Darkglass Electronics Microtubes B1K Bedienungsanleitung

User Manual

Microtubes B1K

CMOS Bass Overdrive

Controls (Front)

Level: Sets the volume of the overdriven

signal.

Drive: Sets the amount of saturation in

the overdriven signal.

Controls (Back)

Open the magnetic bottom lid to access

the controls.

Blend: Mixes the clean input signal with

the overdriven signal. The clean signal is

ﬁxed at unity gain, while the volume of

the overdriven signal is set by the Level

knob, allowing for ﬁne control of the

blend ratio. Turn clockwise to blend in

the clean signal.

Tone: Controls the high frequency

content of the sound. A variable low pass

ﬁlter from 3 kHz to 8 kHz. Turn CCW for a

brighter sound.

DIP switches

Grunt: Provides a low-end boost to massively thicken your sound when

engaged.

MBoost: Gives a subtle 6 dB boost from 300 Hz to 1 kHz to help you cut

through the mix.

Technical Speciﬁcations

Input Impedance 1 MΩ

Output Impedance 1 kΩ

Current Consumption ~30 mA

Voltage 9V DC (Center Negative)

Dimensions

Width 50 mm (2 in) Height 100 mm (4 in) Depth 45 mm (1.75 in)

Weight 205 g (0.45 lb)

Warning

The Microtubes B1K has a current draw of 30 mA. Only use a regulated

9V DC adapter with a center-negative plug. Due to ecological reasons it

does not accept batteries. Unregulated power supplies and/or higher

voltages may result in suboptimal noise performance and even damage

your unit, voiding the warranty.

Microtubes B1K

CMOS Bass Overdrive

Controls (Front)

Level: Sets the volume of the overdriven

signal.

Drive: Sets the amount of saturation in

the overdriven signal.

Controls (Back)

Open the magnetic bottom lid to access

the controls.

Blend: Mixes the clean input signal with

the overdriven signal. The clean signal is

ﬁxed at unity gain, while the volume of

the overdriven signal is set by the Level

knob, allowing for ﬁne control of the

blend ratio. Turn clockwise to blend in

the clean signal.

Tone: Controls the high frequency

content of the sound. A variable low pass

ﬁlter from 3 kHz to 8 kHz. Turn CCW for a

brighter sound.

DIP switches

Grunt: Provides a low-end boost to massively thicken your sound when

engaged.

MBoost: Gives a subtle 6 dB boost from 300 Hz to 1 kHz to help you cut

through the mix.

Technical Speciﬁcations

Input Impedance 1 MΩ

Output Impedance 1 kΩ

Current Consumption ~30 mA

Voltage 9V DC (Center Negative)

Dimensions

Width 50 mm (2 in) Height 100 mm (4 in) Depth 45 mm (1.75 in)

Weight 205 g (0.45 lb)

Warning

The Microtubes B1K has a current draw of 30 mA. Only use a regulated

9V DC adapter with a center-negative plug. Due to ecological reasons it

does not accept batteries. Unregulated power supplies and/or higher

voltages may result in suboptimal noise performance and even damage

your unit, voiding the warranty.

GRUNT ON GRUNT OFF MBOOST ON MBOOST OFF

Disclaimer

In the interest of continuous improvement,

speciﬁcations are subject to change without

notice. If you have any questions, please don’t

hesitate to contact us at www.darkglass.com

The manufacturer claims that the above product

fulﬁlls the requirements as set by EN55013,

EN55020, EN60555-2, EN60555-3, RoHS,

WEEE.

EMC / EMI

This equipment has been tested and found to

comply with the limits for a Class B Digital

device, pursuant to part 15 of the FCC rules.

These limits are designed to provide reasonable

protection against harmful interference in

residential installations. This equipment

generates, uses and can radiate radio frequency

energy and, if not installed and used in

accordance with the instructions, may cause

harmful interference to radio communications.

There is no guarantee that interference will not

occur in a particular installation. If this

equipment does cause harmful interference to

radio or television reception, which can be

determined by turning the equipment off and on,

the user is encouraged to try to correct the

interference by one or more of the following

measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the

equipment and receiver.

· Connect the equipment to an outlet on a

circuit different from that to which the receiver

is connected.

· Consult the dealer or an experienced radio/TV

technician for help

Darkglass Electronics

Helsinki, Finland.

www.darkglass.com

Inhaltsverzeichnis

Andere Darkglass Electronics Musikpedal Handbücher

Darkglass Electronics

Darkglass Electronics ADAM Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics ALPHA-OMICRON Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics Duality Dual Fuzz Engine Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics MICROTUBES B7K Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics DUALITY FUZZ Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics Vintage Microtubes Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics Alpha Omega Super Intelligent Footswitch Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics Super Symmetry Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics Super Intelligent Footswitch Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics ALPHA OMEGA PHOTON Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics Microtubes B3K Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics Microtubes X Ultra Bedienungsanleitung

Darkglass Electronics

Darkglass Electronics MICROTUBES INFINITY Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

PuzzleSounds

PuzzleSounds DR. Q ENVELOPE FILTER Bedienungsanleitung

BYOC

BYOC Analog Chorus Handbuch

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung