Detector Power TREASURE GOLD PLUS 2021 Bedienungsanleitung

TREASURE GOLD PLUS 2021

BIRTBE DETECTORS

OPERATING MANUAL

BURIED TREASURE DETECTOR

TREASURE GOLD PLUS

BATTERY

• The control box is powered by a 9-volt battery located at the bottom of the control

box.

• Lift the cover, pull out the battery connector cable, insert the battery, and close the

lid.

• The equipment can work as long as the LED indicator is on.

• It is recommended to use rechargeable batteries.

ANTENA LOCATOR

• The antenna locator works with a 9-volt battery.

• It is recommended to use a rechargeable battery.

SYSTEMS

GOLD DISCRIMINATION

Gold System

To select the next Gold mode, turn on the device at the LOCATOR ANTENNA position, then set

the selector lever to the ON GOLD position.

In this mode, you will be able to detect only gold by employing the antenna.

DISCRIMINATION System

To select the DISCRIMINATION system, turn on the instrument where LOCATOR ANTENNA is

displayed, then set the selector lever to the ON DISCRIMINATION position.

With the DISCRIMINATION function, you can select the type of metal you want to detect, such

as:

IRON

COPPER

BRONZE

GOLD JEWEL COIN

SILVER

GOLD FINE /MINERAL GOLD, GOLD NUGGETS, GOLD BULLION

IONIC SENSOR

The ionic system can detect the ions produced by noble metals such as gold and silver.

To perform the prospecting with this system, first, turn on the equipment with the LOCATOR

ANTENNA lever, then increase the sensitivity regulator to a sensitive point. This detection

system is efficient in dry soils (not humid) where the metals react with the sun's temperature

and release the ions detected by the equipment.

The radar system detects by ionization only metals that have been buried for many years and

that are in dry soil or earth.

For example, if a treasure is buried in damp soil or where there is water, the equipment will be

able to detect it with the help of the antenna tracker, but the radar system will not notice it

due to the lack of ionization.

It is always advisable to perform the exploration with the tracking antenna, as it can detect any

soil and weather.

Warning. Do not use the RADAR SYSTEM inside houses or near electronic equipment, which

could damage the equipment.

Recommendation: Use the radar system with no houses or power lines or electronic

equipment such as radios or cell phones.

The detection through the ANTENNA LOCATOR can be used in any location with absolutely no

inconvenience.

LOCATOR ANTENNA

Turn on the LOCATOR ANTENNA with the switch; the antenna has two power speeds that you

can set by pressing the red button. It is recommended to use the low power to save battery;

the high power is used to track longer distances; this power is recommended to use for a short

time and switch back to the low power.

When the antenna is turned on, it will start working, tracking the signals of the selected metal

type from the control box.

To conduct the exploration with the antenna, keep the IONIC SENSOR turned on and the IONIC

SENSOR regulator (0).

IONIC SENSOR OR RADAR SYSTEM

For detection with the ionic/radar system, the control box must not be connected to the

antenna cable.

The radar system can detect noble metals that have been buried for many years. It is not

advisable to search near high voltage cables or electrical or electronic equipment.

Performance Demonstration

Metals that you will need to perform the test practices:

1- Un objeto de hierro, cobre, plata, oro.

An object of iron, copper, silver, or gold.

Bury each of these metals in different places at a maximum depth; keep in mind that

this equipment can detect up to 60 meters deep.

After burying the metals, let a couple of months elapse and then perform the detection with

the equipment.

HANDLING THE ANTENNA

The operator must be relaxed before exploring to obtain favorable results since maximum

concentration is required.

To perform a good prospection, the operator must always be in position and direction to the

cardinal points from North to South or East to West.

The locator detects magnetic ions produced by buried metals by frequencies; the equipment

detects up to a maximum distance of 2000 meters and 60 meters deep if the buried metal is of

large volume.

The detection of small objects such as a buried gold coin that is very old can detect up to a

maximum distance of 500 meters.

SEARCH SYSTEM

DETECTION BY CROSSING (X)

It is crucial to carry out the exploration using cardinal points.

Trace the direction from north to south or east to west to obtain an approximation of the

center; this will ease the location of the detected point; after locating the detected point,

perform the depth measurement.

SEARCH SYSTEM

The antenna is always directed to the metal selected by the equipment.

The buried treasure or object produces a magnetic field; the magnetic field emits a signal

picked up by the locating equipment with the help of the tracking antenna.

TEST TO CHECK THE DEPTH

The buried metal object produces magnetic radiation.

The depth of the buried object is the same distance that produces magnetic radiation.

To know the depth of the metal, the following process must be performed:

Once you have located the center of the target, you should stand on top of the center, and

point your antenna towards the ground, then raise the antenna until it reaches the level, and

walk straight from the detected center towards the north, keep the antenna level and at the

moment the antenna turns back as to go back to the center, you should point from that place

to the center and measure that distance, in this way you will have the depth that it is detected.

Carry out tests from the four cardinal points; the measurement test from the center to each

cardinal point must coincide.

HALO EFFECT

The detector equipment is prepared to calibrate the frequencies of each type of metal to be

detected. The equipment receives the signal of the detected metal selected, and the antenna

signals the direction where the buried metal is located; what the operator does is walk in the

direction that the antenna indicates.

This buried metal produces a magnetic field called the halo effect, and this magnetic field

produces negative ions; the equipment detects the ionic field produced by the buried metal.

When the antenna passes over the point, it generates a polarity shock which makes the

antenna rotate repeatedly.

Inhaltsverzeichnis

Beliebte Sicherheitssensor Handbücher anderer Marken

THORLABS

THORLABS PDA10JT Bedienungsanleitung

Waeco

Waeco UV-DETECT Bedienungsanleitung

Intermatic

Intermatic IOS-DSIMF Bedienungsanleitung

urmet domus

urmet domus 1083 Bedienungsanleitung

Siemens

Siemens AZL66 Series Bedienungsanleitung

BTI

BTI Profiline Multi Finder Bedienungsanleitung

Challenger

Challenger SL01 Bedienungsanleitung

DMP Electronics

DMP Electronics 1122INT Bedienungsanleitung

Rielta

Rielta Ladoga MK-RK Bedienungsanleitung

Mirion Technologies

Mirion Technologies ACCURAD PRD Bedienungsanleitung

Bosch

Bosch DS835 Bedienungsanleitung

DBI SALA

DBI SALA EZ Stop Bedienerhandbuch

Lamptime

Lamptime ST05C Bedienungsanleitung

Ubiquiti

Ubiquiti MFI-MSC Bedienungsanleitung

Subsite

Subsite 910R Montageanleitung

Satel

Satel OPAL Pro Bedienungsanleitung

Aleph

Aleph XC-1XTEU Bedienungsanleitung

Pima

Pima LARIS QUAD Bedienungsanleitung