DaVinci LED Power Supply
sku# 250-05849
Page 1 of 3 17602224 - 9/13/2021 © Travis Industries, Inc.
Packing List
Power Supply
Wire Tie
Spade Connectors
(1) male (1) female
Overview
This kit provides the parts and information needed for updating or replacing the LED power supply in a DaVinci
fireplace. This power supply will be a smaller and quieter replacement for the older power supplies or a direct
replacement for newer units.
Disconnect gas and power to the fireplace before proceeding.
Make sure the fireplace has fully cooled prior to conducting service.
Installation - (Early Fireplaces)
NOTE
If a replacement power supply was previously installed into the fireplace, the
wires marked XFMR (see picture below) may be RED and GREEN rather than the
WHITE and BLACK. If the wires are RED and GREEN, follow the directions on page 3.
1. Gain access to the component area of the fireplace (see installation manual for details).
2. Locate the LED power supply. Disconnect the Molex connector from the “power in” on the fireplace.
Disconnect the wires marked “LED XFMR” from the terminals on the power supply. You may discard the
power supply and harness.
First Generation Power Supply
LED XFMR
