Dees Communications Corporation Rev: 071114
Confidential Page 5 7/11/2014
Programming for all Users can be performed at once. Since programming is stored in non-volatile
memor the onl wa it can be changed is to program over it. It is not necessar to reprogram all Users,
onl those ou wish to change. At an point before the final digit is entered, the programming string can
be abandoned b entering #.
If an invalid programming sequence of characters is entered, DeesLink will generate an Alarm Tone (hi-
lo, hi-lo), and allow the s stem administrator to begin over b entering #.
Local rogramming
On the DeesLink unit there is a RJ-11 jack labeled PGM PORT for the purpose of connecting a standard
2500 t pe telephone to program the unit locall . Dial tone will not be present on the PGM jack.
Note that there is a 6 second inter-digit timeout period. If exceeded it will clear the entr and generate an
Alarm Tone (hi-lo, hi-lo). The procedure for local programming is as follows:
1. Come off-hook on the programming phone and dial xxxx*, ou will receive 2 beeps;
2. Enter #, this puts ou into the Idle Mode and ou will receive 1 beep;
3. Enter *, then User number (1-8)
4. Enter * [just a separator]
5. Enter password ou want to assign the User (ex. 1234)
6. Enter *
7. Enter (10-99) as the low CM Line assignment for User
8. Enter *
9. Enter (10-99) as the high CM Line assignment for User
10. Enter *
11. Enter (00-99) as the timeout period assigned for User.
12. Enter **, ends this specific User programming sequence and ou will receive 1 beep tone.
Wait for beep tone before proceeding.
13. This process can be continued (steps 3 – 12) to set up all of the Users. Do not dial # between
programming for different Users.
14. After last User is programmed wait for 1 beep tone confirmation, then dial #. You will
receive 1 low beep, then the DeesLink will hang up.
EXAMPLE: User 2, CM Port A, Password 1234, Lowest CM Line access 10, Highest CM Line access
19, 15 minutes time out. After entering programming mode (xxxx*#), the programming string would be
(*2*1234*10*19*15**).
1. Off-hook on programming phone
2. Enter xxxx* 2 beep confirmation tone
3. Enter # 1 beep confirmation tone
4. Enter *2 User number 2 gives them access to CM Port A
5. Enter*1234 Assign password for User 2
6. Enter *10 defines lower Line limit
7. Enter *19 defines upper Line limit
8. Enter *15 will hang up after 15 minutes of inactivit
9. Enter ** 1 beep tone confirmation
