Datasheen D316S Bedienungsanleitung

FCC Certifications

This Equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment

is operated in a commercial environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio

communications.

Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at

his own expense.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received; including interference that

may cause undesired operation.

CE Mark Warning

This equipment complies with the requirements relating to electromagnetic

compatibility, EN 55022 class A for ITE, the essential protection requirement of

Council Directive 89/336/EEC on the approximation of the laws of the Member

States relating to electromagnetic compatibility.

Company has an on-going policy of upgrading its products and it may be possible

that information in this document is not up-to-date. Please check with your local

distributors for the latest information. No part of this document can be copied or

reproduced in any form without written consent from the company.

Trademarks:

All trade names and trademarks are the properties of their respective companies.

Table of Contents

UNPACKING INFORMATION....................... 5

INTRODUCTION ............................................... 5

GENERAL DESCRIPTION ...................................................5

KEY FEATURES..............................................................5

THE FRONT PANEL .........................................................6

LEDs Definition.......................................................6

THE REAR PANEL...........................................................7

INSTALLATION................................................. 8

DESKTOP INSTALLATION ..................................................8

RACK-MOUNT INSTALLATION .............................................8

INSTALLING NETWORK CABLES...........................................9

FUNCTIONAL DESCRIPTION..................... 10

FLOW CONTROL AND BACK PRESSURE ................................10

MIRROR ...................................................................10

VLAN .....................................................................10

TRUNK (AGGREGATION) ................................................10

QUALITY OF SERVICE (QOS)...........................................10

MANAGEMENT GUIDE.................................. 11

ACCESS THE SWITCH....................................................11

HOMEPAGE................................................................12

ADMINISTRATOR .........................................................13

Authentication Configuration ..................................13

System IP configuration.........................................13

System................................................................14

Load Default Setting .............................................14

Firmware Upgrade ................................................14

PORT MANAGEMENT .....................................................15

Port Configuration.................................................15

Port Mirroring.......................................................16

Bandwidth Control ................................................16

Broadcast Storm Control........................................17

VLAN SETTING ..........................................................18

Group VLAN Setting ..............................................18

Multi to 1 Setting..................................................18

TRUNK SETTING..........................................................19

QOSSETTING............................................................20

Priority Mode .........................................................20

Class of Service Configuration....................................21

MAC ADDRESS CONFIGURATION ......................................21

CONFIGURATION BACKUP/RECOVERY..................................22

PRODUCT SPECIFICATIONS ..................... 23

Unpacking Information

Thank you for purchasing the D316S 16-Ports/D324S 24-Ports Fast

Ethernet Web Smart Switch. Before you start, please verify that your

package contains the following items:

1. One 16/24-Ports Fast Ethernet Web Smart Switch

2. One power cord

3. Rack-mount brackets and screws (optional)

4. Manual CD

D316S/ D324S Introduction

General Description

Easily managing your LAN, the 16/24-Ports Fast Ethernet Web Smart Switch

provides you 16/24*10/100Mbps ports that allow more efficient

management. With the user-friendly Web-based management interface,

you can easily get the overall information of your LAN.

This device provides sufficient management functions. VLAN reduces the

collisions from widely broadcasting. Port Aggregation enlarges the

bandwidth of backbone connection. QoS is supported to secure the

bandwidth for some bandwidth-demanded applications including VoIP or

videoconference. The 802.3x and backpressure flow control mechanisms

are also supported to ensure the correctness of data transmitting. Speed,

duplex mode auto-detection is also supported for your convenient

installation.

Key Features

16/24 fixed 10/100Mbps Fast Ethernet ports for easy network connecting

application.

Provide 4K MAC address entries and 16/24 groups VLAN table

Support Port Mirror.

Support up to 4 ports and 2 groups port aggregation.

Support QoS for better communication quality.

Support full duplex flow control and half duplex back pressure

Store-and-forward forwarding scheme

Error packet filtering

1.5M bits buffer Memory

Support Web-based management interface.

FCC Class A, CE, VCCI. Meet RoHS.

D316S / D324S Front Panel

The front panel consists of LED indicators. Please refer to the following

paragraph for information.

LEDs Definition

LED for the device:

The switch provides a power LED for the device.

