch

Beliebte Gleichstromantrieb Handbücher anderer Marken

Vincent Associates

Vincent Associates UNIBLITZ ED12DSS Bedienungsanleitung

EKSMA OPTICS

EKSMA OPTICS DQ-100-4 Stücklistenhandbuch

Chamberlain Garog

Chamberlain Garog D Series Bedienungsanleitung

Parker

Parker PDS Series Bedienungsanleitung

Festo

Festo DGC G Series Einrichtungshandbuch

Binks

Binks QS-5012-1-CE Bedienungsanleitung

ABB

ABB ACQ580-01 Series Installationshandbuch

YASKAWA

YASKAWA CANopen SI-S3 Bedienungsanleitung

GE D20A6 Bedienungsanleitung

Unex

Unex MC-D-250-1000-050W-TW Bedienungsanleitung

Geckodrive

Geckodrive G213V Bedienungsanleitung

ABB

ABB RSYC-01 Bedienungsanleitung

Rockwell Automation

Rockwell Automation PowerFlex 700S Betriebsanleitung

WEG

WEG DeviceNet CFW500 Bedienungsanleitung

Siemens

Siemens SINAMICS G Datenblatt

Siemens

Siemens SINAMICS SM150 6SL3815-7NP41-0AA1 Betriebsanleitung

SOMFY

SOMFY JR RU 30 Bedienungsanleitung

Beckhoff

Beckhoff AX8911 Bedienerhandbuch