2
Important safety instructions
Your projector has been designed and tested, and meets the latest safety standards for
information technology equipment. However, in order to ensure the safe use of the product, it is
essential to follow the instructions mentioned in the manual and marked on the product.
Please read the manual before using the projector and keep it for future reference.
Please do not look at the projection lens during use, as strong light beam may hurt your eyes.
In some countries/regions, the power supply voltage is unstable. The projector can operate
normally within the voltage range of 100 to 240 (volt) of the AC power supply, but in the areas
that the voltage fluctuation exceeds 10 and the power supply voltage may fluctuate or be cut
off, it is recommended that you connect the projector through a power stabilizer, a surge
protector or an uninterruptible power supply (UPS).
When the projector is working, do not use any object to block the projection lens, otherwise the
object will be heated and deformed, or even fired.
Please do not place the projector on an unstable shelf or a table, otherwise the projector may
fall and maybe seriously damaged.
Do not disassemble the projector before the power to the projector is not cut off. Dangerous
high voltage components are arranged in the projector. Electric shock and death may occur in
case of contact with human body. Therefore, you can open or remove the cover of the projector
in any case. Only qualified professional maintenance personnel can maintain the projector.
Please do not place liquid near or on the projector. If liquid splashes into the projector, the
projector may not work properly. If the projector is wet, the power cord of the projector shall be
unplugged, and then you shall call the authorization service center of the projector for the
maintenance of the projector.