LED Status Operation

Power Steady Green The switch is powered on

Off The switch is powered off

LED for each port:

LED Status Operation

LINK/ACT

Green The port is connected.

Blinking Green A valid link is established, and there is data

transmitting/receiving.

Off No valid link on this port.

Port Operation

The auto-negotiation feature allows those ports running at one of the

following operation modes:

Media Speed Duplex Mode

10/100Mbps(copper) 10Mbps Full Duplex

Half Duplex

100Mbps

Full Duplex

Half Duplex

Restore Default Button

You can use this button to reset the switch or restore factory default settings.

To reset the switch, press the button once.

To restore factory default settings, press and hold the button for three

seconds.

The Rear Panel

Power Receptacle

To be compatible with the electric service standards around the world, the

switch is designed to afford the power supply in the range from 100 to

240VAC, 50/60Hz. Please make sure that your outlet standard to be within

this range.

To power on the switch, please plug the female end of the power cord firmly

into the receptacle of the switch and the other end into an electric service

outlet. After the power cord installation, please check if the power LED is lit

for a normal power status.

Installation

This switch can be placed on your desktop directly, or mounted in a rack.

Please refer to the instructions for installation.

Before installing the switch, we recommend:

1. The switch is placed with appropriate ventilation environment. A

minimum 25mm space around the unit is recommended.

2. The switch and the relevant components are away from sources of

electrical noise such as radios, transmitters and broadband amplifiers

3. The switch is away from environments beyond recommend moisture

Desktop Installation

1. Install the switch on a level surface that can support the weight of the

unit and the relevant components.

2. Plug the switch with the female end of the provided power cord and plug

the male end to the power outlet.

Rack-mount Installation

The switch may be standalone, or mounted in a rack. Rack mounting

facilitate to an orderly installation when you are going to install series of

networking devices.

Procedures to Rack-mount the Switch:

1. Disconnect all the cables from the switch before continuing.

2. Place the unit the right way up on a hard, flat surface with the front

facing you.

3. Locate a mounting bracket over the mounting holes on one side of the

unit.

4. Insert the screws and fully tighten with a suitable screwdriver.

5. Repeat the two previous steps for the other side of the unit.

6. Insert the unit into the rack and secure with suitable screws.

7. Reconnect all the cables.

Installing Network Cables

1. Crossover or straight-through cable: All the ports on the switch

support Auto-MDI/MDI-X functionality. Both straight-through or

crossover cables can be used as the media to connect the switch with

PCs as well as other devices like switches, hubs or router.

2. Category 3,4,or 5 cable: To make a valid connection and obtain the

optimal performance. An appropriate cable that corresponds to different

transmitting/receiving speed is required. To choose a suitable cable,

please refer to the following table.

Media Speed Wiring

10/100Mbps copper

10Mbps Category 3,4,5 Utp/STP

100Mbps Category 5 UTP/STP

Functional Description

Flow Control and Back Pressure

Flow control and Back Pressure both contributes for lower and higher speed

devices to communicate to each other hence ensures the correctness of

data transmitting. The 802.3x flow control and Back Pressure mechanisms

work respectively for full and half duplex modes. Flow control can be

enabled or disabled on a per-port basis.

Mirror

The Mirror function provides network administrator to monitor the traffic. By

forwarding a copy of the packets that transferred by the monitored port, the

sniffer port received all the packets and hence is able to monitor the traffic

of the specified port.

VLAN

With VLAN supported, the network can be segmented in groups to reduce

the collisions from widely broadcasting. The device supports port-based

VLAN.Port-based VLAN classifies incoming packets to VLANs according to

their ingress port.

Trunk (Aggregation)

The Trunk functionality integrates several ports to enlarge the bandwidth

that helps to boost the backbone connectivity. The switch allows the

Maximum 2 group and 4 members for each group.

Quality of Service (QoS)

The QoS service classifies packets into different precedence. The packets

are transmitted and received by their classified priorities. This mechanism

helps high bandwidth demanded applications such as VoIP to get an

unobstructed connection.

Andere Handbücher für D316S

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Datasheen Schalten Handbücher

Datasheen

Datasheen KvmSwitch! CS08C Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung