Datamax E-4304 Bedienungsanleitung

E-4203 / E-4204 / E-4304

Operator’s Manual

Firmware (Software) Agreement

The enclosed Firmware (Software) resident in the Printer is owned by Licensor or its

suppliers and is licensed for used only on a single printer in the user’s Trade or Business.

The User agrees not to, and not to authorize or permit any other person or party

to, duplicate or copy the Firmware or the information contained in the non-volatile

or programmable memory. The firmware (Software) is protected by applicable

Licensor or its suppliers be liable for any damages or loss, including direct, incidental,

economic, special, or consequential damages, arising out of the use or inability to use the

Firmware (Software).

Information in this document is subject to change without notice and does not represent a

commitment on the part of Datamax Barcode Products Corporation. No part of this

manual may be reproduced or transmitted in any form or by any means, for any purpose

other than the purchaser's personal use, without the expressed written permission of

Datamax Corporation.

Part Number: 88-2256-01

Revision: G

Agency Compliance and Approvals:

C US

Listed

UL1950 Information Technology Equipment

C22.2 No. 950-M93

EN60950

For 230 Volt Operation (Europe): Use a cord set, marked "HAR," consisting

of a min H05VV-F cord which has a minimum 0.75 square mm diameter

conductors, provided with an IEC 320 receptacle and a male plug for the

country of installation rated 6A, 250V

Für 230 Volt (Europa):Benützen Sie ein Kabel, das mit"HAR" markiert ist,

bestehend mindestens aus einem H05VV-F Kabel, das mindestens 0,75

Quadratmillimeter Drahtdurchmesser hat; sowie eine IEC320 Steckdose und

einen für das Land geeigneten Stecker, 6A, 250 Volt.

As an Energy Star Partner, the manufacturer has determined that this product

meets the Energy Star guidelines for energy efficiency.

The manufacturer declares under sole responsibility that this product

conforms to the following standards or other normative documents:

EMC: EN 55022 (1993) Class A

EN 50024 (1998)

Safety: This product complies with the requirements of EN 60950 /A11:1997

Gost-R

FCC: This device complies with FCC CFR 47 Part 15 Class A.

þNote: This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions in this manual, it may cause harmful

interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which case the user will

be required to correct the interference at his own expense.

Important Safety Instructions

This printer has been carefully designed to give you many years of

safe, reliable performance. As with all electrical equipment, there are a

few basic precautions you should take to avoid hurting yourself or

damaging the printer:

•Carefully read the installation and operating instructions

provided with your printer.

•Read and follow all warning instruction labels on the printer.

•Place the printer on a flat, firm, solid surface.

•To protect your printer from overheating, make sure all

openings on the printer are not blocked.

•Do not place the printer on or near a heat source.

•Do not use your printer near water, or spill liquid into it.

•Be certain that your power source matches the rating listed on

your printer. If you are unsure, check with your dealer or with

your local power company.

•Do not place the power cord where it will be walked on. If the

power cord becomes damaged or frayed replace it immediately.

•Do not insert anything into the ventilation slots or openings on

the printer.

•Only qualified, trained service technicians should attempt to

repair your printer.

Printer Overview

1.0 Introduction........................................................................ 1

1.1 About this Printer ............................................................... 2

1.1.1 Standard Features.................................................... 2

1.1.2 Optional Features..................................................... 3

Getting Started

2.0 Before using the Printer ...................................................... 5

Setting Up the Printer

3.0 Introduction........................................................................ 7

3.1 Connecting the Printer ........................................................ 7

3.1.1 Power Connection................................................... 7

3.1.2 Interface Connection................................................ 8

3.1.3 Interface Cables....................................................... 8

3.2 Loading Media.................................................................... 9

3.2.1 Loading Media for Peel Configuration..................... 10

3.3 Loading Ribbon (Thermal Transfer)................................... 11

3.4 Flash Memory Expansion.................................................... 13

Using the Front Panel

4.0 Front Panel Operation......................................................... 15

4.1 Lights.................................................................................. 15

4.2 Buttons............................................................................... 16

4.3 Normal Mode - Button Functions........................................ 16

4.4 Printer Setup Mode - Button Functions............................... 17

4.4.1 Printer Setup Menu List........................................... 18

4.4.2 Menu Items and Values............................................ 19

4.4.3 Example of Changing Baud Rate.............................. 22

4.5 Label Alignment................................................................. 25

4.5.1 Label Alignment = YES ........................................... 25

4.5.2 Label Alignment = AUTO........................................ 26

4.5.3 Label Alignment = NO............................................. 26

4.5.4 Label Alignment Recommended Settings................. 27

4.5.5 Label Alignment Troubleshooting............................ 28

iii

4.6 Calibration Mode................................................................ 31

4.6.1 Media Sensor Calibration Procedure........................ 32

4.6.2 Auto Media Calibration Procedure........................... 33

4.7 Internal Labels.................................................................... 34

4.7.1 Database Configuration and Dot Check Label............. 34

4.7.2 Test Label................................................................ 36

Maintenance and Adjustments

5.0 Introduction........................................................................ 38

5.1 Cleaning the Printhead........................................................ 39

5.2 Media Width Adjustment.................................................... 40

5.3 Ribbon Width Adjustment.................................................. 41

5.4 Fine Printhead Adjustment.................................................. 42

5.5 Printhead Replacement....................................................... 43

5.6 Darkness Adjustment.......................................................... 44

5.7 Resetting to the Factory Defaults......................................... 44

5.8 Downloading Firmware and Fonts...................................... 45

Troubleshooting

6.0 Introduction......................................................................... 46

Specifications

7.0 Printer Specifications.......................................................... 50

Appendix A

ASCII Control Code Chart......................................................... A-1

Appendix B

Embedded Fonts and Barcodes................................................... B-1

Appendix C

Warranty Information................................................................. C-1

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Datamax Etikettendrucker Handbücher

Datamax

Datamax A-Class Mark II Bedienungsanleitung

Datamax

Datamax I-Class Bedienungsanleitung

Datamax

Datamax RL3 Bedienungsanleitung

Datamax

Datamax I-Class Mark II Bedienungsanleitung

Datamax

Datamax E-Class Mark III Professional+ Bedienungsanleitung

Datamax

Datamax E-Class Mark III Bedienungsanleitung

Datamax

Datamax H-Class Bedienungsanleitung

Datamax

Datamax Workstation w1110 Bedienungsanleitung

Datamax

Datamax M-Class Mark II Bedienungsanleitung

Datamax

Datamax Allegro 2 Bedienungsanleitung

Datamax

Datamax Prodigy Plus Bedienungsanleitung

Datamax

Datamax H-Class Bedienungsanleitung

Datamax

Datamax LP3 Bedienungsanleitung

Datamax

Datamax I-Class Mark II I-4212E/203 Bedienungsanleitung

Datamax

Datamax M-Class Mark II Bedienungsanleitung

Datamax

Datamax M-Class Mark II Bedienungsanleitung

Datamax

Datamax MICROFLASH 4TE Bedienungsanleitung

Datamax

Datamax I-Class Mark II Bedienungsanleitung

Datamax

Datamax M-Class Mark II Bedienungsanleitung

Datamax

Datamax A-Class A-4212 Bedienungsanleitung

Datamax

Datamax M-Class Mark II Bedienungsanleitung

Datamax

Datamax E Class E-4203 Bedienungsanleitung

Datamax

Datamax M-Class Mark II Bedienungsanleitung

Datamax

Datamax I-Class Bedienungsanleitung

Beliebte Etikettendrucker Handbücher anderer Marken

Brother

Brother P-Touch 2420PC Bedienungsanleitung

newell

newell Dymo LabelManager 210D Bedienungsanleitung

Brother

Brother TD-4000 Bedienungsanleitung

U-Line

U-Line BROTHER H-8754 Bedienungsanleitung

Tharo Systems

Tharo Systems H-435+ Bedienungsanleitung

Brother

Brother E300 Bedienungsanleitung

Godex

Godex RT700 SERIES Bedienungsanleitung

ID Technology

ID Technology 252 Bedienungsanleitung

Labelmate

Labelmate MC-11 Bedienungsanleitung

CAB

CAB XD4M/300 Bedienungsanleitung

Avery Dennison

Avery Dennison Pathfinder 6057 Service-Handbuch

Brother

Brother P-touch PT-9700PC Bedienungsanleitung

TSC

TSC PEX1000 Series Bedienungsanleitung

Adkins

Adkins Label Master Bedienungsanleitung

Epson

Epson LabelWorks LW-400 Bedienungsanleitung

Primera

Primera 510212 Bedienungsanleitung

Brady

Brady BradyPrinter S3100 Bedienungsanleitung

DuraLabel

DuraLabel LabPRO Bedienungsanleitung