This section describes the correct way to assemble MonkeyMESH. By following these instructions
you will achieve the highest Return On Investment from your wire backing system and contribute to a
safe workplace.
Before assembly or use of MonkeyMESH, the specifier must ensure that the product supplied
is correct and appropriate to your workplace. You should also check deltashelving.comto ensure
that you have the current version of this MonkeyMESH Manual.
For thepurposes of the product warranty and to ensure both the safety and integrity of your
workplace, MonkeyMESH must be installed, used and maintained as detailed in this manual.
If the product youare attempting to install does not match the description or requirements of this
manual or the site specifics are not compatible with the product, do no install the MonkeyMESH wire
backing system.ContactDelta immediately to assist in resolving the issue.
Assembling MonkeyMESH
MonkeyMESH Manual P6
Thefollowing toolsare required for installation:
Ratchet and socketextension tosuit M8 screws and nuts
An M8 spanner
Additionally, we recommend the use of the following Personal Protective Equipment (PPE):
Planning Your Installation
Safety GlassesSteel-Capped Boots High-vis Work Wear
Throughout the development of MonkeyMESH we have investigated and tested the safest and most
efficient method ofinstallation.
Installation should start atone end of theracking assembly, commencing at the top-most position
for a MonkeyMESH Panel. The next section to be installed should be the section immediately
underneath,and so on until you reach thebottom of that rack.
The installer should then move to the sectionof theracking assembly immediately next to the section
that now has MonkeyMESH installed,and again start from the top and work down.The following
diagram illustrates our recommendation for the order in which MonkeyMESH Panels should be
installed:
1
2
3
4
5
6
7
8
9
10
11
12
Please note
Before beginning
installation, make sure
to carefullymeasure
where the MonkeyMESH
will go on the racking
assembly. If you install
the top Bracket too low,
the bottom Bracket may
not have enough space
to be installed.
!
PreparationIntroduction Assembly and Installation Inspection
RACKMAN AUSTRALIA
AUTHORISED DISTRIBUTOR
info@rackmanaustralia.com.au
1300 722 626
www.rackmanaustralia.com.au
