Dell Latitude E4200 Bedienungsanleitung

Replacing the System Board

About Warnings

WARNING: A WARNING indicates a potential for property damage, personal injury,

or death.

Setting the AMT Manageability Mode

NOTE: For Dell™ Latitude™ E5400 and E5500 computers, and for Dell Precision™

M6400 Mobile Workstations, skip this section and see "Programming the Service Tag"

on page 3.

WARNING: Before you begin any of the procedures in this section, read the safety

information that shipped with your computer. For additional safety best practices,

see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: If you need to remove the bottom access panel, first disconnect the

AC adapter and modem cables from all electrical outlets.

CAUTION: Follow the instructions carefully to ensure that you configure the

computer for the correct management mode.

Remove the bottom access panel (see your

Service Manual

Take note of the label that is attached to the inside of the bottom access panel.

label

March 2009

R939Ham1-edited.fm Page 1 Tuesday, November 3, 2009 4:59 PM

You should see one of the following four configuration-mode labels on the inside

of the chassis:

NOTE: If the original configuration-mode label is missing, damaged, or otherwise

illegible, contact Dell to obtain your configuration-mode number (see your computer

documentation for contact information).

Replace the bottom access panel.

NOTE: For information on replacing the system board, see "Replacing the System

Board" in your Service Manual.

Disconnect the network cable, if applicable, and the mass storage devices like

hard drives or USB flash keys.

Connect the AC adapter and turn on the computer.

An initialization screen is displayed. The green text on the initialization screen

prompts you to select the appropriate configuration for your computer.

CAUTION: Ensure that you use the correct configuration-mode number. Once you

have selected a configuration, you cannot change the management mode as this

process is not reversible. If you make the wrong selection, your computer may not

operate as it should.

Enter the configuration-mode number that you obtained from the label inside

the bottom access panel.

If this is the correct configuration-mode number, select

at the prompt.

Once the initialization is complete, the computer shuts down.

Reconnect the network cable and the mass storage devices like hard drives or

USB flash keys.

Restart the computer.

R939Ham1-edited.fm Page 2 Tuesday, November 3, 2009 4:59 PM

Programming the Service Tag

After replacing the system board for Latitude E5400, E5500, and Dell Precision

M6400 Mobile Workstations, you need to program the service tag if the following

message is displayed on startup:

WARNING: The Service Tag has not been programmed.

This system will not function properly without a

Service Tag.

The setup utility will launch the Service Tag

installer.

NOTE: Latitude and Dell Precision E-Series Workstation computers configured

with iAMT®receive this message only after the iAMT initialization procedures

are completed.

NOTE: The battery light on the computer flashes blue and amber during this error.

To program the Service Tag:

Press <F2> to enter the system setup program.

Enter the correct Service Tag.

Perform one of the following steps:

•

If the AC Adapter is already connected

, exit the system setup program and

reboot the computer.

•

If the AC Adapter is not connected

, turn the computer off, connect the

AC adapter, and then turn the computer back on.

R939Ham1-edited.fm Page 3 Tuesday, November 3, 2009 4:59 PM

FIPS 201 Compliance

NOTE: Federal Information Processing Standards (FIPS) 201 compliance affects

Latitude E4300, E6400, E6500, M2400, M4400 and M6400.

CAUTION: Perform the steps in "FIPS 201 Compliance" on page 4 only if you have an

FED account in the Americas region and require a FIPS compliant system. These steps

disable the contactless smart card reader.

Download the latest utilities from the Dell Support website at

support.dell.com

• For 32-bit Microsoft

Windows Vista

or Windows XP

operating

systems, download the

CVFIPS201_Enable.exe

utility.

• For 64-bit Windows Vista or Windows XP operating systems,

download the

CVFIPS201_Enable64.exe

utility.

Run the utility and select

FIPS Compliant

The system is now FIPS 201 compliant.

____________________

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is

strictly forbidden.

Trademarksusedinthistext:Dell,Latitude,DellPrecision,andthe DELL logoaretrademarksofDell Inc.;

iAMT is a registered trademark of Intel Corporation in the U.S. and other countries; Microsoft, Windows

Vista, and Windows XP are either trademarks or registered trademarks of Microsoft Corporation in the

United States and/or other countries

Other trademarks and trade names may be used in this document to refer to either the entities claiming the

marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade

names other than its own.

R939Ham1-edited.fm Page 4 Tuesday, November 3, 2009 4:59 PM

Andere Handbücher für Latitude E4200

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dell Computerhardware Handbücher

Dell

Dell PowerEdge Express Flash PCIe SSD Bedienungsanleitung

Dell

Dell OptiPlex XE4 Small Form Factor Bedienungsanleitung

Dell

Dell PowerEdge S130 Bedienungsanleitung

Dell

Dell 2000FP Bedienungsanleitung

Dell

Dell Precision R5500 Bedienungsanleitung

Dell

Dell 8 Bedienungsanleitung

Dell

Dell Dimension 4600 Series Bedienungsanleitung

Dell

Dell PowerConnect W-7200 Series Bedienungsanleitung

Dell

Dell Embedded Box PC 5000 Bedienungsanleitung

Dell

Dell Embedded Box PC5000 Bedienungsanleitung

Dell

Dell qlogic qla2100 Bedienungsanleitung

Dell

Dell PowerEdge C6220 II Kurzanleitung

Dell

Dell Latitude ON Bedienungsanleitung

Dell

Dell PowerEdge 2600 Bedienungsanleitung

Dell

Dell POWEREDGE RAID H700 Kurzanleitung

Dell

Dell Alienware Graphics Amplifier Bedienungsanleitung

Dell

Dell Dimension XPS T Series Bedienungsanleitung

Dell

Dell ADVANCED PORT REPLICATOR Bedienungsanleitung

Dell

Dell P570 Bedienungsanleitung

Dell

Dell PowerEdge 1650 Bedienungsanleitung

Dell

Dell Latitude L400 Bedienungsanleitung

Dell

Dell Mellanox ConnectX-3 Bedienungsanleitung

Dell

Dell PowerEdge 1650 Bedienungsanleitung

Dell

Dell Streak 5 Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung