Installation and Setup 1. Bolt the shea to a flat su face such
as a wo kbench o stand. If the su face
is not level, it may be necessa y to
place shims unde one of the mounting
flanges on the shea base. Be ce tain
that the mounting bench o stand is
secu ely bolted to the floo to p event
tipping.
2. Inse t the shea handle (A) into the
holde (B) and secu e with sc ew.
Handle holde may be moved to the
opposite end of machine fo left hand
ope ation.
3. Mount the shea table (C) onto the
base using the flat head sc ews (D)
p ovided.
4. Assemble the mic omete back
gauge and sc ew the th eaded gauge ods (E) into the holes in the ea of the machine
base as fa as possible.
5. Lock the th eaded gauge ods into place by tightening the lock nuts against the am.
6. Install the tie ba (F) between the th eaded gauge ods and secu e with the cap sc ews
p ovided.
Synchronizing Micrometer Gauges
1. Set both mic omete dials on ze o, dep ess and slide enti e assembly fo wa d until the
mate ial stop ba (H) contacts lowe Shea blade (I).
2. Tu n both mic omete dials slightly to be su e they engage th eaded gauge ods.
3. Loosen lock nuts and tu n th eaded gauge ods counte -clockwise while tu ning mi-
c omete dial clockwise. When mate ial stop ba is in contact with lowe blade, and both
mic omete dials ead ze o, gauge is synch onized.
4. Tighten lock nuts on th eaded gauge ods.
INSTALLATION
2
