9
Manual DV‑101D
9. NowpresstheOKbutton
10. Usingthetwobuttonsontheleft,select
channel
11. NowpresstheOKbutton.
* The display will now show DAY SELECTION.
12. The button on the left can be used to select
(flashing) the different days (above in
display).
The button alongside can be used to confirm
your selection (flashing stops).
NowpresstheOKbutton(thiswillnowbe
flashing).
13. Setting the start time for powering on (e.g.
start at 8.00 a.m.)
You can set the times (power-on command)
by using the two buttons on the left.
NowpresstheOKbutton.
14. Duration (eg 5 sec signal):
You can set the hours/min/sec e.g. for a
school bell by using the two buttons on the
left (power-on command).
NowpresstheOKbutton.
1.6.2 PROGRAMMING THE CHANGEOVER
TIME IN MINUTES
The DV-101D now functions as a normal
standard digital time clock.
* Pressing (briefly) the ESC button will
take you back 1 step in the programming
process.
1. Press the menu button 1x
2. Usingthetwobuttonsontheleft,select
PROGRAM
3. NowpresstheOKbutton
4. Usingthetwobuttonsontheleft,select
NEW
5. NowpresstheOKbutton
6. Usingthetwobuttonsontheleft,select
VACATION / WEEKLY
7. NowpresstheOKbutton
8. Usingthetwobuttonsontheleft,select
ON / OFF
9. NowpresstheOKbutton
10 Usingthetwobuttonsontheleft,select
channel
11 NowpresstheOKbutton.
* The display will now show DAY SELECTION.
12. The button on the left can be used to select
(flashing) the different days (above in
display).
The button alongside can be used to confirm
your selection (flashing stops).
13. NowpresstheOKbutton(nowashing).
14. The two buttons on the left can be used to
set (channel on) the times (minutes).
15. NowpresstheOKbutton.
16. Repeat the actions in steps 14-15 until
STORED is shown in the display.
You have now finished programming the
DV-101D.
1.6.3 SETTING THE SWITCH CYCLE
Consult the factory manual.
1.7 REMOVING THE SWITCH COMMANDS
Consult the factory manual.
1.8 THE FUSE OF THE DV101D
The DV-101D has a 6 Amp thermal fuse.
This fuse disables the DV-101D on its own
during an overload and / or short-circuits.
When the thermal fuse has turned off the
DV-101D (during an overload and / or short) the
DV-101D can be reset.
NLHUUKESDEFR
DV-101D Binnenwerk PMS.indd 7 28-3-2012 2:18:46
