Danfoss 176F1784 Bedienungsanleitung

This instruction sheet is for the field installation of the USB extension cable into the door

of F-Frame VLT frequency converters. Note: This kit is applicable to drives built dur-

ing or after Week 40 of 2008. Frequency converters built prior to Week 40, 2008 do not

have the provisions for this kit.

INSTRUCTIONS

INSTALLATION OF USB EXTENSION CABLE INTO F-FRAME VLT®DRIVES

Instruction No: 177R0091 V0 Jan 2009 Page 1 VLT®is a registered trademark of Danfoss A/S

Kit Contents

• USB extension cord

• Tie wraps

• Instruction Sheet 177R0091

Kit Part Number

176F1784

The door on the rectifier section of

F-Frame VLTs are fitted with a

feed-through hole to accommodate

a USB extension cord so that the

controls can be accessed from a

laptop computer without requiring

access to the inside of the VLT.

With the rectifier door open, the

hole is located near the upper right

corner of the door. See Figures 1

and 2.

The feed-through hole is covered

by the decorative label on the out-

side and with a round sticker on the

outside.

Figure 1. Location of USB feed-through hole.

WARNING

The frequency converter contains dangerous voltage. Disconnect power and follow lock-

out/tag-out procedures before working on this equipment.

Instruction No: 177R0091 V0 Jan 2009 Page 2

1. Remove the label shown in Fig-

ure 2 to expose the USB feed-

through hole from the inside of

the door.

2. Carefully cut through the exterior

label to create a hole for the USB

cable. It is recommended that

the hole be located by creating a

hole in the label from the inside of

the door, then cut through the

decorative label from the outside

to prevent the decorative label

from separating from the door.

Figure 3. USB connector retaining nut.

Figure 4. Inserting USB cable into

feed-through hole.

Figure 2. Location of USB feed-through hole.

3. Remove the retaining nut from

the USB cable. See Figure 3.

4. Insert the USB cable into the door.

The gasket should be located on the

outside of the door. See Figure 4.

Instruction No: 177R0091 V0 Jan 2009 Page 3

5. Secure the USB connector onto

the door by using the USB cable

retaining nut from inside the door.

Tighten securely. See Figures 5

and 6.

Figure 5. Securing USB connector with retaining

nut.

Figure 6. USB connector installed on door.

Instruction No: 177R0091 V0 Jan 2009 Page 4

Figure 7. Front cover of cable channel.

7. Route the USB cable along the

same route as the LCP cable.

This is shown by the dotted red

line in Figure 8. Utilize cable ties

to secure the USB cable to the

LCP cable until the cable is inside

the cable channel.

Figure 8. Routing of USB cable in rectifier cabinet.

8. Route the USB cable from the

cable channel to the control card

as shown in Figure 9.

Figure 9. USB cable.

6. Remove the cable-channel cover

from the front of the cable chan-

nel to enable insertion of the USB

cable. See Figure 7.

Instruction No: 177R0091 V0 Jan 2009 Page 5

9. Connect the USB cable to the control card as

shown in Figure 10.

10. Reinstall the cable-channel cover

as shown in Figure 11.

The installation of the USB cable is

now complete.

Figure 10. USB cable connected to

control card.

Figure 11. Front cover of cable channel.

Inhaltsverzeichnis

Andere Danfoss Industrieanlagen Handbücher

Danfoss

Danfoss VACON NXS Air-cooled Bedienungsanleitung

Danfoss

Danfoss ET4020 Bedienungsanleitung

Danfoss

Danfoss Optyma Slim Pack Bedienungsanleitung

Danfoss

Danfoss 176F4184 Bedienungsanleitung

Danfoss

Danfoss Kompakt H28 Bedienungsanleitung

Danfoss

Danfoss BHO 64A Bedienungsanleitung

Danfoss

Danfoss VLT Safety Option MCB 150 Bedienungsanleitung

Danfoss

Danfoss FT1390 Bedienungsanleitung

Danfoss

Danfoss ET6110 Bedienungsanleitung

Danfoss

Danfoss IPS 8 Bedienungsanleitung

Danfoss

Danfoss Aeroquip FT1370 Bedienungsanleitung

Danfoss

Danfoss VACON 1000 Bedienungsanleitung

Danfoss

Danfoss BOCK F Bedienungsanleitung

Danfoss

Danfoss HG88e Bedienungsanleitung

Danfoss

Danfoss BOCK HRX CO2 T H Bedienungsanleitung

Danfoss

Danfoss DHP-M Leitfaden

Danfoss

Danfoss VXe SLS Bedienungsanleitung

Danfoss

Danfoss FHM-C Series Bedienungsanleitung

Danfoss

Danfoss XG 14 Bedienungsanleitung

Danfoss

Danfoss S19 Leitfaden

Danfoss

Danfoss IPS 8 Gebrauchsanweisung

Danfoss

Danfoss S 22 Bedienungsanleitung

Danfoss

Danfoss iSave 21 Bedienungsanleitung

Danfoss

Danfoss PLUS+1 JS1-H Bedienungsanleitung

Beliebte Industrieanlagen Handbücher anderer Marken

ABB

ABB Unifix AD Handbuch

Mark 7

Mark 7 Evolution Bedienungsanleitung

Husky

Husky HyPET Bedienungsanleitung

bora

bora PM-1800 Bedienungsanleitung

Grizzly

Grizzly T32428 Bedienungsanleitung

Siemens

Siemens 8MF1 Series Bedienungsanleitung

ABB

ABB HT610965 Bedienungsanleitung

ABB

ABB SafeLink Bedienungsanleitung

Phoenix

Phoenix PHX-150 Bedienungsanleitung

ABB

ABB A165-L32 Bedienungsanleitung

ABB

ABB HT842936 Bedienungsanleitung

Rioned

Rioned UrbanJet Bedienungsanleitung

Hermetica

Hermetica 10 Series Bedienungsanleitung

HORNER

HORNER OEE Solution Bedienungsanleitung

Hammerhead

Hammerhead HG375 Bedienungsanleitung

SCHUNK

SCHUNK VERO-S NSE-A3 138 Gebrauchsanweisung

ABB

ABB HT566657 Bedienungsanleitung

Webasto

Webasto GSE CAN Bedienungsanleitung