Denver BTT-515 Bedienungsanleitung
Getting Started
Remove the speaker from the box.
Remove any packaging from the speaker.
Place the packaging inside the box and either store or dispose of safely.
In the Box
Bluetooth® LED Speaker
Line-in Aux. Cable
USB Charging Cable
Instruction Manual
Features
Bluetooth Version: 5.0
Built-in Rechargeable Battery
Wireless Range: Up to 25 m
Micro USB Charging Cable (Included)
Speaker Output: 2 x 5 W
Line-in Aux. Cable (Included)
Frequency Range: 100 Hz-18 kHz
Instructions for Charging the Battery
The speaker is fitted with a 3.7 V 1200 mAh rechargeable battery (non-removable). It is
recommended that the battery is fully charged before first use; this will take approx. 4
hours.
Connect the micro USB end of the USB charging cable into the 5V charging port on
the back of the speaker and the other end to a compatible USB port.
Whilst charging, the charging indicator light will become red. Once the battery has been
fully charged, the charging indicator light turns off.
Carefully disconnect both ends of the USB charging cable and store it safely for future use.
Using the Bluetooth® LED Speaker Basic Functions
Turn on the speaker by turning the on/off switch to the on position.
Pause a track by pressing ' '; push it again to resume the track.
Adjust the volume of the speaker by pressing'+' and '-'. Press and hold'+' to increase the
volume; decrease the volume by pressing and holding '-'.To switch to the next track,
press'+'; play the previous track by pressing '-'.Cycle between modes by pressing 'M' until
the desired operation is selected. Turn the on/off switch to the off position to turn the
speaker off.
Modes
The speaker must be turned on before using any of the following modes.
Using the Colour Changing LED Lights
The LED lights will automatically activate when the speaker is turned on and can be
controlled by using 'M'. Press 'M' twice rapidly to cycle between different light modes.
MODE 1: Colour Changing Mode
MODE 2: Off
Bluetooth Mode
Pairing with a Bluetooth Compatible Device
STEP 1: Once the speaker has been turned on, a voice prompt will signal it is ready to be
paired with a Bluetooth compatible device.
STEP 2: Search for the speaker with the Bluetooth compatible device. Select '000' to connect
and pair. Once a pairinghas been made; the LED lights will flash rapidly and a voice prompt
will signal that the devices are paired.
STEP 3: To unpair or remove a Bluetooth compatible device from the speaker, turn off the
Bluetooth function on the compatible device. The speaker can now be paired with a new
compatible device.
Note: Once devices are connected, sound can be controlled by either the speaker or the
relevant controls on the Bluetooth compatible device.
Making Phone Calls via a Bluetooth Compatible
Device
Once the Bluetooth compatible device has been paired with the speaker, phone calls can be
made.
STEP 1: Use the Bluetooth compatible device, dial the number to be called and select the
Bluetooth/hands-free option. The speaker and its built-in microphone will now act as a
hands-free device.
STEP 2: To connect or disconnect a call with the speaker, press ' '.
STEP 3: The volume of the phone call can be controlled by either the speaker or the
Bluetooth compatible device.
STEP 4: To reject an incoming phone call, press and hold ' ' for approx. 2-3 seconds.
Aux. Mode
Connect one end of the line-in Aux. cable to the Aux. input port on the speaker and the
other end to an MP3 player or other compatible audio source.
The speaker will automatically switch to Aux. mode once the line-in Aux. cable has been
inserted.
Note: Sound can now be controlled by the relevant controls on the compatible audio
source; the speaker cannot be used to skip tracks during Aux. mode.
If the speaker does not automatically switch to Aux. mode when the line-in Aux. cable is
inserted, press 'M' until it is selected.
Micro SD Card/USB Mode
STEP 1: To use micro SD card mode, insert a micro SD card (not included) into the micro SD
card slot. The speaker will automatically switch to micro SD card mode.
STEP 2: To use USB mode, insert a compatible USB drive into the USB port. The speaker will
automatically change to USB mode.
STEP 3: If the speaker does not automatically change to micro SD card or USB mode, press
'M' until the desired operation is selected.
Note: Once connected, sound can be controlled by the speaker.
No USB drive should be inserted whilst using micro SD card mode or vice versa, as this could
interfere with playback.
The speaker will only recognise MP3 audio files; if other file formats are present on the
Micro SD card or USB drive, this may prevent the speaker from playing.
Troubleshooting
The speaker has no power.
The speaker has run out of charge. Charge the speaker following the instructions in the
section entitled 'Charging the Battery'.
The speaker has no sound.
The volume level is set too low. Check that the volume level is set at an audible level and
adjust accordingly.
The speaker is not paired with a Bluetooth compatible device. Follow the instructions in the
section entitled 'Bluetooth Mode'.
Please notice - All products are subject to change without any notice. We take reservations
for errors and omissions in the manual.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S
Electric and electronic equipment and included batteries contains materials, components
and substances that can be hazardous to your health and the environment, if the waste
material (discarded electric and electronic equipment and batteries) is not handled
correctly.
Electric and electronic equipment and batteries is marked with the crossed out trash can
symbol, seen above. This symbol signifies that electric and electronic equipment and
batteries should not be disposed of with other household waste, but should be disposed of
separately.
As the end user it is important that you submit your used batteries to the appropriate and
designated facility. In this manner you make sure that the batteries are recycled in
accordance with legislature and will not harm the environment.
All cities have established collection points, where electric and electronic equipment and
batteries can either be submitted free of charge at recycling stations and other collection
sites, or be collected from the households. Additional information is available at the
technical department of your city.
Hereby, Inter Sales A/S declares that the radio equipment type SP-007 is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: www.denver-electronics.com and then click the search ICON on
topline of website. Write model number: SP-007. Now enter product page, and red directive
is found under downloads/other downloads.
Operating Frequency Range:
Max Output Power:
DENVER ELECTRONICS A/S
Inhaltsverzeichnis
Andere Denver Sprecher Handbücher
Denver
Denver BTS-110NR Bedienungsanleitung
Denver
Denver BTV-220 Bedienungsanleitung
Denver
Denver BTL-324 Bedienungsanleitung
Denver
Denver BTL-31 Bedienungsanleitung
Denver
Denver BTS-63 Bedienungsanleitung
Denver
Denver BTS-90 Bedienungsanleitung
Denver
Denver BTM-610 Bedienungsanleitung
Denver
Denver TSP-353 Bedienungsanleitung
Denver
Denver BTS-110 Bedienungsanleitung
Denver
Denver SP-1000 Bedienungsanleitung
Denver
Denver BPS-455 Bedienungsanleitung
Denver
Denver BPS-351NR Bedienungsanleitung
Denver
Denver TSP-305 Bedienungsanleitung
Denver
Denver BTB-410 Bedienungsanleitung
Denver
Denver BTG-615 Bedienungsanleitung
Denver
Denver BTS-21 Bedienungsanleitung
Denver
Denver TSP-505MK2 Bedienungsanleitung
Denver
Denver TSP-450NR Bedienungsanleitung
Denver
Denver BTL-62 Bedienungsanleitung
Denver
Denver TSP-110 Bedienungsanleitung
Beliebte Sprecher Handbücher anderer Marken
Bowers & Wilkins
Bowers & Wilkins 4 Bedienungsanleitung
Sonance
Sonance SONOS OUTDOOR Series Bedienungsanleitung
Electro-Voice
Electro-Voice EVID FM4.2 Bedienungsanleitung
Pioneer
Pioneer XW-HTD630 Bedienungsanleitung
Onn
Onn BWA16AA002 Bedienungsanleitung
HP
HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung