3
Using the Handlebar Clamp with 360° Rotation
How to use the 360° Rotation feature
IMPORTANT
SAFETY NOTE
Do not attach clamp
to any tapered section
of your handlebar.
1Connect 360° Mount (Part D) to rear of phone holder
using Short Bolt (Part G)
1To adjust the angle of the phone holder loosen
thumb screw. Pull the phone holder up slightly
so grooves are separated Rotate phone holder
into desired position. Once in place, tighten the
thumb screw.
2
Use thumb screw; tighten to secure the
handlebar clamp and mount.
If necessary use the adhesive foam inserts to
provide a snug fit for your device. (FIGURE 2)
Service: Please do not return to store;
for immediate response email
service@designbydelta.com
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
Use rubber shims as needed (Part E) (FIGURE 1)
Place Handlebar Mount (Part C) in position
over the 360° Mount (Part D), be sure groves
are in lined up and in place. (FIGURE 2)
Open slightly in order to allow
easy access to insert the bolt.
Insert the bolt on the same side
as the locking mechanism
360°
FIGURE 1
FIGURE 2
FIGURE 2
011722
