TB-3008 Page 2 of 2
Heat Sealed Patches
It is possible to heat seal patches to our smocks. The patch
should be small and the smock should be tested before and
after application.
Grounding Integrity Testing
For daily testing or monitoring of the grounding integrity
of Desco ESD protective smocks and ground cords, we
recommend the use of standard wrist strap testers or
single-wire workstation continuous monitors.
Panel to panel conductivity is essential so as not to leave
portions of the smock as isolated charged conductors.
Panel to panel conductivity is easy to test using our
Surface Resistance/ Resistivity Tesk Kit Item #19770, by
placing 5 pound electrodes on different panels. Unless
properly grounded, the smocks can hold a charge and
become a possible source for discharge to ESD susceptible
products. For additional information, refer to ANSI/ESD
S20.20 and the ESD Association Garment Standard,
ESD-STM2.1.
Desco has several testers available for this purpose. For
more information ask for specification drawings or operating
instruction manuals by item number.
Maintenance
For proper operation, the ESD protective smock must be
laundered periodically. Launder garment in cool or warm
water, tumble dry with low heat or hang dry. DO NOT
BLEACH. The carbon-suffused mono-filament nylon is
sensitive to heat and should not be exposed to laundering
heat in excess of 120°F. Use only non-ionic softeners and
detergents when laundering. Under normal wearing and
recommended washing conditions, Desco ESD protective
smocks will maintain their usefulness and effectiveness
for a minimum of 100 washings. Some other ESD smocks
have as little as 1% suffused carbon and lose their ESD
protective qualities after a few washings.
Specifications
Fabric Weight 2.3 oz per square yard
Fabric Content Texturized polyester and
minimum 9% carbon mono-
filament nylon.
Carbon Mono-filament Conductive at 104ohms, non-
flaking and non-sloughing.
Surface Resistivity 105- 106ohms, per ESD-STM2.1
of Fabric
Static Decay Rate 5000 volts to 500 volts in less than
0.1 seconds, per FTMS-101C
Glass Transition Temp 250°F
Flash Point 1040°F
Note: Material sample swatches are available upon
request. Fabric lots vary slightly in color and weight. If
you have any question please don’t hesitate to request
a sample material from our Customer Service Team.
19350
19250
DESCO WEST - 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178 • Fax (909) 627-7449
DESCO EAST - One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Fax (781) 575-0172 • Web Site: Desco.com
Limited Warranty
Desco expressly warrants that for a period of one (1) year from the date
of purchase or (100) one-hundred wash cycles, whichever occurs first,
Desco garments will be free of defects in material (parts) and workmanship
(labor). Within the warranty period, a garment will be replaced at Desco’s
option, free of charge. Call Customer Service at 909-627-8178 (Chino,
CA) or (781) 821-8370 (Canton, MA) for Return Material Authorization
(RMA) and proper shipping instructions and address. Include a copy of
your original packing slip, invoice, or other proof of date of purchase. Any
garment under warranty should be shipped prepaid to the Desco factory.
Warranty replacements will take approximately two weeks.
Warranty Exclusions
THE FOREGOING EXPRESS WARRANTY IS MADE IN LIEU OF
ALL OTHER PRODUCT WARRANTIES, EXPRESSED AND IMPLIED,
INCLUDING MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE WHICH ARE SPECIFICALLY DISCLAIMED. The express
warranty will not apply to defects or damage due to accidents, neglect,
misuse, alterations, operator error, or failure to properly maintain, clean or
repair products.
Limit of Liability
In no event will Desco or any seller be responsible or liable for any injury,
loss or damage, direct or consequential, arising out of the use of or
the inability to use the product. Before using, users shall determine the
suitability of the product for their intended use, and users assume all risk
and liability whatsoever in connection therewith.
© 2010 DESCO INDUSTRIES INC.
Employee Owned
Figure 3. Grounding the smock
Figure 4. Testers
19780
